Power swing analysis in a future metropolitan electric power system on a contingent trip of cryogenic high-power cables

A cryogenic power cable is expected to be capable of carrying bulk power as a main transmission line in a future metropolitan electric power system. It is important to establish a strategy of how to sustain power supply when such a highly densified power supply route trips from the network due to contingency. It is proposed here that the bulk power transmitted by the cryogenic cable could be distributed into the parallel conventional transmission lines by suitable circuit breaker operations in the system. In this process, power-flow routes are forced to be changed with a remarkable modification in the system configuration. In this paper, the power swings associated with the large power-flow change following contingent faults are analyzed by means of a transient network analyzer. It is found that the proposed system modification could be realized without any harmful power swing if the parameters in generators as well as in control devices have conventional magnitudes. It is shown also by simulations that the margin to occurrence in an unstable power swing is left sufficient even if the parameters deviate somewhat from the present magnitudes.     

EXPANSION AND STRESS RELAXATION OF EXPRESSED CAKE

Expansion and stress relaxation of expressed cake are discussed.

The expansion process of expressed cake after release of load is very similar to consolidation of solidndashliquid mixtures, although a liquid flow in the expansion process is opposite in direction to that in consolidalion. This process can be analyzed well by use of the Terzaghi Voigt combined model. It is shown that the rate of primary deformation in expansion is much smaller than that in consolidation under the same change in compressive pressure. It is also found that the ratio of secondary deformation to total deformation in expansion is much larger than that in consolidation.

Stress relaxation of expressed cake, which is observed when expression is stopped before attaining an equilibrium compression state of a material, can be explained by use of a consolidation and expansion theory. In the relaxation process, local expansion appears near the drainage surface while local consolndash idation appears near the center of the cake. The equilibrium cake stress is uniquely determined by the average consolidation ratio when the expression is interrupted.     

Crystal orientation of β-phase isotactic polypropylene induced by magnetic orientation of N,N′-dicyclohexyl-2,6-naphthalenedicarboxamide

Melt crystallization of isotactic polypropylene (iPP), containing crystallites of N,N′-dicyclohexyl-2,6-naphthalenedicarboxamide (DCNDCA) as a nucleating agent of the the β-phase iPP crystal, is carried out under a magnetic field (6 T) to obtain the alignment of the iPP crystal induced by magnetic alignment of DCNDCA. In a previous paper, DCNDCA was reported to undergo magnetic alignment in a liquid suspension. The obtained iPP sample exhibits alignment of the β-phase crystal with the c-axis aligned perpendicular to the magnetic field. The comparison of this alignment of iPP with the reported magnetic alignment of DCNDCA indicates that the β-phase crystal grows epitaxially on the DCNDCA crystal. The (330)_β plane of the iPP crystal lies on the bc-plane of the DCNDCA crystal in which the direction of the c-axis of the iPP coincides with the direction of the b-axis of the DCNDCA crystal.     

An ESR study of the film formation steps of vapor deposition polymerization of polyamic acid

A film of polyamic acid is formed by vapor deposition polymerization of pyromellitic dianhydride (PMDA) and 4,4′-diaminodiphenyl ether (ODA). We have taken ESR spectrum during the polymerization process and compared it with the ESR spectrum of films obtained from solution polymerization. In the intermediate polymers during vapor deposition polymerization, the amide bond (? CONH? ) is coplanar with the benzene ring and two protons in the PMDA molecule. This intermediate polymer has one unpaired electron that interacts with the two nitrogen nuclei equally. On the other hand, in the polymer obtained by solution polymerization, the amide bond and the benzene ring of PMDA are not coplanar. In this polymer, too, some of the molecules have an unpaired electron that seems to have almost no coupling with NH groups. These results imply that the polymer formation via vapor deposition proceeds through different intermediates and different molecular configurations from that via the solution process.     

Numerical analyses of high‐beta spherical tokamaks with varied elongation

The effect of plasma elongation on the second‐stable spherical tokamak (ST) was numerically studied using the experimentally measured pressure and current profiles of ultrahigh‐beta STs. The maximum beta of ST over 50% was obtained in the TS‐3 ST/CT experiment by applying an external toroidal field to an FRC. It was found that the marginal beta for the ballooning instability increased with the plasma elongation κ of ST. The elongated STs with κ > 2 have the magnetic shear (S)–pressure gradient (α) profiles located in the second‐stable regime for the ballooning mode and the stability margin increased with κ. The close relation between the absolute minimum‐B profile and the second stability was documented. The effect of elongation on maximum beta was observed to saturate when κ exceed 3, indicating that the optimized elongation for high‐beta STs is located around 2 < κ < 3. © 2006 Wiley Periodicals, Inc. Electr Eng Jpn, 155(4): 1–6, 2006; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20132     

Evaluation of static and dynamic fracture toughness in ductile cast iron

Crack extension behavior and fracture toughness of ductile cast iron were examined by three-point bend tests, where various detection methods of crack initiation under static and dynamic loading conditions were adopted. Loading on the specimens was interrupted at various displacement points, and the final fracture surfaces of the specimen were observed via scanning electron microscopy (SEM). Crack-tip opening displacement (CTOD) obtained under the dynamic loading condition was smaller than that under the static loading condition in ferritic ductile cast iron, and CTOD additionally decreased with increasing pearlite content in the matrix. The relationship between J (ΔC) obtained by the compliance changing rate method and J(R) established by the intersection of the crack extension resistance curve and the theoretical blunting line varied with pearlite content. The average value of .J(ΔC) and J(R), that is J (mid), was proposed to define the fracture toughness of ductile cast iron; J (mid) was considered to be a reasonable measure for the fracture toughness of ductile cast iron, irrespective of loading condition and the pearlite content in the matrix.     

Analysis of amyloid deposition in a transgenic mouse model of homozygous familial amyloidotic polyneuropathy

Amyloid fibrils derived from the Japanese, Portuguese, and Swedish types of familial amyloidotic polyneuropathy all consist of a variant transthyretin (TTR) with a substitution of methionine for valine at position 30 (TTR Met 30). In an attempt to establish an animal model of TTR Met-30-associated homozygous familial amyloidotic polyneuropathy and to study the structural and functional properties of human TTR Met 30, we generated a mouse line carrying a null mutation at the endogenous ttr locus (ttr-/-) and the human mutant ttr gene (6.0-hMet 30) as a transgene. In these mice, human TTR Met-30-derived amyloid deposits were first observed in the esophagus and stomach when the mice were 11 months of age. With advancing age, amyloid deposits extended to various other tissues. Because no significant difference was detected in the onset, progression, and tissue distribution of amyloid deposition between the ttr-/- and ttr+/+ transgenic mice expressing 6.0-hMet 30, endogenous normal mouse TTR probably does not affect the deposition of human TTR Met-30-derived amyloid in mice. TTR is a tetramer composed of four identical subunits that binds thyroxine (T4) and plasma retinol-binding protein. The introduction of 6.0-hMet 30 into the ttr-/- mice significantly increased their depressed serum levels of T4 and retinol-binding protein, suggesting that human TTR Met 30 binds T4 and retinol-binding protein in vivo. The T4-binding ability of human TTR Met 30 was confirmed by the analysis of T4-binding proteins in the sera of ttr-/- transgenic mice expressing 6.0-hMet 30. The T4-binding studies also demonstrated the presence of hybrid tetramers between mouse and human TTR subunits in the ttr+/+ transgenic mice expressing 6.0-hMet 30.     

Acrylic nonaqueous dispersion using butylated melamine-formaldehyde resin as dispersant

A series of acrylic nonaqueous dispersions were prepared by using various kinds of butylated melamine–formaldehyde (BMF) resins as dispersant. The functional group composition of BMF to form stable dispersion was butoxy group more than 13 mol/BMF 1 mol, and methylol group ranged from 1 to 2.5 mol/BMF 1 mol. It is concluded that the anchoring of BMF to acrylic copolymer was due to the formation of covalent bond between methylol group in BMF and hydroxy group in acrylic copolymer.