Effects of Winding Attachment Positions on Output Characteristics of Flux‐Modulating Synchronous Machines

The flux‐modulating synchronous machine (FMSM) is a new type of multipole SM with nonoverlapping concentrated armature and field windings on the stator. This paper compares the output characteristics of two FMSMs through finite element analysis (FEA) and experiments. In both of the FMSMs, the attachment positions of the armature and field windings are swapped. To determine the reason for the discrepancies in their output characteristics, unsaturated inductances were calculated using a d‐‐q equivalent circuit. In addition, the calculated results of the inductances were confirmed through a visualization of the leakage fluxes using FEA. The results of the study show that the synchronous inductance can be reduced by attaching the armature winding to the air‐gap side of the stator teeth and that the reduction leads to an increase in output power.     

Correlation between motion of source bender element and feedback signal induced by self-monitoring

Since the introduction of bender element tests to soil testing, the reliability of the estimated travel time has been the most serious problem. The author has previously shown a potential solution whereby removing the response of the bender element subsystem from the whole response could dramatically improve the accuracy of the travel time estimation. In order to lay the foundation for estimating the response of the bender element subsystem, this paper examines the correlation between the displacements of the element and the induced feedback signals by employing a self-monitoring element. The response of the self-monitoring element is modeled as a transfer function involving two internal transfer functions that relate the input signals to the displacements and the displacements to the feedback signals, respectively. Using a laser displacement sensor, the displacements are directly measured through the entire surface and reveal the three-dimensional bending motion of the element oscillating in both longitudinal and width directions. The feedback signals are similar to, but inconsistent with, the tip displacements, and an attempt is made to correct the feedback signals. Finally, a conclusion is given on the potential for estimating the response of the bender element subsystem using the self-monitoring element.     

Approximate cutting pattern optimization of frame-supported and pneumatic membrane structures

International Journal of Mechanics and Materials in Design - A simple iterative method is presented for cutting pattern optimization of frame-supported and pneumatic membrane structures for...     

Iodine-123-BMIPP myocardial washout and cardiac work during exercise in normal and ischemic hearts

Due to the changes in the frequency of penicillin-resistant strains of S. pneumoniae, it is necessary to perform surveillance studies of bacterial resistance. Isolates from the upper respiratory tract of asymptomatic children have been useful. There is no information about the difference between isolates from children with and without upper respiratory tract infection (URTI). The objective of the authors in this paper is to establish the prevalence of carrier-state, serotype and antimicrobial resistance of S. pneumoniae isolates from children with and without acute upper respiratory tract infection (URTI) in a rural area in Mexico. A cross-sectional comparative study was performed in Tlaxcala, Mexico. Children from one month 5 years of age were included. Nasopharyngeal swabs were obtained. Identification was done by international microbiology standards. Serotyping was done by the capsular Quellung test. The susceptibility testing was performed by the agar dilution method. Four-hundred and fifty patients were included. S. pneumoniae was isolated in 134 children (29.7%). Frequency of carriers was greater in patients with URTI (107/323) than without URTI (27/127) (33.1% vs. 21.1% p = 0.012, OR 1.84, IC 95% 1.1-3.08). The six most frequent serotypes were: 6B (16.4%); 19F (11.9%); 19A (6.7%); 14, 23F, and 35 (5.2% each), with no difference among the groups. Only 3% of the strains had high level resistance to penicillin, and 12.6% had intermediate resistance, and for ampicillin 4%, amoxicillin 4%, amoxicillin-clavulanate 4%, ceftriaxone 3%, cefotaxime 1.5%, erythromycin 6%, miocamycin 3%, chloramphenicol 4%, and vancomycin 0%. Trimethoprim-sulfamethoxazole resistance was very high (42%). In conclusion, colonization is higher in children with URTI. Five of the most frequent serotypes identified in this study were the same as those identified in patients with S. pneumoniae invasive diseases in Mexico City. In Tlaxcala, Mexico, beta-lactams could be the drug of choice for the treatment of S. pneumoniae lower respiratory tract infections. It is necessary to perform clinical assays to evaluate the efficacy of trimethoprim-sulfamethoxazole due to the high resistance in vitro.     

Quantal release at a neuronal nicotinic synapse from rat adrenal gland

The neuronal nicotinic synapse in tissue slices of the adrenal medulla was studied with whole-cell patch-clamp. Excitatory postsynaptic currents (EPSCs) were evoked by local field stimulation or occurred spontaneously especially when external [K+] was increased. EPSCs were carried by channels sharing biophysical and pharmacological properties of neuronal-type nicotinic receptors (nAChRs). A single-channel conductance (gamma) of 43-45 pS was found from nonstationary variance analysis of EPSCs. Spontaneous EPSCs were tetrodotoxin-insensitive and Ca(2+)-dependent and occurred in burst-like clusters. Quantal analysis of spontaneous EPSCs gave a quantal size of 20 pA and amplitude histograms were well described by binomial models with low values of quantal content, consistent with a small number of spontaneously active release sites. However, rare large amplitude EPSCs suggest that the total number of sites is higher and that extrajunctional receptors are involved. Our estimates of quantal content and size at the chromaffin cell neuronal nicotinic synapse may be useful in characterizing central neuronal-type nicotinic receptor-mediated cholinergic synaptic transmission.     

The predominant contribution of oligopeptide transporter PepT1 to intestinal absorption of beta-lactam antibiotics in the rat small intestine

Although recent evidence suggests that certain beta-lactam antibiotics are absorbed via a specific transport mechanism, its nature is unclear. To confirm whether peptide transport in the rat can be largely ascribed to the intestinal oligopeptide transporter PepT1, the transporter has been functionally characterized and its significance in the intestinal absorption of beta-lactam antibiotics was evaluated. For evaluation of transport activity complementary RNA (cRNA) of rat PepT1 was synthesized in-vitro and expressed in Xenopus laevis oocytes. cRNA induced uptake of several beta-lactam antibiotics and the dipeptide [14C]glycylsarcosine; this was specifically inhibited by various dipeptides and tripeptides but not by their constituent amino acids or by tetra- or pentapeptides. The transport activity of PepT1 for beta-lactam antibiotics correlated well with their in-vivo intestinal transport and absorption. Furthermore, mutual inhibitory effects on uptake were observed between glyclsarcosine and beta-lactam antibiotics. Hybrid depletion of the functional expression of rat PepT1 in oocytes injected with rat intestinal epithelial total mRNA was studied using an antisense oligonucleotide corresponding to the 5'-coding region of PepT1. In oocytes injected with rat mRNA pre-hybridized with the antisense oligonucleotide against rat PepT1, the uptake of [14C]glycylsarcosine was almost completely abolished, whereas its uptake was not influenced by a sense oligonucleotide for the same region of PepT1. Similarly, the uptake of beta-lactam antibiotics was also reduced by the antisense oligonucleotide against rat PepT1. These results demonstrate that the intestinal proton-coupled oligopeptide transporter PepT1 plays a predominant role in the carrier-mediated intestinal absorption of beta-lactam antibiotics and native oligopeptides in the rat.     

Parallel simulated annealing for power system decomposition

This paper proposes a parallel optimization approach to power system decomposition for voltage control. In this paper, a parallel simulated annealing (PSA) technique is developed to decompose power systems so that subsystems are equally separated in terms of the number of nodes and control variables. System decomposition is one of difficult discrete number combinatorial problems. The PSA technique provides better solutions than the conventional SA because of searching a solution near a global minimum over a wide range. The proposed method is tested in IEEE 30, 57, and 118 node systems     

Air vent in water chamber and surface coating on liner slides concerning auxiliary cooling system for the high temperature engineering test reactor

Experimental study was made to confirm the validity of new designs of the auxiliary cooling system for the high temperature engineering test reactor (HTTR). First, it is necessary to vent residence air in outlet side of water chamber of the auxiliary heat exchanger for the HTTR. Accordingly, we have proposed to mount a proper bend duct in the outlet side of the water chamber. Air vent is done by difference between pressures at both ends of the bend duct caused by the forced water circulation using the water pumps. From flow tests, it was confirmed that it is capable of venting the air through the bend duct by circulating the water in maximum capacity of the water pumps. Second, it is essential to prevent seizure and excessive wear of the liner slides of the auxiliary concentric hot gas duct for the HTTR at a service temperature of 950°C. Therefore, we have put forward to coat titanium nitride (TiN) on the surface of the liner slides made of nickel-based superalloy Hastelloy XR using the thermochemical vapor deposition method. As a result of seizure and wear tests, it was confirmed that the TiN coating film of 3 μm on the surface of Hastelloy XR is sufficient.