Inhibition of radical polymerization in solvent‐based systems (security of solvent‐based radical polymerization of PSA‐acrylic in a plant reactor)

This article shows the influence of some chain‐transfer agents as inhibitors for acrylic solvent‐based polymerization. These chain‐transfer agents can offer significant advantages, as outlined below. The following chain‐transfer agents were studied to stop or slow down the polymerization process in the case of a runaway: n‐dodecyl mercaptan, trimethylolpropane‐trimercaptoacetate, phenothiazine, diphenylphenylen diamine, cuprum oxide, isopropanol, toluene, and carbon tetrachloride. Synthesized pressure‐sensitive adhesive based on acrylic polymers and containing 2‐ethylhexyl acrylate, methyl acrylate, and acrylic acid were used for the production of self‐adhesives with high cohesion. The polymerization was accomplished in ethyl acetate. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 87: 1354–1357, 2003     

A comparison of the3He melting curve,T c(P) curve,and the susceptibility of lanthanum-diluted cerium magnesium nitrate below 50 mK

The ac susceptibility of lanthanum-diluted cerium magnesium nitrate has been compared to the temperature scales as derived from the (P, T) relation determined by Halperin and that was measured recently by Greywall. It is found that the susceptibility does not obey a simple Curie-Weiss law over the temperature range between 1 and 50 mK. The results of these calibrations are also used to determine the temperatures for the second-order phase transitions into the superfluid phases of³He at several pressures. TheseT _c(P) values are compared to results of earlier experiments that used thermometry based on the susceptibility of platinum as well as other thermometry techniques.     

Primary hybrid total hip arthroplasty: an interim followup

The senior authors' initial experience with primary hybrid hip replacement in patients with osteoarthritis was studied to evaluate the efficacy of the procedure. Hybrid total hip arthroplasty (uncemented Harris-Galante acetabular component and cemented Iowa precoated femoral component) was performed in 131 consecutive, nonselected hips in 118 patients with the diagnosis of primary osteoarthritis. Followup was performed at 8 to 9 years after the procedure. The average age at the time of the procedure was 68 years (range, 45-87 years). There were 50 men (55 hips) and 68 women (76 hips). At final followup 19 patients (22 hips) had died. The femoral component had been revised for aseptic loosening in 8 hips (6.1%). One additional hip showed definite radiographic loosening. Hence, the prevalence of radiographic femoral failure was 6.9% (9 hips). No acetabular component had been revised for aseptic loosening and no acetabular component had migrated. The senior author continues to perform hybrid total hip arthroplasty in all patients with primary osteoarthritis. However, design modifications have been made in the femoral component that is used.     

Inhibition of nitrification in the packed bed reactors by selected organic compounds

The effect of methanol, acetone, formalin and glucose on the nitrification process in the packed bed reactors has been investigated. For the utilized compounds the inhibition constant K_i was determined according to Dixon's method. The determined values were as follows: methanol K_i = 116.0 mg l^?1; acetone K_i = 804.2 mg l^?1; formalin K_i = 61.5 mg l^?1. The value of K_i for glucose has not been determined because glucose in applied concentration up to 11,325 mg l^?1 had no effect on the nitrification course.     

Characterization of supported Pd-Pt catalysts by chemical probes

The temperature programmed (palladium) hydride decomposition appeared very effective method for diagnosing the extent of alloying in Pd-Pt/SiO₂ catalysts. Introduction of Pt to Pd catalysts moves the TPHD peak gradually towards lower temperatures and the shift in hydride decomposition peak is accompanied by a decrease in the amount of released hydrogen. The catalysts prepared the direct redox method showed much better alloy homogeneity than the samples prepared by coimpregnation. The results of probing with other techniques, i.e. catalytic probing with hydrodechlorination of CCl₂F₂ and XRD, were in line with TPHD data. The catalytic probing showed the presence of synergistic effect, a clear indication of Pd-Pt mixing. XRD data of post-reaction samples showed carbon incorporation into Pd-rich phase, whereas separate Pt-rich phase did not experience any bulk carbiding.     

Charnley total hip arthroplasty in patients less than fifty years old. A twenty to twenty-five-year follow-up note

We evaluated the results twenty to twenty-five years after ninety-three consecutive, nonselected Charnley total hip arthroplasties performed with cement by the senior one of us in sixty-nine patients who were less than fifty years old at the time of the procedure. Seventy of the seventy-two hips in the living patients were followed radiographically for at least twenty years. Twenty-seven hips (29 per cent) had a revision or a resection of the prosthesis during the follow-up period. The revision or the resection was performed because of aseptic loosening in twenty-one hips (23 per cent), infection in four (4 per cent), dislocation in one (1 per cent), and fracture of the femur in one. Eighteen acetabular components (19 per cent) and five femoral components (5 per cent) were revised because of aseptic loosening, and an additional fourteen acetabular components (15 per cent) and seven femoral components (8 per cent) demonstrated definite or probable radiographic loosening. The present study demonstrates the long-term durability of total hip arthroplasty performed with cement in an active population of patients. The fixation of the femoral component was found to perform better than that of the acetabular component at twenty to twenty-five years after the procedure.     

Ion sputtering and its biomedical applications. Theoretical concepts and practical consequences. Clinical implications and potential use

It is the purpose of the paper to promote the ion beam sputtering technique and its biomedical applications among not only ion beam users but also other research workers, and especially, among biologists and medical doctors. The objectives of this article are threefold. Firstly, it supplies a conceptual background for discussing the main question of this work, i.e. biomedical applications of sputtering. Secondly, the title issue and some related problems, important in the biomedical use, are widely presented and discussed. Finally, clinical implication and potential applications are shown.