New method for selective growth of diamonds by microwave plasma chemical vapour deposition

Selective nucleation and deposition of diamonds were achieved on an SiO₂-patterned Si substrate. The substrate was pre-treated with an electric field in plasma to introduce diamond nuclei. This treatment did not affect the SiO₂ area. Consequently, diamonds grew only on the area where Si was exposed under the conventional conditions of diamond growth. The maximum nucleation density on the area of SiO₂was about 5 × 10⁷ cm⁻². The ratio of the selectivity was 2 × 10² or higher. This process will be useful and very promising for manufacturing diamond electronic devices.     

Effect of EFA deficiency on lipid transport from liver

Studies are reported of the effect of an essential fatty acid (EFA) deficiency on synthesis of triglycerides (TG) and phospholipids (PL) and secretion of these compounds by livers of male Sprague-Dawley rats. Animals were fed a semipurified diet containing corn oil or hydrogenated coconut oil (HCO) as the sole source of fat or no fat from weaning to 20 weeks of age. Liver function of the animals in each group was compared by an isolated liver perfusion technique with perfusates containing erythrocytes and linoleate, and in vivo experiments via tail vein injection of palmitate-³H. Perfusion experiments showed that an EFA deficiency reduced the ability of the liver to secrete TG and PL. Accumulation of TG in the liver and its diminished secretion into the blood of EFA deficient animals were demonstrated by in vivo experiments with palmitate-³H. The rate of conversion of linoleate to arachidonate and synthesis of PL was greater in livers of EFA deficient rats than in the control, corn oil fed animals. The results suggest a relationship of EFA metabolism to lipid transport. One of five papers to be published from the Symposium “Lipid Transport” presented at the AOCS Meeting, New Orleans, April 1970.     

Hot-water treatment of sol–gel derived SiO2–TiO2 microparticles and application to electrophoretic deposition for thick films

SiO₂–TiO₂ spherical microparticles of about 0.7 μm in diameter were prepared by the sol–gel method. Anatase nanocrystals were formed in the microparticles and their specific surface area was increased after a hot-water treatment at 90 °C. From the changes in the concentration of I₂ photocatalytically generated from KI aqueous solution, the activity of the SiO₂–TiO₂ microparticles was found to increase with increasing the hot-water treatment time. Particulate, thick films were electrophoretically deposited on indium tin oxide (ITO)-coated glass substrates using the anatase nanocrystal-precipitated SiO₂–TiO₂ microparticles. The thickness of the electrophoretically deposited particulate film increased to be approximately 10 μm with an increase in applied voltage. The resultant thick film showed a high photocatalytic activity.     

WO3/BiVO4 composite photoelectrode prepared by improved auto-combustion method for highly efficient water splitting

We report on the improvement in the water splitting efficiency of a WO₃/BiVO₄ composite photoelectrode by the application of an improved auto-combustion method to the preparation of porous BiVO₄ thin films. The unique feature of this preparation method is the addition of both NH₄NO₃, as a strong oxidizing agent, and an organic additive into BiVO₄ precursor solution. The local decomposition heat of the organic additive and oxidizing agent created a porous film with small, highly crystalline BiVO₄ particles. The photoelectrode has many advantages over existing ones, such as the high light-harvesting efficiency (LHE), a single BiVO₄ phase, the facile access of the holes to the photoelectrode/electrolyte interface, and the ease of water and oxygen diffusion. The maximum incident photon-to-current efficiency (IPCE) was estimated to be 64% (at 440 nm, 1.23 V vs. RHE) and the applied bias photon-tocurrent efficiency (ABPE) reached as high as 1.28%. This ABPE value is highest among all oxide semiconductor photoelectrodes reported previously, except for the case of a stacking photoelectrode system.     

Deposition of Lead Phosphate by Lead-Tolerant Bacteria Isolated from Fresh Water near an Abandoned Mine

Specialist bacteria can synthesize nanoparticles from various metal ions in solution. Metal recovery with high efficiency can be achieved by metal-tolerant microorganisms that proliferate in a concentrated metal solution. In this study, we isolated bacteria (Pseudomonas sp. strain KKY-29) from a bacterial library collected from water near an abandoned mine in Komatsu City, Ishikawa Prefecture, Japan. KKY-29 was maintained in nutrient medium with lead acetate and synthesized hydrocerussite and pyromorphite nanoparticles inside the cell; KKY-29 also survived nanoparticle synthesis. Quantitative PCR analysis of genes related to phosphate metabolism showed that KKY-29 decomposed organic phosphorus to synthesize lead phosphate. KKY-29 also deposited various metal ions and synthesized metal nanoparticles when incubated in various metal salt solutions other than lead. The present study considers the development of biotechnology to recover lead as an economically valuable material.     

Lower Tropospheric Aerosol Measurements by MAX-DOAS During Severe Asian Dust Period

A recently developed aerosol retrieval algorithm based on O₄ slant column densities (SCDs) measured at a visible wavelength (476 nm) was utilized to derive aerosol information (e.g., aerosol optical depth (AOD) and vertical distributions of aerosol extinction coefficients (AECs)) in the lower troposphere during a severe Asian dust period. The MAX-DOAS measurements were carried out at Gwangju, Korea for nearly three months from February through May 2008. Comparison with AOD and surface PM₁₀, measured by collocated sunphotometer and beta gauge sampler, were made to validate the retrieved AODs and AECs in the atmospheric layer surface to 1 km height above ground. On the Asian dust days, temporal variations of the AODs retrieved from MAX-DOAS measurements show similar patterns, but with reduced magnitudes, to those measured by sunphotometer whereas similar AOD magnitude and temporal variation was observed between MAX-DOAS and sunphotometer measurements during the non-episodic days. Smaller correlation was observed between the surface PM₁₀ and AECs at 0.5 km during the Asian dust period compared to the correlation obtained for the non episodic days. This study demonstrates the ability of MAX-DOAS as a remote sensing technique for surface aerosol measurements under conditions of homogeneously distributed pollution in the planetary boundary layer. However, for the measurement of significantly enhanced aerosol loads with heterogeneous vertical distribution (e.g., Asian dust), measured AODs and AECs are underestimated at altitudes above 1 km due to decreased sensitivity of MAX-DOAS measurements at high altitudes.     

Examining corporate reputation judgments with generalizability theory.

The researchers used generalizability theory to examine whether reputation judgments about corporations function in a manner consistent with contemporary theory in the corporate-reputation literature. University professors (n = 86) of finance, marketing, and human resources management made repeated judgments about the general reputations of highly visible American companies. Minimal variability in the judgments is explained by items, time, persons, and field of specialization. Moreover, experts from the different specializations reveal considerable agreement in how they weigh different aspects of corporate performance in arriving at their global reputation judgments. The results generally support the theory of the reputation construct and suggest that stable estimates of global reputation can be achieved with a small number of items and experts. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

An aqueous suspension system for phospholipase D-mediated synthesis of PS without toxic organic solvent

Enzymatic synthesis of PS by phospholipase D (PLD)-mediated transphosphatidylation in an aqueous media was investigated. The purpose of this study was to establish a novel synthetic method where no toxic organic solvents were used. An attempt to react soybean lecithin (simply dispersed in an aqueous buffer) with an aqueous solution of l-serine and PLD was unsuccessful, giving only 20% of PS. By contrast, a suspension of lecithin adsorbed on fine powders such as silica was effectively converted into PS in an aqueous solution of l-serine and PLD. After screening various powders for use as the lecithin adsorbent, calcium sulfate was found to be the best with respect to lecithin conversion. In addition, calcium sulfate did not require prior adsorption of lecithin (i.e., the reaction proceeded effectively simply by adding the powder to an aqueous mixture of lecithin, l-serine, and PLD). With this “aqueous suspension system” of calcium sulfate, up to 180 mg/mL lecithin was completely converted, resulting in more than 80% PS in 24 h. The synthesized PS could easily be recovered from the powder by extracting with a mixture of n-hexane, ethanol, and diluted HCl.     

A multilevel PWM strategy suitable for high‐voltage motor direct drive systems with consideration of the adverse effect of dead time

Recently, high‐voltage motor direct drive systems have been put to practical use, and various multilevel PWM strategies have also been proposed. This paper describes a multilevel PWM strategy [our group calls it the Carrier Phase Selection Method (CPS)] that has the lowest line voltage harmonic distortion in order to prevent the degradation of high‐voltage motor winding insulations. This method takes the adverse effect of dead time into consideration, and it controls the shift direction of a carrier phase. Therefore, a favorable output waveform without instantaneous voltage surges is achieved even if the line voltage level changes. Moreover, the switching transitions across all switching devices are well‐balanced, so the utilization of inverter unit cells is equalized. This is an important factor when designing the entire system. Based on simulation and experimental results, it is shown that this CPS method is particularly effective in high‐voltage motor direct drive systems. © 2008 Wiley Periodicals, Inc. Electr Eng Jpn, 165(2): 77–88, 2008; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20474