A CMOS multichannel 10-Gb/s transceiver

We describe a CMOS multichannel transceiver that transmits and receives 10 Gb/s per channel over balanced copper media. The transceiver consists of two identical 10-Gb/s modules. Each module operates off a single 1.2-V supply and has a single 5-GHz phase-locked loop to supply a reference clock to two transmitter (Tx) channels and two receiver (Rx) channels. To track the input-signal phase, the Rx channel has a clock recovery unit (CRU), which uses a phase-interpolator-based timing generator and digital loop filter. The CRU can adjust the recovered clock phase with a resolution of 1.56 ps. Two sets of two-channel transceiver units were fabricated in 0.11-/spl mu/m CMOS on a single test chip. The transceiver unit size was 1.6 mm /spl times/ 2.6 mm. The Rx sensitivity was 120-mVp-p differential with a 70-ps phase margin for a common-mode voltage ranging from 0.6 to 1.0 V. The evaluated jitter tolerance curve met the OC-192 specification.     

Eosinophil chemotaxis induced by several biologically active substances and the effects of apafant on it in vitro

Chemotaxis of guinea pig eosinophils induced by various stimuli in use of a modified Boyden chamber technique in vitro and the effect of a platelet-activating factor (PAF) antagonist, apafant (CAS 105219-56-5, WEB 2086 BS), on it were examined. The eosinophils were obtained by bronchoalveolar lavage from the animals treated by i.v. injection with Sephadex G-200 and purified by Percoll density gradient centrifugation. PAF significantly and potently induced the chemotaxis at a broad range of 10(-17) to 10(-7) mol/l, where no concentration-dependency was observed. Leukotriene B4 also induced the chemotaxis in a concentration-dependent manner at 10(-14) to 10(-12) mol/l and the enhanced migration was not declined until 10(-7) mol/l. Interleukin-5 (IL-5), IL-8 and regulated on activation normal T expressed and secreted (RANTES) only modestly enhanced the chemotaxis in some concentrations at 10(-13) to 10(-7) mol/l with or without significance and with no concentration-dependency while formyl-methionyl-leucyl-phenylalanine (FMLP), a known chemoattractant, increased the migration at 10(-7) to 10(-5) mol/l. Apafant at 10(-8) to 10(-6) mol/l strongly and concentration-dependently inhibited 10(-8) mol/l PAF-induced chemotaxis. However, the drug showed nominal or no influences on their chemotaxis stimulated by the other agonists, at the concentrations of which the enhanced migration was observed. From these results, it is concluded that IL-5, IL-8 and RANTES, different from PAF and LTB4, are not potent stimuli for the eosinophil chemotaxis and that apafant is a selective antagonist of PAF, which is expected to be therapeutically effective for PAF-associated diseases including bronchial asthma.     

KGa-priderite and related compound for the selective reduction of nitrogen monoxide with propylene

The catalytic activity of KGa-priderite, K_1.6Ga_1.6Ti_6.4O₁₆, and its related compound KGa₈Ga₉Ti₁₅O₅₆ was investigated for the selective reduction of nitrogen monoxide (NO) with propylene (C₃H₆) in the presence of high oxygen concentrations. The KGa-priderite showed significant activity during this reaction, but the related compound showed only a little activity. These compounds are quite different from the conventional catalysts for NO_x selective reduction and are characterized by the fact that their properties are free from the effects of solid acidity and support metals. This difference was attributable to the NO desorption rate at the surface of these compounds. It has become clear that the KGa-priderite catalyst remarkably adsorbed NO, and it is suggested that the amount of NO adsorbed and the amount of catalytic activity are able to be increased by the design of priderite structure.     

Thermal response in thermal energy storage material around heat transfer tubes: effect of additives on heat transfer rates

The effects of carbon-fiber chips and carbon brushes as additives on the thermal conductivity enhancement of phase change materials (PCMs) using in latent heat thermal energy storage are investigated experimentally and numerically by considering the wall effect of the additives. The carbon-fiber chips are effective for improving the heat transfer rate in PCMs. However, the thermal resistance near the heat transfer surface is higher than that for the carbon brushes. As a result, the overall heat transfer rate for the fiber chips is lower than that for the carbon brushes. Consequently, the carbon brushes are superior to the fiber chips for the thermal conductivity enhancement under the present experimental conditions. The carbon brushes are moreover applied to the packed beds of particles to overcome their low thermal conductivity in chemical heat pump/storage. The carbon brushes essentially improve the heat transfer characteristics in the packed beds, though the thermal resistance is observed because the particles obstruct contact between the fibers and the heat transfer surfaces.     

Non-linear current–voltage characteristics related to native defects in SrTiO3 and ZnO bicrystals

SrTiO₃ and ZnO bicrystals with various types of boundaries were fabricated in order to examine their current–voltage characteristics across single grain boundaries. Their grain boundary structures were also investigated by high-resolution transmission electron microscopy. In Nb-doped SrTiO₃, electron transport behaviors depend on the type of boundaries. Random type boundaries exhibit highly non-linear current–voltage characteristics, while low angle boundaries show a slight non-linearity. On the contrary, undoped ZnO does not exhibit non-linear current–voltage characteristics in any type of boundaries including random ones. It is suggested that the differences observed in current–voltage properties between the two systems are mainly due to the difference in the accumulation behavior of acceptor-like native defects at grain boundaries. A clear non-linearity is obtained by means of Co-doping even for the highly coherent Σ1 boundary in a ZnO bicrystal. This is considered to result from the production of acceptor-like native defects by Co-doping.     

Physical and functional association of cortactin with Syk in human leukemic cell line K562

Human leukemic cell line K562 is induced to differentiate into the megakaryocytic lineage by stimulation with 12-O-tetradecanoylphorbol-13-acetate (TPA). We demonstrate here that TPA stimulation increases tyrosine phosphorylation of an 80-kDa protein at an early stage of megakaryocytic differentiation and that this 80-kDa protein is identical with cortactin. Since tyrosine kinase Syk was activated by TPA stimulation, we examined the possibility that cortactin is a potential substrate of Syk in K562 cells. TPA-induced tyrosine phosphorylation of cortactin was decreased profoundly by overexpression of dominant-negative Syk. Furthermore, cortactin was associated with Syk even before TPA stimulation. Since cortactin was previously referred as an 80/85-kilodalton pp60src substrate, we examined the association between Src and cortactin, whereas its association could not be detected. These data suggest that Syk phosphorylates cortactin in K562 cells upon TPA treatment.     

A broadband power meter calibration system in the frequency rangefrom 10 MHz to 40 GHz using a coaxial calorimeter

A broadband power meter calibration system based on a newly constructed coaxial calorimeter has been developed in the frequency region 10 MHz-40 GHz. The RF power is measured as the difference of DC power supplied to the calorimeter built-in heater in the RF load, when RF is turned off and on, holding an isothermal control between the RF load and a temperature reference. To minimize the error due to the adiabatic coaxial waveguide, we devised a new method utilizing its output port as a test port. The evaluations showed a calibration uncertainty of (0.28-2.2)% expressed by one standard deviation at the 1 mW level in the full band