Forensic toxicological application of TOXI-LAB screening for biological specimens in autopsy cases and emergency cares

Using the TOXI-LAB drug detection system, emergency toxicological screening was performed in autopsy cases and emergency cares. In 280 autopsy cases (male 182 cases 65%, female 98 cases 35%), drug positive cases were 28 cases of male (15%) and 24 cases of female (24%). The age groups which showed higher rate of drug positive cases were 10s-40s in male (approximately 20%) and 20s in female (67%). In the 238 cases of emergency care (male 129 cases 54%, female 104 cases 44%, unknown 5 cases 2%), drugs were positive in 29 cases of male (22%) and 32 cases of female (30%). The age groups which showed relatively higher rate of drug positive cases were 40s in male (64%), 20s (71%) and 30s (89%) in female. Forty-four different kinds of drugs were detected in TOXI-LAB positive cases, in which the psychotropic drugs and the sedative-hypnotic drugs amounted to approximately 70%. Methamphetamine and amphetamine, which were the main abused drugs showing a socially important problem, were detected in total 15 cases. TOXI-LAB was based on thin-layer chromatography (TLC); however, from the extraction to development, coloration and detection have been accelerated (about 50 min) and simplified. In order to perform the forensic toxicological practice in Japan, it becomes more useful that TOXI-LAB is used in autopsy cases and emergency cares, if the drugs, which have caused poisoning cares in Japan, are added to TOXI-LAB. The present study describes the advantage and problem of TOXI-LAB drug detection system through demonstrating the practical cases of autopsy cases and emergency cares.     

Role of Acetic Acid Added to the Reaction Media for the Enantio-differentiating Hydrogenation of Methyl Acetoacetate Over a Tartaric Acid-modified Nickel Catalyst

The role of acetic acid added to the reaction media for the enantio-differentiating hydrogenation of methyl acetoacetate over a (R,R)-tartaric acid-in-situ-modified nickel catalyst was studied from the viewpoint of the hydrogenation rate during repeated runs. The hydrogenation of methyl acetoacetate on the “enantio-differentiating sites” of a tartaric acid-modified nickel catalyst was specifically accelerated by the acetic acid added to the reaction media to increase the enantio-differentiating ability of the catalyst. In order to increase the enantio-differentiating ability, the addition of acetic acid to the reaction media was required in each run during the repeated use of the catalyst.     

Fabrication of Transparent, Sintered Sc2O3 Ceramics

We report here the fabrication of transparent Sc₂O₃ ceramics via vacuum sintering. The starting Sc₂O₃ powders are pyrolyzed from a basic sulfate precursor (Sc(OH)_2.6(SO₄)_0.2·H₂O) precipitated from scandium sulfate solution with hexamethylenetetramine as the precipitant. Thermal decomposition behavior of the precursor is studied via differential thermal analysis/thermogravimetry, Fourier transform infrared spectroscopy, X-ray diffractometry, and elemental analysis. Sinterability of the Sc₂O₃ powders is studied via dilatometry. Microstructure evolution of the ceramic during sintering is investigated via field emission scanning electron microscopy. The best calcination temperature for the precursor is 1100°C, at which the resultant Sc₂O₃ powder is ultrafine (∼85 nm), well dispersed, and almost free from residual sulfur contamination. With this reactive powder, transparent Sc₂O₃ ceramics having an average grain size of ∼9 μm and showing a visible wavelength transmittance of ∼60–62% (∼76% of that of Sc₂O₃ single crystal) have been fabricated via vacuum sintering at a relatively low temperature of 1700°C for 4 h.     

Effects of dietary lipids on daunomycin-induced nephropathy in mice: comparison between cod liver oil and soybean oil

Although it is well known that dietary lipids affect the course of glomerulonephritis in rats and humans, the precise mechanisms involved have not been fully elucidated. The aim of this study was to investigate the effects of different types of dietary lipids (fish oil and vegetable oil) on daunomycin (DM)-induced nephropathy in mice fed on soybean oil (SO) or cod liver oil (CLO). Urinary protein excretion, serum albumin, creatinine, total cholesterol, and TG were measured, and glomerular histological changes were evaluated. Antioxidant enzymes were also measured, along with the levels of lipid peroxide, GSH, thromboxane (Tx) B_2′ and 6-keto prostaglandin F_1α in renal cortical tissue. Dietary CLO significantly reduced urinary albumin excretion and ameliorated the histological changes induced by DM. The increase of tissue lipid peroxide levels seen in SO-fed mice was suppressed in CLO-fed mice, whereas CLO-fed mice showed higher GSH levels than SO-fed mice throughout the experiment. In addition, renal tissue GSH peroxidase activity was significantly higher at 72 h after DM injection in CLO-DM mice than in SO-DM mice. Both renal cortical TxB₂ and 6-keto PGF_1α levels were significantly lower in CLO-DM mice than in SO-DM mice. These results suggest that inhibition of oxidative damage by dietary CLO played an important role in the prevention of DM nephropathy in this mouse model. The effect of CLO was closely associated with the inhibition of Tx synthesis.     

Some properties of mullite powders prepared by chemical vapour deposition

The sinterability of mullite (3Al₂O₃·2SiO₂) powder prepared by chemical vapour deposition was examined to improve the conditions for fabricating dense mullite ceramics. The starting powder contained not only mullite, but also a small amount of -Al₂O₃ (Al-Si spinel) and amorphous material. Although the compressed powder was fired at a temperature between 1550 and 1700 °C for 1, 3 and 5 h, the relative densities of the sintered compacts were limited to 90%: (i) due to the creation of pores/microcracks during the solid state reaction (1100–1350 °C), and (ii) due to restriction on the rearrangement of grains because the amount of liquid phase (1550–1700 °C) was insufficient. Calcination of the starting powder was effective for preparation of easily sinterable powder with homogeneous composition. When the compact formed by compressing the calcined powder at 1400 °C for 1 h was fired at 1650 °C for 3 h, the relative density was raised up to 97.2%; moreover, mullite was the only phase detected from the sintered compact. The sintered compact was composed of polyhedral grains with sizes of 1–2 m and elongated grains with long axes of 6 m.     

A study of Q-learning considering negative rewards

In the reinforcement learning system, the agent obtains a positive reward, such as 1, when it achieves its goal. Positive rewards are propagated around the goal area, and the agent gradually succeeds in reaching its goal. If you want to avoid certain situations, such as dangerous places or poison, you might want to give a negative reward to the agent. However, in conventional Q-learning, negative rewards are not propagated in more than one state. In this article, we propose a new way to propagate negative rewards. This is a very simple and efficient technique for Q-learning. Finally, we show the results of computer simulations and the effectiveness of the proposed method.     

Editorial

Higher-Order and Symbolic Computation -     

Fabrication of Translucent Magnesium Aluminum Spinel Ceramics

A precursor for magnesium aluminum spinel powder, composed of crystalline ammonium dawsonite hydrate (NH₄Al(OH)₂CO₃·H₂O) and hydrotalcite (Mg₆Al₂(CO₃)(OH)₁₆·4H₂O) phases, was synthesized via precipitation, using ammonium bicarbonate as the precipitant. The precursor was characterized by differential thermal analysis/thermogravimetry, X-ray diffractometry, and scanning electron microscopy. Reactive spinel powder, which could be densified to translucency under vacuum at 1750°C in 2 h without additives, was obtained by calcining the precursor at 1100°C for 2 h.     

Editorial

Higher-Order and Symbolic Computation -