A CMOS multichannel 10-Gb/s transceiver

We describe a CMOS multichannel transceiver that transmits and receives 10 Gb/s per channel over balanced copper media. The transceiver consists of two identical 10-Gb/s modules. Each module operates off a single 1.2-V supply and has a single 5-GHz phase-locked loop to supply a reference clock to two transmitter (Tx) channels and two receiver (Rx) channels. To track the input-signal phase, the Rx channel has a clock recovery unit (CRU), which uses a phase-interpolator-based timing generator and digital loop filter. The CRU can adjust the recovered clock phase with a resolution of 1.56 ps. Two sets of two-channel transceiver units were fabricated in 0.11-/spl mu/m CMOS on a single test chip. The transceiver unit size was 1.6 mm /spl times/ 2.6 mm. The Rx sensitivity was 120-mVp-p differential with a 70-ps phase margin for a common-mode voltage ranging from 0.6 to 1.0 V. The evaluated jitter tolerance curve met the OC-192 specification.     

Evaluation of inelastic constitutive models under plasticity-creep interaction for steel at 600°C

Uniaxial tests to identify plasticity-creep interaction in steel at 600°C were carried out as the Benchmark Project by the Subcommittee on Inelastic Analysis and Life Prediction, JSMS. The purpose of this paper is to present recent experimental data and predictions of constitutive models obtained in the project. Ten types of constitutive models were utilized to compare analytical predictions to sixteen benchmark experiments which are grouped into four categories: (I) tensile and creep tests under monotonic loading, (II) mixed mode tests under plastic and creep loading, (III) ratcheting deformation tests under program loads, and (IV) cyclic deformation tests under the combination of different strain rates. The benchmark tests in Group IV are used to estimate the creep-fatigue life of steel; the results will be published in a separate paper.     

An automatic torque ripple compensation system for direct drive motors

A serious problem in motion control is the occurrence of torque ripple. Since a direct drive (DD) motor with a magnet rotor uses a rare-earth magnet, the torque ripple is more serious than that of conventional servomotors. This paper presents an auto-compensation of torque ripple using a software-implemented torque observer. The frequency and amplitude of torque ripple can be obtained in the controller by using the estimated torque from an observer, and the autonomous generation of a compensating current component for a torque ripple is possible. The proposed algorithm has been verified by experiments.     

KGa-priderite and related compound for the selective reduction of nitrogen monoxide with propylene

The catalytic activity of KGa-priderite, K_1.6Ga_1.6Ti_6.4O₁₆, and its related compound KGa₈Ga₉Ti₁₅O₅₆ was investigated for the selective reduction of nitrogen monoxide (NO) with propylene (C₃H₆) in the presence of high oxygen concentrations. The KGa-priderite showed significant activity during this reaction, but the related compound showed only a little activity. These compounds are quite different from the conventional catalysts for NO_x selective reduction and are characterized by the fact that their properties are free from the effects of solid acidity and support metals. This difference was attributable to the NO desorption rate at the surface of these compounds. It has become clear that the KGa-priderite catalyst remarkably adsorbed NO, and it is suggested that the amount of NO adsorbed and the amount of catalytic activity are able to be increased by the design of priderite structure.     

Physical and functional association of cortactin with Syk in human leukemic cell line K562

Human leukemic cell line K562 is induced to differentiate into the megakaryocytic lineage by stimulation with 12-O-tetradecanoylphorbol-13-acetate (TPA). We demonstrate here that TPA stimulation increases tyrosine phosphorylation of an 80-kDa protein at an early stage of megakaryocytic differentiation and that this 80-kDa protein is identical with cortactin. Since tyrosine kinase Syk was activated by TPA stimulation, we examined the possibility that cortactin is a potential substrate of Syk in K562 cells. TPA-induced tyrosine phosphorylation of cortactin was decreased profoundly by overexpression of dominant-negative Syk. Furthermore, cortactin was associated with Syk even before TPA stimulation. Since cortactin was previously referred as an 80/85-kilodalton pp60src substrate, we examined the association between Src and cortactin, whereas its association could not be detected. These data suggest that Syk phosphorylates cortactin in K562 cells upon TPA treatment.     

A broadband power meter calibration system in the frequency rangefrom 10 MHz to 40 GHz using a coaxial calorimeter

A broadband power meter calibration system based on a newly constructed coaxial calorimeter has been developed in the frequency region 10 MHz-40 GHz. The RF power is measured as the difference of DC power supplied to the calorimeter built-in heater in the RF load, when RF is turned off and on, holding an isothermal control between the RF load and a temperature reference. To minimize the error due to the adiabatic coaxial waveguide, we devised a new method utilizing its output port as a test port. The evaluations showed a calibration uncertainty of (0.28-2.2)% expressed by one standard deviation at the 1 mW level in the full band     

Construction of a control system for disturbance rejection using a dual observer

A well‐known control system which can reduce the adverse effects of disturbances is a disturbance observer. However, in many cases of mechanical systems, system disturbances which do not satisfy the matching condition may be imposed. Therefore, it may be difficult to reduce the adverse effects of the disturbances by the traditional disturbance observer. In this paper, a method of control system synthesis for disturbance rejection using a dual observer is proposed. This method is based on the zeroing induced by the disturbance localization problem. This problem may be solved by dividing the state space into observable subspace and unobservable subspace. As compared with an H_∞ controller based on perfect observation, the usefulness of the proposed control system for disturbance rejection is demonstrated by numerical simulations for a two‐mass spring system. © 2002 Scripta Technica, Electr Eng Jpn, 138(4): 50–60, 2002; DOI 10.1002/eej.1138     

Generation of monoclonal antibodies to the rabbit interleukin-2 receptor alpha chain (CD25) and its distribution in HTLV-1-transformed rabbit T cells

Rabbits can be infected with human retroviruses such as human T-cell leukemia virus-1 (HTLV-1) and human immunodeficiency virus (HIV), and provide useful animal models to study retroviral diseases such as adult T-cell leukemia and HIV. Previously we have succeeded in generating monoclonal antibodies (mAbs) against rabbit CD4, CD5 and CD11a antigens. To make this animal species more amenable to cellular and molecular studies, we have attempted to extend the panel of mAbs against rabbit CD antigens. Here we report on the generation of three neutralizing mAbs against interleukin-2 receptor alpha chain (IL-2R alpha) (CD25), Kei-alpha 1 (IgG2b), Kei-alpha 2 (IgG2a) and Kei-alpha 3 (IgG1). They specifically recognize the rabbit Mr 55,000 IL-2 binding protein, IL-2R alpha, and completely inhibit both high- and low-affinity IL-2 binding to F648b cells that express IL-2R alpha as well as IL-2R beta. The use of mAb Kei-alpha 1 confirmed that the rabbit IL-2R alpha is not only a low-affinity IL-2R on its own but also an essential component of high-affinity IL-2R as found in other animal species, and that rabbit activated T cells including HTLV-1-transformed cell lines express high levels of the IL-2R alpha. Together with mAbs against various rabbit CD antigens that we reported previously, these neutralizing mAbs to IL-2R alpha will be valuable for studies of human retrovirus infections, such as those induced by HTLV-1 or HIV, in rabbits.