Studies on biaxial stretching of polypropylene film. IX. Melting behavior of biaxially stretched film in one step

Melting temperature of a film biaxially stretched in one step in air at 152 or 140°C increases with increase of vA, whereas heat of fusion and density decrease with increase of vA, where vA is the degree of stretching in area. The rapid decrease in density occurs for vA > 10. Extrapolation of the plot of the density versus vA^?1/2 gives a value of 0.870 g/cm³ at infinite vA, which has been reported as the amorphous density of isotactic polypropylene by Farrow. This is so because the fine structure of the film becomes more and more amorphous with further stretching and reaches completely amorphous state at infinite vA. The temperature of stretching has a strong effect on the thermal behavior of a film; a low stretching temperature (140°C) brings about lower melting temperature, heat of fusion, and density. Crystallinity after melt press has not so large an effect on the melting behavior as the stretching temperature. Melting temperature and the shape of the thermogram also depend on the heating rate. There is an appropriate heating rate depending on vA which gives the minimum melting temperature. With stretched samples, a small side peak or a shoulder appears at a relatively low temperature in the thermogram when a high heating rate is used.     

Electrochemical properties of iron rust

In order to elucidate the electrochemical properties of iron rust, galvanostatic cathodic polarization of rusted steel and rust electrodes, prepared by fixing a piece of rust plate on an acrylic plate with conductive adhesive, was examined. The change in the amount of crystalline substances in the rust layer was observed by X-ray diffraction. The electrochemically active intermediate substances, could not be identified by X-ray diffraction, but their behaviour was distinguished from that of crystalline substances. The rest potential of the rust electrode was controlled by the equilibrium potential of intermediate substances. “An overlapping dual electrode” model is proposed for rusted steel in aqueous solution. Beneficial elements added to weathering steel inhibit the formation of crystalline magnetite in the cathodic reduction process of rust and increase the electrical resistance of the rust layer.     

Preparation and characterization of Z-type hexaferrites, Ba3(1−x)Sr3x Co2Fe24O41 with x = 0–0.5, via a two-step calcination with an intermediate wet milling

Z-type hexaferrites (Ba_{3(1 − x)}Sr_3x Co₂Fe₂₄O₄₁with x = 0–0.5, Z-hex) were prepared in a nearly phase pure state by a two-step calcination with an intermediate wet milling. The first calcination of the starting mixture comprising oxides or hydroxides at temperatures below 1100^∘C brought about a mixture of layer-structured M and Y-type hexaferrite phases, together with a spinel phase of Co ferrite. Z-hex was fully crystallized after the second calcination up to 1230^∘C. Wet milling between the two calcination steps was decisive for the phase purity. Emphasis was laid on the quantitative analyses of Z-hex, together with the evaluation of anisotropic growth of the crystallites. Sr addition stabilizes Z-hex, while decreases degree of anisotropy simultaneously.     

Tribochemical Surface Reaction and Lubricating Oil Film

A radioactive tracer technique was used to investigate a tribo-chemical surface reaction obtained by a thrust collar type friction Machine. Radioactive dibenzyl disulfide labeled with sulfur-35 was used as an additive. Steel and copper disks were used as friction specimens.

Radioactive copper sulfide on the friction surface was quantitatively measured with a G-M tube, and a kinetical analysis of the reaction was carried out.

The friction coefficient decreased linearly depending on the amount of surface produced on the friction surface. This dependency was accompanied by adsorption of dibenzyl disulfide, which made a more effective lubricating oil film and was enhanced by the sulfide on the friction surface.

The results of kinetical analysis were explained effectively by considering the oil film behavior related to the adsorptive action of the surface sulfide.     

The calculation of particle deposition efficiency due to inertia,diffusion and interception in a plane stagnation flow

The particle deposition mechanism in a plane stagnation flow is investigated analytically and numerically. Particle deposition efficiency η_TID is obtained theoretically by taking into account particle inertia, diffusion and interception. It is compared with various calculated deposition efficiencies, i.e. η_T (due to inertia) + η_I (due to interception) + η_D (due to diffusion), η_TI, (due to inertia and interception) + η_D, etc. In the region where all of the three deposition mechanisms, i.e. inertia, interception and diffusion, act at the same time, real deposition efficiency η_TID is not accurately expressed by η_T + η_I + η_D. However, η_TID is nearly equal to η_TI + η_D unless the interception parameter is zero.The calculated results of particle concentration indicate that a high concentration region is formed near the deposition plate, and that the concentration becomes higher as particle inertia increases.     

High-pressure viscosity prediction of di(2-ethylhexyl) phthalate and tricresyl phosphate binary mixtures using dielectric relaxation data

Dielectric permittivity and loss in di(2-ethylhexyl) phthalate and tricresyl phosphate binary mixtures were measured over a frequency range from 100 Hz to 1.5 MHz under high pressure. The mixtures showed single dielectric relaxation. The composite plots of the dielectric loss data showed one master curve and time–temperature–pressure superposition were applicable. The prediction of high-pressure viscosity was carried out from the change of dielectric relaxation time with temperature and pressure. The predicted results showed relatively good agreement with viscosity data obtained from a falling-sphere viscometer.     

Cloning and characterization of NE-dlg: a novel human homolog of the Drosophila discs large (dlg) tumor suppressor protein interacts with the APC protein

We have cloned a cDNA for a novel human homolog of the Drosophila discs large (dig) tumor suppressor protein, termed NE-dlg (neuronal and endocrine dig). Northern blot analysis revealed that the gene is highly expressed in neuronal and endocrine tissues. Fluorescence in situ hybridization (FISH) and radiation hybrid mapping studies localized the NE-dlg gene to chromosome Xq13. We also found that the NE-dlg gene encoded a 100 kDa protein. Immunolocalization studies using an NE-dlg antibody showed that the protein tended to be expressed in non-proliferating cells, such as neurons, cells in Langerhans islets of the pancreas, myocytes of the heart muscles, and the prickle and functional layer cells of the esophageal epithelium. Proliferative cells, including various cultured cancer cell lines and basal cells in the esophageal epithelium, showed little expression of the NE-dlg protein. In addition, yeast two-hybrid screening and in vitro binding assays revealed that the NE-dlg interacted with the carboxyl-terminal region of the APC tumor suppressor protein. These data suggest that NE-dlg negatively regulates cell proliferation through its interaction with the APC protein.     

Optimization of excimer-forming two-probe nucleic acid hybridization method with pyrene as a fluorophore

A previously presented homogeneous assay method, named the excimer-forming two-probe nucleic acid hybridization (ETPH) method, is based on specific excimer formation between two pyrenes attached at the neighboring terminals of two sequential probe oligonucleotides complementary to a single target. In this study, we investigated assay conditions and optimal molecular design of probes for intense excimer emission using a pyrenemethyliodoacetamide-introduced 16mer probe, a pyrene butanoic acid-introduced 16merprobe and a target 32mer. The length of the linker between the pyrene residue and the terminal sugar moiety remarkably influenced the quantum efficiency of excimer emission; the pair of linker arms of these two probes was optimal. The quantum efficiency was also dependent upon the concentrations of dimethylformamide and NaCl added to the assay solution. Spectroscopic measurements and T m analysis showed that an optimal configuration of the two pyrene residues for intense excimer emission might be affected by pyrene-pyrene interaction, pyrene-duplex interaction (intercalation/stacking) and solvent conditions as a whole. We then demonstrated the practicality of the ETPH method with the optimal hybridization conditions thus attained by determining that the concentration of 16S rRNA in extracts from Vibrio mimicus ATCC 33655 cells in exponential growth phase is 18 500 16S rRNA molecules/cell on average.     

Induction of platelet-activating factor in mice by intravenous administration of a neutral fraction of bakers' yeast mannan

A neutral subfraction of mannan of bakers' yeast (WNM) was found to show a lethal effect in mice when administered intravenously. Symptoms caused by intravenous (i.v.) administration of WNM resembled those resulting from the administration of platelet-activating factor (PAF). CV-3988 and ONO-6240, selective PAF antagonists, prevented hypotension and death caused by the administration of WNM or PAF. A β-adrenoceptor agonist was shown to prevent death caused by WNM, whereas propranolol increased the lethal activity of WNM. Intravenous administration of WNM into mice produced PAF in gall bladder fluid which was determined by platelet aggregation assay. The findings indicate that WNM is able to induce PAF in mice and that the resultant PAF may participate in the WNM-induced lethal activity observed in mice.