塔里木盆地雅—轮地区断层封堵性研究

塔里木盆地雅—轮地区大部分圈闭及油气藏的形成与断裂作用密切相关,对断层封堵性的综合研究已成为该地区油气勘探的重要因素。应用地质定性分析、Allen剖面分析及断层涂抹量计算等方法,通过对研究区4个典型断层封堵油气藏的系统解剖研究,建立雅—轮地区断裂封堵性评价标准,对雅—轮地区断层的封堵性进行综合评价。雅—轮地区断层整体封堵效果良好,断层在圈闭形成和油气聚集过程中起着重要的控制作用,形成一系列沿断层带状分布的油气藏。亚南断裂的封堵效果东部要优于西部,下部要优于上部。轮台断裂在不同部位、不同深度均存在着不同的封堵性能,封堵非均质性明显,总体显示断裂东部地区(也根附近)的封堵性要好于西部雅南地区。      

琼北福山凹陷大地电磁测深资料地质解释

根据琼北福山凹陷两条大地电磁测深试验剖面，可将凹陷自上而下分为５个电性层，并确定其对应的地质属性。利用大地电磁测深资料可以确定断层和局部构造。文中通过试验说明大地电磁测深法的正确性和可行性。     

在协议集成测试系统上开展路由协议测试

在分析路由协议的特性及其测试需求的基础上，提出利用窗口黑盒来描述被测协议，利用多通道测试方法扩展对被测实现的控制和观察，通过扩充参考实现增强系统的测试能力。将这些理论，技术应用于系统中，对路由协议开展了有效的测试活动，为国产高性能路由器的开发提供了有力的支持，也进一步增强了PITS系统的功能和适用性。     

Strengthening of Preloaded RC Beams Using Hybrid Carbon Sheets

Reinforced concrete (RC) beams subject to service loads of 40 or 60% of steel yielding were strengthened using hybrid continuous carbon fiber sheets. The hybrid systems were made of high-strength and high-modulus carbon sheets, and compared with systems using only high-strength carbon. It was found that the use of high-modulus carbon sheets in hybrid systems could increase the yielding load, the flexural stiffness, the postyielding ductility, and reduce the crack opening in concrete. The slope changes on load-deflection curves at steel yielding are not noticeable in hybrid systems. The tensile strains developed in hybrid sheets after the fracture of high-modulus carbon are higher in magnitude and distributed in a larger area, leading to an ultimate carbon fracture with concrete crushing. These unique features are attributed to the high stiffness and low ultimate tensile strain of the high-modulus carbon fibers which stiffen the structures, avoid or delay the fiber-reinforced polymer debonding, and facilitate the deformability during their subsequent breakdown.     

大江河口三维非线性斜压水流盐度数学模型

本文建立了河口三维非线性斜压水流盐度数学模型。该模型通过。坐标变换，使整个水域垂直方向可采用相同的分层。基于过程分裂法，将三维流动分成表面重力波（外模式）和内重力波（肉模式）。外模式采用改进型双步全隐有限差分DSI法进行计算，内模式利用欧拉-拉格朗日公式，改进三维垂直方向隐式格式，减小了数值耗数，提高了计算精度及稳定性。该模型应用于长江口三维盐水入侵计算，结果表明水流盐度分布与实测一致。     

Hydrogen Reduction and Microstructural Changes of ISF Sinter

The reduction rate and microstructural changes of imperial smelting furnace (ISF) sinter have been investigated by means of thermogravimetric analysis, X-ray difFraction (XRD), scanning electron microscope (SEM ), energy dispersive analysis of X-ray (EDAX) and optical microscope.It is demonstrated that the overall reaction rate of the reduction is influenced by temperature and hydrogen partial pressure in H2 /N2 gas mixtures. There are two distinct zones observed in the partially reduced sinter. The reduction of zincite proceeds predominantly in a narrow range between the two zones, while the reduction of tead oxide and silicate takes place throughout the sinter. The differences between zincite and lead oxide or silicate in reducibility are analysed by thermodynamlcs. The phase transformations and microstructural changes occurring during the reduction process are discussed     

Analysis of the detectivity for triple-layer heterojunction GaSb/GaInAsSb infrared detectors

In this paper, the detectivity is calculated and analyzed with the front-or backside illuminated case for both N-GaSb/p₂-Ga_0.8In_0.2As_0.19Sb_0.81/p₁-Ga_0.9In_0.1As_0.09Sb_0.91 and N₁-GaSb/n₂-Ga_0.9In_0.1As_0.09Sb_0.91/p-Ga_0.8In_0.2As_0.19Sb_0.81 infrared photovoltaic detectors, respectively. The analysis results show that the main absorption appears in the p-type Ga_0.8In_0.2As_0.19Sb_0.81 material with either front- or backside illuminated case for above two structures. In each structure, the carrier concentration obviously affects the detectivity. The carrier concentration in the wide-bandgap material for the isotype heterojunction should be reduced as low as possible to reduce the tunneling rate at the isotype heterointerface. Moreover, the change of the detectivity with the p-side surface recombination velocity for the N₁-n₂-p structure is more sensitive than that with the p₁-side surface recombination velocity for the N-p₂-p₁ structure. In the N-p₂-p₁ structure with the incident light from the p₁-side surface, two-color detection is achieved.     

基于雅可比矩阵的电压控制区域划分的改进

对应用比较广泛的电压控制区域（VCA）划分方法进行了改进，在传统的去除小元素法基础上，采用牛顿 — 拉夫逊法潮流雅可比矩阵中有功和无功对电压幅值偏导数的子矩阵之和进行VCA划分;然后，将各种拓扑变化对系统电压稳定性的影响进行排序，按从大到小的顺序用这些拓扑变化对得到的VCA分区进行修正，直到修正结果不再改变为止，从而得到了适用于各种拓扑结构下电压稳定性分析的分区。改进后分区的有效性在新英格兰10机39节点系统上得到了验证。     

Kerr型介质界面上弱非线性TM表面波的传播特性

本文研究Ｋｅｒｒ型介质界面上弱非线性ＴＭ表面波的性质。数值计算表明了沿线性与非线性介质界面传播的ＴＭ表面波的自散焦特性。