Evaluation of in vitro stability of large unilamellar liposomes coated with a modified polysaccharide (O-palmitoylpullulan)

Aiming at encapsulation of a hydrosoluble drug, large unilamellar liposomes (LUV) of egg phosphatidylcholine (PC) were coated with a natural polysaccharide derivative, O-palmitoylpullulan (OPP), and its in vitro stability evaluated using fluorescent probes. This coating (in OPP/PC weight ratio of 3) improved significantly the in vitro stability of LUV by decreasing both the permeability and fluidity of the liposomal membrane.This paper was accepted for publication after the 1995 Conference of the European Society of Biomaterials, Oporto, Portugal, 10–13 September.     

A New Triazole-Thiol Compound Organofunctionalized on the Silica Gel Surface: Chemical Properties and Copper Sorption in Ethanol / Water Media

Silicon - This study describes the preparation and characterization of 3-chloropropyl silica gel with 4-amino-5-(4pyridyl)-4H-1,2,4-triazole-3-thiol (SGA) for copper adsorption in different media....     

Surface Pretreatments of Silicon Nitride for CVD Diamond Deposition

The efficiency of different surface pretreatments (four standard chemical etchings and four diamond powder abrasive procedures) on silicon nitride (Si₃N₄) substrates for chemical vapor deposition (CVD) of diamond has been systematically investigated. Blank Si₃N₄ samples were polished with colloidal silica (∼0.25 μm). Diamond nucleation and growth runs were conducted in a microwave plasma chemical vapor deposition apparatus for 10 min and 6 h, respectively. Superior results concerning nucleation density ( N _d∼ 10¹⁰ cm⁻² after 10 min), film uniformity, and grain size (below 2 μm after 6 h) were obtained for the mechanically microflawed samples, revealing that chemical etchings (hot and cold strong acids, molten base or CF₄ plasma) are not crucial for good CVD diamond quality on Si₃N₄.     

Li influx and binding, and li/mg competition in bovine chromaffin cell suspensions as studied by li NMR and fluorescence spectroscopy

Li(+) influx by bovine chromaffin cells, obtained from bovine adrenal medulla, was studied in intact cell suspensions using (7)Li NMR spectroscopy with the shift reagent [Tm(HDOTP)](4-). The influx rate constants, k(i), were determined in the absence and in the presence of two Na(+) membrane transport inhibitors. The values obtained indicate that both voltage sensitive Na(+) channels and (Na(+)/K(+))-ATPase play an important role in Li(+) uptake by these cells. (7)Li NMR T(1) and T(2) relaxation times for intracellular Li(+) in bovine chromaffin cells provided a T(1)/T(2) ratio of 305, showing that Li(+) is highly, immobilized due to strong binding to intracellular structures. Using fluorescence spectroscopy and the Mg(2+) fluorescent probe, furaptra, the free intracellular Mg(2+) concentration in the bovine chromaffin cells incubated with 15 mM LiCl was found to increase by about mM after the intracellular Li(+) concentration reached a steady state. Therefore, once inside the cell, Li(+) is able to displace Mg(2+) from its binding sites.     

Spectroscopic Multicomponent Analysis Using Multi-objective Optimization for Variable Selection

The multiple determination tasks of chemical properties are a classical problem in analytical chemistry. The major problem is concerned in to find the best subset of variables that better represents the compounds. These variables are obtained by a spectrophotometer device. This device measures hundreds of correlated variables related with physicocbemical properties and that can be used to estimate the component of interest. The problem is the selection of a subset of informative and uncorrelated variables that help the minimization of prediction error. Classical algorithms select a subset of variables for each compound considered. In this work we propose the use of the SPEA-II （strength Pareto evolutionary algorithm II）. We would like to show that the variable selection algorithm can selected just one subset used for multiple determinations using multiple linear regressions. For the case study is used wheat data obtained by NIR （near-infrared spectroscopy） spectrometry where the objective is the determination of a variable subgroup with information about E protein content （%）, test weight （Kg/HI）, WKT （wheat kernel texture） （%） and farinograph water absorption （%）. The results of traditional techniques of multivariate calibration as the SPA （successive projections algorithm）, PLS （partial least square） and mono-objective genetic algorithm are presents for comparisons. For NIR spectral analysis of protein concentration on wheat, the number of variables selected from 775 spectral variables was reduced for just 10 in the SPEA-II algorithm. The prediction error decreased from 0.2 in the classical methods to 0.09 in proposed approach, a reduction of 37%. The model using variables selected by SPEA-II had better prediction performance than classical algorithms and full-spectrum partial least-squares.     

Induction motor fault detection and diagnosis using a current state space pattern recognition

In the last few decades the continuous monitoring of complex dynamic systems has become an increasingly important issue across diverse engineering areas. This paper presents a pattern recognition based system that uses visual-based efficient invariants features for continuous monitoring of induction motors. The procedures presented here are based on the image identification of the 3-D current state space patterns that allow the identification of distinct fault types and, furthermore, their corresponding severity. This automatic fault detection system deals with time-variant electric currents and is based on the identification of three-phase stator currents specified patterns. Several simulation and experimental results are also presented in order to verify the effectiveness of the proposed methodology.     

An Investigation into the Use of Water by Portuguese Industry

ABSTRACT

The continuous increase in water demand for various uses underlines the importance of supply problems in the general context of water resources management.

In this domain it would clearly be useful to collect and make available all the data currently stored on different paper supports and kept by several regional agencies. This would provide an immediate overview of tbe resources, and also permit forecasting the future demand for tbe various utilizations.

This paper describes a project involving a database to be used for groundwater resources management, conceived not only as a support for research activity, but also as a contribution to developing new and more efficient managementprocedures. The database has been designed to be used on a personal computer, with software readily available on the market.     

Extraction and characterization of highly purified collagen from bovine pericardium for potential bioengineering applications

Bovine pericardium is widely used as a raw material in bioengineering as a source of collagen, a fundamental structural molecule. The physical, chemical, and biocompatibility characteristics of these natural fibers enable their broad use in several areas of the health sciences. For these applications, it is important to obtain collagen of the highest possible purity. The lack of a method to produce these pure biocompatible materials using simple and economically feasible techniques presents a major challenge to their production on an industrial scale. This study aimed to extract, purify, and characterize the type I collagen protein originating from bovine pericardium, considered to be an abundant tissue resource. The pericardium tissue was collected from male animals at slaughter age. Pieces of bovine pericardium were enzymatically digested, followed by a novel protocol developed for protein purification using ion-exchange chromatography. The material was extensively characterized by electrophoresis, scanning electron microscopy, energy dispersive X-ray spectroscopy, and infrared spectroscopy. The results showed a purified material with morphological properties and chemical functionalities compatible with type I collagen and similar to a highly purified commercial collagen. Thus, an innovative and relatively simple processing method was developed to extract and purify type I collagen from bovine tissue with potential applications as a biomaterial for regenerative tissue engineering.     

Low-cost deployment proposal to urban mobility in smart cities

Rational use of cars in smart cities can represent an economical and cheaper way to decrease the quantity of cars on the roads to better the life quality of the populations. This paper presents a low-cost deployment proposal called “URCa project” to reach these goals and proposes a paradigm change by sharing the cars considering some logistic aspects including car ride mechanism. Technical feasibility to deploy this solution was checked by means of a proof of concept. The concept was proven by passenger counting and license plate that are essential information in this solution were obtained taking photographs, applying two types of recognition algorithms and sending the results to be stored and evaluated by analytic data processes of a transit regulatory agency showing that this project is technically viable. The low-cost solution was justified by a financial analysis based on both costs (URCa solution and a bridge) that has shown a ratio of 1:10,000.