Preparation of a Near-Infrared Ray Absorption Film from N-Phenylthiocarbamoyl Chitosan Derivative

We recently observed that the decanoylation of N-phenylthiocarbamoyl chitosan (2) with a mixture of decanoic anhydride and pyridine at 60 °C for 24 h afforded N,N-(decanoyl)phenythiocarbamoyl-/2-isothiocynato chitosan decanoate (3b) rather than the expected product N,N-(decanoyl)phenylthiocarbamoyl chitosan decanoate (3a). This result suggested that some of the N,N-(decanoyl)phenylthiocarmbamoyl groups had been converted to isothiocyanate groups during the decanoylation process. The subsequent reaction of compound 3b with aniline gave N,N-(decanoyl)phenylthiocarbamoyl/N-phenylthiocarbamoyl chitosan decanoate (4) in high yield. A solution of compound 4 in CHCl₃ was then added to a solution of copper decanoate (5) in the same solvent, and the resulting mixture was cast onto a glass plate to give a cast film. The film was annealed at 200 °C in an oven to give a greenish film, which showed good near-infrared absorption characteristic in the range of 800–2200 nm.     

Vapor absorption by LiBr aqueous solution in vertical smooth tubes

Heat and mass transfer in a falling film vertical in-tube absorber was studied experimentally with LiBr aqueous solution. The presented results include the effect of solution flow rate, solution subcooling and cooling water temperature on the absorption in a smooth copper tube 16.05 mm I.D. and 400 mm long. The experimental data in the previous report for a 1200-mm-long tube was also re-examined and compared. It was demonstrated by the observation of the flow in the tube that the break down of the liquid film into rivulets leads to deterioration of heat and mass transfer at lower film Reynolds number or in longer tubes. An attempt to evaluate physically acceptable heat and mass transfer coefficients that are defined with estimated temperature and concentration at the vapor–liquid interface was also presented.     

Synthesis and luminescence of Sr2CeO4 fine particles

Fine particles of a blue emission phosphor Sr₂CeO₄ have been synthesized using a chemical co-precipitation technique, and the textual and luminescent properties were compared with the one synthesized by the conventional solid-state reaction method. Particle size and distribution of the Sr₂CeO₄ fine powder prepared by the co-precipitation process were smaller and narrower than those obtained by the samples prepared from the conventional one. The emission intensity of the fine particles was equal to that of the larger particles prepared from the solid-state reaction, on the contrary to the general tendency that emission intensity decrease with particle size reduction. Although no Ce³⁺ peaks were observed in EPR measurements, X-ray photoelectron spectra of the samples clearly elucidated the existence of Ce³⁺ only on the surface of Sr₂CeO₄.     

Comparison of activities in selective catalytic reduction of NOx by C3H8 over Co/MFI, Fe/MFI, and H/MFI zeolite catalysts

The Co/MFI(SiO₂/Al₂O₃ = 30) were prepared by a precipitation method with NaOCl in alkali solutions exhibited high activities to N₂ at 250 °C for the selective catalytic reduction (SCR) of NO_x. These catalysts showed two UV–vis bands at 700 and 400 nm, indicating the presence of octahedral Co(III) as well as tetrahedral Co(II). The high SCR activity over such Co(III, II)/MFI(30) seems to come from Co(III)---O moieties. The Co(II)MFI(30) catalysts prepared from Co(II)Cl₂ exhibited low SCR activities due to the presence of tetrahedral Co(II) ions in MFI. Less CO formation occurred over Co/MFI catalysts. The Fe/MFI(30) catalyst exhibited high activity due to the presence of some Fe---O species in MFI but more amount of CO were produced during SCR. H/MFI(30) catalyst exhibited a good SCR activity. However, more amount of carbonaceous deposits were produced on it. The correlation between acid concentration and SCR activity was discussed over H/MFIs.     

Functioning survival rate of fixtures and superstructures of osseointegrated implants: ten years of progress in Tokyo Dental College Hospital (second report)

Endoglucanase production was measured in culture filtrates of four species of Saccobolus growing in media containing glucose or crystalline cellulose as the only carbon sources. Enzyme activity was four to seven times higher in the presence of cellulose than glucose. S. saccoboloides showed maximal growth and enzyme production. The extracellular proteins secreted during growth on cellulose were separated by polyacrylamide gel electrophoresis and stained for proteins. A zymogram technique was used to visualize bands with endoglucanase activity. The four species showed different protein and isoenzyme patterns.     

Effect of immunosuppression on composition of quasispecies population of hepatitis C virus in patients with chronic hepatitis C coinfected with human immunodeficiency virus

BACKGROUND/AIMS: To study the effects of the immunosuppression caused by the reduction of CD4 activity on the composition of hepatitis C virus (HCV) populations, we analyzed the number of HCV quasispecies clones and the nucleotide diversity of the hypervariable region 1 (HVR1) of HCV in 37 patients with hemophilia with persistent HCV infection, with or without human immunodeficiency virus (HIV). METHODS: The numbers of HCV quasispecies clones were measured by fluorescence single-strand conformation polymorphism analysis. Direct sequencing was used to analyze the degree of diversity of HVR1. We compared these values according to coinfection with HIV, and CD4 counts of patients. RESULTS: There were no differences in either the number of HCV clones or the diversity between patients with and without HIV coinfection. In HIV coinfected patients the diversity decreased in association with the decrease in CD4 count while the number of HCV clones did not. The diversity of HVR1 was 3.64 +/- 5.03% in patients with a CD4 count < 50/microliters and 14.92 +/- 6.03% in patients with a CD4 count > or = 50/microliters; it was significantly lower in the former (p = 0.0002). CONCLUSIONS: A severe reduction in the CD4 count, which is considered to cause a decline in the activity of helper T-lymphocytes, induced changes in the composition of HCV populations; one or a few quasispecies clones are predominant in the HCV population in the serum of individual patients.     

Color registration error reduction method compensating the influence of belt thickness variation in electrophotographic process

This paper proposes a new belt drive control method for reducing a belt velocity-fluctuation that is caused by a belt thickness-variation in the circumferential direction. A belt driving system performs feedback control with a rotary encoder-output mounted on a driven roller. This proposed method correct the reference value of the feedback control for the purpose of the belt velocity regulation. The correction includes two steps. The first step acquires the encoder-output of the driven roller and calculates the rotational angular velocity-fluctuation with one cycle of the belt rotation. The second step converts from the velocity-fluctuation to the correction value of the feedback reference. The correction value cancels a detection error of the driven roller caused by the belt thickness-variation. After these steps, the belt driving system controls the belt velocity as compensating the belt velocity-fluctuation. Experimental result showed the significant fluctuation reduction on a typical tandem-engine printer.     

Molecular basis of a hereditary type I protein S deficiency caused by a substitution of Cys for Arg474

The molecular basis for a hereditary type I protein S (PS) deficiency was investigated. DNA sequence analysis in the proband showed a novel missense mutation substituting Cys (TGT) for Arg474 (CGT) that is a highly conserved amino acid residue among the related proteins. This missense mutation cosegregated with the type I PS deficiency in this family. Transient expression studies showed that the secretion of the recombinant Cys-mutant PS was markedly decreased compared with that of the recombinant wild-type PS, reproducing the observed phenotype of type I deficiency. Stable expression and pulse-chase experiments demonstrated an intracellular degradation and an impaired secretion of the recombinant Cys-mutant PS. Furthermore, the substitution of Arg474 by Ala or Glu, but not by Lys, markedly reduced the secretion of the recombinant PS mutants in transient expression studies, suggesting that a positively charged basic amino acid might be needed at residue 474 and might play a key role in the protein structure and conformation of the sex hormone binding globulin-homology domain of the PS molecule. We postulate that the loss of the highly conserved Arg474 might be responsible for the type I PS deficiency inherited in this family.     

Environmental effect on room- temperature ductility of isothermally forged tial- base alloys

Isothermally forged TiAl-base alloys (Al-rich, Mn-containing, and Cr-containing TiAl) were heat-treated in various conditions, and equiaxed grain structures consisting of γ and α₂ or Β phases were obtained. The heat-treated alloys were tensile tested in vacuum and air at room temperature, and the environmental effect on tensile elongation was studied. The ductility of the alloys consisting of equiaxed γ grains and a large amount of α₂ grains was not largely affected by laboratory air, and a decrease in the amount of α₂ grains resulted in a large reduction of ductility in air. The Β phase in the Cr-containing alloy improved the ductility in vacuum, but it resulted in a large reduction of ductility in air. Formerly with Kougakuin University, Shinjyuku-ku, Tokyo, Formerly with National Research Institute for Metals, Meguro-ku, Tokyo,