Breakdown characteristics of oil and paper insulation for a very fast transient voltage

This paper describes the dielectric breakdown characteristics of oil and oil‐impregnated paper for very fast transient (VFT) voltages. Blumlein circuits generate VFT voltages of 60 and 300 ns in a pulse width that simulates disconnecting switching surges in gas‐insulated switch gears. We measured the breakdown voltages of needle‐to‐plane, plane‐to‐plane oil gaps and several pieces of paper between plane electrodes for VFT and lightning impulse voltages. The measured data were formulated in V‐t characteristics and Weibull probability distributions. The inclination n of V‐t characteristics of insulating paper is 150, which is less than n = 13.7 of the plane‐to‐plane oil gap in the VFT time range. The shape parameters of Weibull distribution obtained in this study show that the scattering of breakdown voltages of paper is much less than that of oil. © 2002 Wiley Periodicals, Inc. Electr Eng Jpn, 141(4): 16–24, 2002; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.10043     

Stabilization of inter-area and/or oscillatory modes in large-scale power system by voltage impedance power system (VIPS) apparatus based on decentralized control scheme

New technologies such as power electronics have made it possible to change continuously the impedance of a power system not only to control power flow but also to enhance stability. A power system incorporating a variable impedance apparatus such as a variable series capacitor (VSrC) and high-speed phase shifter (HSPS) is called VIPS (Variable Impedance Power System) by the authors. This paper proposes a novel control method of VIPS apparatus such as VSrC and HSPS installed at an interconnecting point for stabilizing inter-area unstable and/or oscillatory modes. The proposed design method of the control system is a kind of hierarchical decentralized control method of a large-scale power system based on a Lyapunov function. Under the proposed control scheme, each subsystem can be stabilized independently by local controllers such as AVR, speed governor and PSS, and then the whole interconnected system can be stabilized by VIPS apparatus taking into account interactions between subsystems. The effectiveness and robustness of the VIPS apparatus control are shown by numerical examples with model systems including a large-scale power system.     

Tunable laser for sensing atmospheric transmission in the infrared region of 11 ∼ 16 µm

We succeeded in observing the continuously tunable, pulsed InSb SFR (Spin-Flip Raman) laser emission in the infrared region of 11～16µm (11.4～16.3µm) from only one InSb device, merely by adjusting the pumping wavelength (11 lines from the infrared NH₃ laser) and the applied magnetic field (0～80 kGauss).     

Percutaneous lumbar nucleotomy

The nature of the events whereby the reactive intermediates resulting from the bioactivation of bromobenzene and furosemide induce hepatotoxicity is unknown. To examine a role for disturbances in intracellular calcium homeostasis, secondary to a depletion in cellular reduced glutathione (GSH) and reduced protein thiols (PSHs), isolated mouse hepatocytes were exposed to cytotoxic concentrations of bromobenzene or furosemide. Cytosolic calcium concentration, as well as thiol status, was determined. The incubation of hepatocytes with 3.0 mM bromobenzene, and subsequent additions (1.2 mM) of the agent every hour, resulted in significant GSH depletion. The loss of plasma membrane integrity at 1.5 h preceded both a rise in the cytosolic Ca2+ concentration and depletion of total PSH content. Furosemide (1.0 mM) produced a 70% depletion in cellular GSH content in isolated hepatocytes. The initiation of cell damage occurred concurrently with both a rise in the cytosolic Ca2+ concentration and a depletion of total PSH content 4 h following furosemide addition. Since the increase in cytosolic Ca2+ did not precede cytotoxicity, these results do not support an initiating role for Ca2+ deregulation in bromobenzene and furosemide hepatotoxicities. In addition, depletion of PSH content did not correlate with bromobenzene- or furosemide-induced cytotoxicity.     

OSP-P200最新开放式数控系统

上世纪90年代末，受到以国际互联网为代表的信息技术革命的影响，制造业为了构筑新的生产方法，开始引入各种信息技术工具。这是为了满足消费者品种多样化和个性化的需求，以大量生产为主的产品导向模式（Product Out）向多品种小批量的市场导向模式（Marketin）的变化为目的，充分利用信息技术和设计制造知识，更加快速和低价地向市场提供各种高附加价值产品。     

Elevated expression of epidermal ornithine decarboxylase mRNA in scleroderma

Using in situ hybridization techniques, we examined the expression of ornithine decarboxylase (ODC) mRNA in the skin of five patients with systemic sclerosis (SSc) and five normal controls. Sections treated with an anti-sense probe showed concentrated grains exclusively in the epidermis of SSc patients, but not in that of normal controls. Because our subcloned anti-sense probe specifically hybridizes with ODC mRNA, these findings indicate that the expression of ODC mRNA is elevated in SSc epidermis. Possibly polyamines have an important part to play in the skin changes of SSc.     

Fate of the chlorine and fluorine in a sub-bituminous coal during pyrolysis and gasification

The fate of the chlorine and fluorine present in a sub-bituminous coal from Indonesia during pyrolysis and gasification has been studied with fixed and entrained bed reactors. The rate profile for HCl evolved in the temperature programmed pyrolysis exhibits the main and shoulder peaks at 480 and 600 °C, respectively. Model experiments and subsequent Cl 2p XPS measurements show that HCl reacts with metal impurities and carbon active sites at 500 °C to be retained as inorganic and organic chlorine forms, from which HCl evolves again at elevated temperatures. It is suggested that the HCl observed in the coal pyrolysis may originate from the above-mentioned chlorine functionalities formed by secondary reactions involving the nascent char. In the CO₂ gasification of the 900 °C char at 1000 °C and 2.5 MPa, any measurable amounts of HCl and HF could not be detected even at a high conversion of 75 wt% (daf), suggesting the accumulation of these halogens in the residual char. When the coal is injected into an O₂-blown, entrained bed gasifier at 1200-1400 °C under 2.6 MPa, the partial oxidation proceeds to a larger extent at a higher O₂/coal ratio, whereas the chlorine and fluorine are enriched in the remaining char, and the extent of the enrichment at the latter stage of gasification is larger with the fluorine. The XPS measurements of the chars reveal the presence of the broad F 1 s peak, which can cover a wide range of binding energies attributable to inorganic and organic fluorine. The halogen enrichment during gasification is discussed in terms of secondary reactions of HCl and HF with char.     

Effect of alkali and alkaline earth metals on nitrogen release during temperature programmed pyrolysis of coal

Formation of HCN, NH₃, and N₂ during fixed-bed pyrolysis at 10K min⁻¹ has been studied using coal samples after partial demineralization followed by addition of metal hydroxides from aqueous systems. Without additives, NH₃ is the predominant product at ≤ 700°C, showing the two peaks in the formation rate profile, whereas N₂ is the only product at ≥ 800°C. The presence of NaOH, KOH and Ca(OH)₂ promotes considerable NH₃ formation between 450 and 600°C, but in contrast suppresses HCN formation in this region. The Ca shows the largest effect on both the promotion and suppression. It is likely that the NH₃ increased by Ca addition arises partly from HCN, but mainly from secondary reactions of tar-N. These hydroxides affect N₂ formation in quite different manners: the Na decreases the rate between 700 and 950°C, and the K changes it less significantly than the Na, but the Ca remarkably increases the rate in a low temperature region of 550–700°C. These different features are discussed in terms of solid-phase reactions of alkali metal carbonates with char-N and secondary decomposition reactions of tar-N on CaO particles. As a result, total conversion of coal-N to HCN, NH₃ and N₂ up to 1000°C increases in the sequence of Na < none < K < Ca.     

Synthesis and electrode performance of layered nickel dioxide containing alkaline ions

Several polymorphs of layered nickel dioxide were prepared by using the chemical insertion of alkaline ions into Li_0.10NiO₂. We used aqueous AOH (A = Li, Na, K) solutions as reducing agents. Sodium and potassium insertion resulted in hydrated layered compounds that can be classified as γ-NiOOH with high crystallinity, while lithium insertion occurred without hydration. We discuss the coordination environment around the A⁺ ions for these inserted compounds. The thermal behavior, analyzed using high temperature (HT) X-ray diffraction (XRD) and thermogravimetric (TG) measurements, indicated that heating the hydrate at 150 °C yielded its dehydrate. The electrode performance of the nickelate was studied in lithium cells. We discuss the effect of interlayer water on cell rechargeability and the similarity between these nickelate and hydrated manganese dioxide (birnessite).     

Effect of inorganic salt on adsorption of sodium alkyl sulfates and fatty acid sodium salts from aqueous solution onto ion exchange resins

The adsorption isotherms of sodium salts of alkyl sulfonic acid and fatty acid with various carbon numbers onto ion exchange resins were measured in the absence and in the presence of sodium chloride in aqueous solutions. In the absence of the inorganic salt, the amount of adsorption remarkably increased with an increase in the length of alkyl groups in the adsorbates. Furthermore, the amount of adsorption apparently decreased with addition of sodium chloride into the solutions and almost reached a constant value at high concentrations of NaCl. This behavior strongly suggested that the electrostatic interaction on the adsorption decreased with increasing salt concentration and that the effect of hydrophobic interaction seems to play an important role on adsorption.