Metabolism of tetramethrin isomers in rat: II. Identification and quantitation of metabolites

1. To examine the metabolic fate of (1RS, trans)- or (1RS, cis)-tetramethrin [3, 4, 5, 6-tetrahydrophthalimidomethyl (1RS, trans)- or (1RS, cis)-chrysanthemate], rat was administered a single oral dose of trans- or cis-[alcohol-14C]tetramethrin at dose levels of 2 or 250 mg/kg. 2. The radiocarbon was almost completely eliminated from rat within 7 days after administration in all groups. 14C-recoveries (expressed as percentages relative to the dosed 14C) in faeces and urine were 38-58 and 42-58% respectively in rat administrated trans-[alcohol-14C]tetramethrin, and in faeces and urine were 66-91 and 9-31% respectively in rat administered cis-[alcohol-14C]tetramethrin. 3. Fourteen metabolites found in excreta were purified by using several chromatographic techniques and identified by spectroanalyses (nmr and MS). Five sulphonate derivatives and three dicarboxylic acid derivatives were found. 4. The main metabolites were sulphonate derivatives in the faeces, and in the urine, alcohols, dicarboxylic acid and reduced metabolites derived from the 3,4,5,6-tetrahydrophthalimide moiety.     

Additives distribution and electrical properties in zinc oxide varistor prepared by a wet chemical method

Cobalt-, praseodymium-added zinc oxide varistor was prepared through a wet chemical method followed by sintering with or without calcination. Changes in grain size, compact density, additives distribution, and voltagecurrent/ capacitance-voltage relations were investigated for the characterization of the samples sintered at temperatures from 1473 to 1573 K without calcination or with calcination at 773 K for 2 h. The electrical properties were compared with nhose of samples prepared by two types of ball mill methods. The wet chemical method provided almost the same additives-distribution profile and less impurities in comparison with the ball grinding method carried out for 10–100 h. The donor concentration and the potential-barrier height for the samples were evaluated by Double Schottky Barrier Model. Addition of small amount of both cobalt and praseodymium in preparation by the wet chemical method was effective for a better nonlinearity relation between voltage and current, which has potential for a smaller sized varistor.     

Au/Pt/Ti/Ni ohmic contacts to p-ZnTe

Ohmic contacts of Au/Pd/Ti/Ni to p-ZnTe show a minimum specific contact resistance of 10^-6 Ωcm² for a p-type doping level of 3×10¹⁹ cm^-3 and at an annealing temperature of 300°C. The Ni and Ti layers are very effective in improving the electrical properties of these contact     

Metabolism of tetramethrin isomers in rat: IV. Tissues responsible for formation of reduced and hydrated metabolites

1. To identify the sites of formation of the reduced metabolites, 3-hydroxy-cyclohexane-1,2-dicarboximide (3-OH-HPI-1 and -2), 1,2-cyclohexanedicarboxylic acid (TCDA) and 1-hydroxy-1,2-cyclohexanedicarboxylic acid (1-OH-HPA), in rat treated with 14C-labelled (1RS, trans)-tetramethrin, [3,4,5,6-tetrahydrophthalimidomethyl (1RS, trans)-chrysanthemate], bile-duct cannulated animals were orally or intravenously administered 14C-labelled 3,4,5,6-tetrahydrophthalimide (TPI) or 3,4,5,6-tetrahydrophthalic acid (THPA), precursors of these metabolites, and bile, urine and faeces were collected for analysis. 2. 3-OH-HPI-1 and 3-OH-HPI-2, which are cis-form reduced metabolites, and 1-OH-HPA were detected in bile and urine samples of the bile-cannulated rat treated intravenously and orally with 14C-labelled TPI, indicating their formation in tissues or blood. TCDA, a trans-form reduced metabolite, was not detected in bile, urine or faeces of the bile-cannulated rat treated intravenously with 14C-THPA, but was found in the faeces after oral application, indicating formation in the gastrointestinal tract. 3. To clarify whether 1-OH-HPA is produced from THPA via TCDA (hydroxylation via reduction) or by direct addition of H2O to its double bond (hydration), rats were orally administered 14C-labelled TCDA, and metabolites in urine and faeces were analysed. The observed lack of 1-OH-HPA indicated formation by direct addition of H2O to the double-bond of THPA. 4. To specify which tissues form reduced and hydrated metabolites, in vitro metabolism studies were carried out. Reduction to the cis-form was found to take place in blood cells, reduction to the trans-form took place in the gastrointestinal tract contents, and hydration took place in the liver and the intestinal tract contents.     

水相酶促酯化法拆分dl－薄荷醇的连续操作

对影响脂肪酶活性、稳定性和对映选择性的因素，如有机溶剂和反应温度等首先进行了优化。其次，使用悬浮于环已烷的粉末状游离脂肪酶（ＣａｎｄｉｄａｃｙｌｉｎｄｒａｃｅａｌｉｐａｓｅＯＦ３６０）作生物催化剂，成功地构建了一个高效的非水相游离酶连续搅拌釜反应器。当使用高度反应性的丙酸酐作为薄荷醇的酰基给体，进行连续的酶促对映选择性酯化反应时，醇的转化率在两周内可保持４０％以上，所生成酯的光学纯度超过９５％ｅ．ｅ。但是，当使用相应的游离丙酸（而不是酸酐）作酰基给体时，薄荷醇的转化率在连续操作开始后迅速下降，表明使用酸酐时的生产力要比使用游离酸时高。最后，对底物溶液的浓度和流速进行了进一步优化；同时对反应器系统的含水量进行了监测，并通过对酸酐料液的浓度或流速进行微调的方法，有效地将有机溶液相的水分浓度控制在一定的范围（２～４ｍｍｏｌ／Ｌ）之内，结果，ｄｌ－薄荷醇对映选择性连续酯化反应非常稳定地运行了两个月之久（转化率４７～３５％，光学纯度９５～９８％ｅ．ｅ．），酶反应器的半衰期超过２００天。     

Room-temperature lasing operation of GaInNAs-GaAssingle-quantum-well laser diodes

We have succeeded in demonstrating continuous-wave (CW) operation of GaInNAs-GaAs single-quantum-well (SQW) laser diodes at room temperature (RT). The threshold current density was about 1.4 kA/cm², and the operating wavelength was approximately 1.18 μm for a broad-stripe geometry. Evenly spaced multiple longitudinal modes were clearly observed in the lasing spectrum. The full-angle-half-power far-field beam divergence measured parallel and perpendicular to the junction plane was 4.5° and 45°, respectively. A high characteristic temperature (T₀) of 126 K under CW operation and a small wavelength shift per ambient temperature change of 0.48 nm/°C under pulsed operation were obtained. These experimental results indicate the applicability of GaInNAs to long-wavelength laser diodes with excellent high-temperature performance     

Fabrication of Bulk β-FeSi2 Crystal With ThreeDimensional Alignment by an Oscillating Magnetic Field

It has been reported that an anisotropic magnetic field could produce the three-dimensional alignment of fine single-crystal particles with the orthorhombic crystal structure.However,the three-dimensional alignment was achieved only in suspensions.Fabrication of bulk"single"materials that have the three-dimensional alignment of grains has been desired.This study proposes a procedure for the fabrication,which consists of slip casting under an oscillating magnetic field and sintering.Optimization of casting and sintering conditions achieved the three-dimensionally aligned bulkβ-FeSi₂.     

Combustion of Aluminum Particles near the Burning Surface in AP/AN Composite Propellants

Aluminum (Al) particles are commonly used in ammonium perchlorate (AP) composite propellants of solid rockets for increasing performance. When propellants including Al particles burn, Al particles easily agglomerate on the burning surface of the propellant. The diameters of agglomerated Al particles are greater than those of mixed particles. The combustion efficiency of the propellant decreases with increasing burning time of the agglomerated Al particles. Therefore, it is important to observe how the agglomerated Al particles burn on the burning surface of AP composite propellant. A lot of researchers have studied Al agglomerate characteristics. Previous studies clarified the relation between the agglomerated Al particle diameter and luminous flame diameter around Al particles near the burning surface. The shapes of luminous flames around agglomerated Al particles are spherical or elliptical. This study evaluates the shapes of the luminous flame around agglomerated Al particles at a constant diameter or a different diameter. When the proportion of the luminous flame diameter (D_f) to the diameter of agglomerated Al particles (D₀) is 1.54–1.71 at a constant D₀, the luminous flames are almost perfectly spherical. Otherwise, the luminous flames are elliptical at a constant D₀. Furthermore, when D_f/D₀ is close to the mean value, the luminous flame is more spherical than elliptical at different D₀. The evaporation rate and the burning rate of Al vapor are inversely proportional to D₀. The oxidation gas temperatures were changed and the activation energy of Al vapor was obtained as 39.2 kJ mol⁻¹.     

Theoretical and experimental analyses of cladding strain produced by expansion of cracked fuel pellets

The intensification of strain in the cladding, caused by the expansion of cracked fuel pellets, was studied using the theory of plate bending. A simplified equation for evaluation of local strain in the cladding was derived which considers the effect of non-axisymmetric deformation in the cladding and the gap between fuel and cladding. Comparison was made with other theoretical analysis, based on the stress function and Fourier series technique.Circumferential strain distribution was also measured with wire strain guages plated on the Zircaloy-2 cladding, which was expanded by use of pre-cracked hollow pellets. Strain distribution data obtained from the proposed equation were found to agree with the experimental results.