Sensitivity of an anadically oxidized aluminium film on a surface acoustic wave sensor to humidity

The sensitivity, transient response and sensitivity mechanism of a surface acoustic wave humidity sensor using porous anodically oxidized aluminium (alumina) films as mechanical interfaces have been studied theoretically and experimentally. It is found that the sensitivity of alumina films of 1.0 μm thickness is -0.034 m/(s %RH) and is the same order as that of polyimide films. The transient response of alumina films to humidity is about one order faster than that of polyimide films. For the sensitivity mechanism, the phase-velocity change is attributed to the mechanical perturbation caused by the absorption of water molecules. The equivalent density change of alumina films between 0 and 100%RH is about 0.7%. In addition, the actual stiffness constants of alumina films are two orders less than those of bulk alumina.     

Characterization of alternative plasticizers in poly(vinyl chloride) sheets for blood containers

This study aimed to optimize the ratio of dioctyl 4‐cyclohexene‐1,2‐dicarboxylate (DOTH) and di‐isononyl‐cyclohexane‐1,2‐dicarboxylate (DINCH^®) for use as plasticizers in poly(vinyl chloride) (PVC) sheets. We also evaluated the biological safety of DOTH for its potential to be part of a safe PVC‐based blood container. The suppression of hemolysis in mannitol‐adenine‐phosphate / red cell concentrates (MAP/RCC) with DOTH/(DINCH^®‐PVC) sheets and the elution of plasticizers from the sheets increased with higher DOTH compositions. The properties of the PVC sheet containing DOTH and DINCH^® in the ratio of 25:33 parts against PVC 100 parts as a weight were almost identical to the PVC sheet made of di(2‐ethylhexyl) phthalate. From a subchronic toxicity test, DOTH did not show any adverse effects on all organs, including the testes, epididymis, liver, and kidneys. The no‐observed‐adverse‐effect level was 300 mg/kg body weight/day in a rat. These results suggest that DOTH/DINCH^® (25:33) is a promising candidate for the replacement of di(2‐ethylhexyl) phthalate in blood containers. J. VINYL ADDIT. TECHNOL., 22:520–528, 2016. © 2015 Society of Plastics Engineers     

Digital filtering implementations for the detection of broad spectral features by direct analysis of passive Fourier transform infrared interferograms

Finite impulse response (FIR) filters and finite impulse response matrix (FIRM) filters are evaluated for use in the detection of volatile organic compounds with wide spectral bands by direct analysis of interferogram data obtained from passive Fourier transform infrared (FT-IR) measurements. Short segments of filtered interferogram points are classified by support vector machines (SVMs) to implement the automated detection of heated plumes of the target analyte, ethanol. The interferograms employed in this study were acquired with a downward-looking passive FT-IR spectrometer mounted on a fixed-wing aircraft. Classifiers are trained with data collected on the ground and subsequently used for the airborne detection. The success of the automated detection depends on the effective removal of background contributions from the interferogram segments. Removing the background signature is complicated when the analyte spectral bands are broad because there is significant overlap between the interferogram representations of the analyte and background. Methods to implement the FIR and FIRM filters while excluding background contributions are explored in this work. When properly optimized, both filtering procedures provide satisfactory classification results for the airborne data. Missed detection rates of 8% or smaller for ethanol and false positive rates of at most 0.8% are realized. The optimization of filter design parameters, the starting interferogram point for filtering, and the length of the interferogram segments used in the pattern recognition is discussed.     

Study on sustainable redevelopment of a densely built-up area in Tokyo by introducing a distributed local energy supply system

“Distributed local energy systems” had been expected to rationalize the supply of energy to built-up areas, but until now very little research has been performed to estimate the effect of their application to actual cities. In this research, therefore, a future vision for the year 2030 in the Sancha Area (SANCHA VISION 2030), a typical densely built-up area in Tokyo, has been elaborated including a simulation to estimate benefits from the application of distributed energy systems in terms of reduced energy consumption and CO₂ emissions as well as mitigation of the heat-island phenomenon. As a result, it was demonstrated that a “distributed local energy system”, which provides a district with both electrical power and heat through an integrated distribution system, may contribute to a considerable improvement in energy efficiency for those areas. In addition, it may also provide other benefits, including enhancement of living amenity and urban security in times of emergency.     

A 50 GHz GaAs FET MIC transmitter/receiver using hermetic miniatureprobe transitions

A very compact 50-GHz-band transmitter/receiver for a video link is described. The RF assemblies used in the system consist of 25/50-GHz frequency doublers, a 25-GHz dielectric-resonator oscillator, and a 25-GHz FM modulator. The circuits make extensive use of microwave integrated circuit (MIC) technology with all GaAs FETs as active elements. The frequency doublers exhibit a minimum conversion loss of 2.6 dB and a maximum output power of 11 dBm. The modulator is highly frequency stabilized by the dielectric resonator. Recently developed miniature probe microstrip-to-waveguide transitions permit the MIC assemblies to be installed compactly in hermetically sealed packages. Design considerations and experimental data for the transition are presented. Using these technologies a transmitting power of 10 dBm and a receiver noise figure of 13 dB have been obtained     

Vacancy site occupation by Co and Ir in half-Heusler ZrNiSn and conversion of the thermoelectric properties from n-type to p-type

The n-type thermoelectric properties of the half-Heusler compound ZrNiSn can be converted to p-type by the addition of Co and Ir. We found that Co and Ir atoms preferably occupy the vacancy sites instead of substituting at Ni sites. This implies that the phase stability of the compound gradually changes towards that of the Heusler compound Zr(Ni,M)₂Sn, where M is Co and/or Ir. The occupation of vacancy sites by Co and Ir atoms leads to a drastic reduction in lattice thermal conductivity owing to the enhancement of phonon scattering by the solid solution effect.     

Seismic proof test of a reinforced concrete containment vessel (RCCV): Part 1: Test model and pressure test

In Japan, the Nuclear Power Engineering Corporation (NUPEC), sponsored by the Ministry of Economy, Trade and Industry (METI), has been conducting a series of seismic reliability proving tests using full-scale or close to full-scale models to simulate actual important equipment that is critical for seismic safety of nuclear power plants. The tests are intended to validate the seismic design and reliability with a sufficient margin even under destructive earthquakes. A series of tests was carried out on a reinforced concrete containment vessel (RCCV) for advanced boiling water reactor (ABWR) from 1992 to 1999. A large-scale high-performance shaking table at Tadotsu Engineering Laboratory, the largest in the world, was used for this test. Part 1 reports the test model and the results of pressure and leak tests. Part 2 describes test procedures, input waves and the results of verification tests such as changes of stiffness, characteristic frequency and damping ratio, the failure of the model and the load deflection. Part 3 shows the seismic safety margin that was evaluated from the energy input during the failure test to a design basis earthquake. Part 4 reports simulation analysis results by a stick model with lumped masses.     

Moiré interferometry measurements of neartip deformation in inhomogeneous elasticplastic fracture specimens

Moiré interferometry was used for direct measurements of the crack tip behavior in the homogeneous compact tension (CT) specimens of A533B and HT80 steels, and in electron-beam welded inhomogeneous CT specimens of the two materials. These two materials have considerably different yield stresses, although their elastic properties are the same. Five types of homogeneous and inhomogeneous specimens were used in the experiment. Moiré fringe patterns of the five specimen types were directly compared for elastic, elastic-plastic and unloaded stages. Although the global deformations in terms of the load versus COD relations exhibit little inhomogeneity effects, large inhomogeneity effects were observed in the moiré fringe patterns in the elastic-plastic and unloaded stages. The near-tip deformations were also compared with the corresponding HRR singular fields. In a horizontal weld specimen, due to strong hardening in the weld region, the slope of the displacement field does not shift the characteristic HRR field for the A533B or the HT80 steel for increasing load.     

Enhancement of human parainfluenza virus-induced cell fusion by pradimicin, a low molecular weight mannose-binding antibiotic

Oligosaccharides, especially mannose residues, expressed on the cell surface, are thought to be important for virus-induced membrane fusion. We examined the effect of mannose-binding compounds, pradimicin derivative BMY-28,864 (PRM) and concanavalin A (Con A), on cell fusion of human parainfluenza type 2 virus (hPIV2)-infected HeLa cells. Syncytium formation of hPIV2-infected HeLa cells was suppressed in the presence of Con A. On the other hand, PRM enhanced cell fusion of hPIV2-infected HeLa cells. These effects were blocked by addition of mannose-rich mannan. However, PRM shows little effect on virus growth and the expression of viral glycoproteins on the cell surface in hPIV2-infected HeLa cells. Fluorescein-isothiocyanate-labeled pradimicin and Con A bound to both uninfected and hPIV2-infected mononuclear cells, indicating that these compounds have an affinity to several cellular component(s). In contrast to Con A, PRM had little affinity to the viral glycoproteins. It is inferred from these results that the enhancement of hPIV2-induced cell fusion is probably due to the interaction between PRM and cellular component(s).     

Contributions of generators for power flow and loads in a power system

Because of the introduction of deregulation and competition in the electricity supply industry, large numbers of IPPs (Independent Power Producers) will get into the market. It has become much more important to be able to determine which generators are supplying a particular load, which generator is responsible for transmission line congestion, and what is each generator's contribution to the system losses. In this paper, we propose a way to calculate these contributions automatically. The applicability of the proposed technique is demonstrated using the EAST 10 47‐bus power system. © 2003 Wiley Periodicals, Inc. Electr Eng Jpn, 144(3): 28–35, 2003; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.10181