Replacement of beef fat in Frankfurters by interesterified palm,cottonseed and olive oils

Three interesterified vegetable oils (IVOs) prepared from palm, cottonseed, and olive oil, respectively, have been studied for application to Frankfurters. Beef fat (10%) was replaced by one of the IVOs at 20, 60 or 100%. Fatty acid composition of the lipid fraction in the Frankfurters and saturated/unsaturated ratios were established for all batches. We found that total or partial replacement of beef fat by IVOs did not lead to significant changes in appearance, colour, texture, flavour or sensory score. We conclude that IVOs may be successfully applied as beef fat substitutes in Frankfurters.     

Dissociation between the potency and reversibility of the insulinotropic action of two meglitinide analogues

The non-sulphonylurea hypoglycaemic agent repaglinide is about one order of magnitude less potent, in terms of insulinotropic efficiency, than S3075, another meglitinide analogue. In the present study, the effects of these two drugs upon 86Rb outflow, 45Ca efflux and insulin release from prelabelled rat pancreatic islets were investigated in a perifusion system. At a concentration of 10 microM, which is sufficient to evoke a maximal secretory response in incubated islets, both agents inhibited 86Rb efflux from islets perifused in the absence of D-glucose, and stimulated both 45Ca efflux and insulin release from islets perifused in the presence of 6 mM D-glucose. The stimulation of 45Ca efflux from prelabelled islets was suppressed in the absence of extracellular Ca2+. The cationic and secretory response to repaglinide differed, however, from that evoked by S3075, in persisting for at least 20 min after removal of the drug from the perifusion medium, whilst the changes in 86Rb outflow, 45Ca efflux and insulin release caused by S3075 were rapidly reversible. These findings indicate that there is no parallel between the insulinotropic efficiency of distinct meglitinide analogues, and the reversibility of their functional effects. Since a comparable dissociation was recently documented in the case of hypoglycaemic sulphonylureas, the present observations reinforce the view that distinct molecular determinants may rule the relative insulinotropic potency of sulphonylureas and structurally related meglitinide analogues, on one hand, and the reversibility of their biological action, on the other hand.     

Chebyshev wavelet collocation method for magnetohydrodynamic flow equations

This study proposes Chebyshev wavelet collocation method for partial differential equation and applies to solve magnetohydrodynamic (MHD) flow equations in a rectangular duct in the presence of transverse external oblique magnetic field. Approximate solutions of velocity and induced magnetic field are obtained for steady‐state, fully developed, incompressible flow for a conducting fluid inside the duct. Numerical results of the MHD flow problem show that the accuracy of proposed method is quite good even in the case of a small number of grid points. The results for velocity and induced magnetic field are visualized in terms of graphics for values of Hartmann number H_a ≤ 1000.

     

Robust control of variable speed autonomous underwater vehicle

Set point tracking control of autonomous underwater vehicle (AUV) via robust model predictive control (RMPC) is considered. Input-constrained RMPC with integral action, which has been developed in our previous work, is used to control the AUV in this study. In order to derive a RMPC control rule, non-linear dynamics of AUV with six degree of freedom is linearized at certain operating points. So, horizontal and vertical plane dynamics of system are represented by linear models which have polytopic uncertainties. Since the derived control rule will be used in real time, the computation time should be reduced. To overcome this computational time problem and get rid of trial–error step of Algorithm 1, a new algorithm is proposed here. The simulations are carried out using the control rule based on this algorithm and these results are presented.     

Performance evaluation of an importance sampling technique in a Jackson network

Importance sampling is a technique that is commonly used to speed up Monte Carlo simulation of rare events. However, little is known regarding the design of efficient importance sampling algorithms in the context of queueing networks. The standard approach, which simulates the system using an a priori fixed change of measure suggested by large deviation analysis, has been shown to fail in even the simplest network settings. Estimating probabilities associated with rare events has been a topic of great importance in queueing theory, and in applied probability at large. In this article, we analyse the performance of an importance sampling estimator for a rare event probability in a Jackson network. This article carries out strict deadlines to a two-node Jackson network with feedback whose arrival and service rates are modulated by an exogenous finite state Markov process. We have estimated the probability of network blocking for various sets of parameters, and also the probability of missing the deadline of customers for different loads and deadlines. We have finally shown that the probability of total population overflow may be affected by various deadline values, service rates and arrival rates.     

Degradation of 4-chloro-2-methylphenol in aqueous solution by electro-Fenton and photoelectro-Fenton processes

Degradation of 4-chloro-2-methylphenol (PCOC), a refractory toxic chemical emitted to the environment from the industrial production of phenoxy herbicides was studied in aqueous solution. Electro-Fenton and photoelectro-Fenton processes were used as the degradation methods. H₂O₂, produced by the reduction of oxygen at carbon cathode reacted with dissolved metal ions to form hydroxyl radicals, which in turn reacted with PCOC sequentially to degrade the aromatic ring. The effects of using different [Fe²⁺]/[PCOC]₀ and the effect of replacing Fe²⁺ by Mn²⁺ ion have been examined. It was found that degradation rate was increased with increasing [Fe²⁺]/[PCOC]₀ ratio from 2 to 4. However, the total charge utilized during the treatment was also increased. The efficiency of PCOC degradation was observed to be higher when Mn²⁺ was used as the catalyst. The mineralization of aqueous solutions of PCOC, withdrawn from the reactor at certain time interval, has been followed by total organic carbon (TOC) decay and dechlorination. A fast and complete degradation of the aromatic ring was achieved in photoelectro-Fenton system. 41.7% TOC decay and complete dechlorination were observed by consuming only 141.4 C electrical charge during a 300 min photoelectron-Fenton treatment. In the case of electro-Fenton system, 280.7 C electrical charge was consumed during 450 min of electrolysis to attain a similar degradation of PCOC. 14.9% TOC removal and 89.3% dechlorination have been obtained in this system under the applied conditions.     

Comparison of a sMBR and a CASP system for wastewater reclamation and re-use

The performance of a submerged membrane bioreactor (sMBR) for municipal wastewater reclamation and re-use was compared with that of a current classic activated sludge process (CASP). The average chemical oxygen demand (COD) of CASP effluent was 75 mg/l, while the average COD of sMBR filtrate was 15 mg/l. In general, COD removal was above 98%. However, the best results were obtained at a sludge rentention time (SRT) of 50 days. The total phosphorus (TP) content of the filtrate decreased to a level <1 mg/l under aerobic conditions in which aeration occurred continuously. It was shown that the filtrate TP and orthoposphate (Orto-P) concentrations increased dramatically during the periods of intermittent aeration because phosphorus is released under anoxic conditions. In the CASP effluent, the average TP and Orto-P were 7.9 mg/l and 7.1 mg/l, respectively. The filtrate was free of suspended solids (SS) and total coliform bacteria. The effluent SS in the CASP was 40 mg/l. The turbidity removal in the sMBR reached almost 99%, i.e. generally less than 1 NTU, while the average turbidity of the CASP effluent was almost 15 NTU. The removal of ammonium nitrogen (NH₄⁺-N) in the sMBR was almost 99.8%. In addition, the nitrate concentration in the filtrate decreased to 2.4 mg/l under both aerobic & anoxic conditions. It was shown that both nitrification and denitrification could be successfully reduced through intermittent aeration. Average total Kjeldehl nitrogen (TKN) and NH₄⁺-N in the CASP effluent were 30.2 mg/l and 20 mg/l, respectively, i.e. the nitrification efficiency was 42.9%, and the denitrification value was not available. When these results are compared with those in the CASP, it indicated that the sMBR could be successfully used for reclamation and re-use of municipal wastewater.     

Optimization of demand-related packaging sizes using a p-median approach

The determining of efficient packaging sizes is a key factor in saving material and transportation costs and also in reducing packaging waste. By analyzing the range of items and their contribution to sales-relevant order structures of a globally operating mail order company, a simplified packing algorithm is proposed. In combination with well-known methodologies, this heuristic provides near optimal solutions improving current packaging of eCommerce companies. It is shown that simple, practical heuristics are sufficient to achieve average material savings of more than 10 %. In order to find efficient packaging sizes, a set of them is generated by discretization of packaging dimensions. Given the set of orders and the set of packaging sizes, a p-median approach is applied to find a specified number of optimal, demand-related packaging sizes.     

Min-degree constrained minimum spanning tree problem: New formulation via Miller–Tucker–Zemlin constraints

Given an undirected network with positive edge costs and a positive integer $d>2$, the minimum-degree constrained minimum spanning tree problem is the problem of finding a spanning tree with minimum total cost such that each non-leaf node in the tree has a degree of at least $d$. This problem is new to the literature while the related problem with upper bound constraints on degrees is well studied. Mixed-integer programs proposed for either type of problem is composed, in general, of a tree-defining part and a degree-enforcing part. In our formulation of the minimum-degree constrained minimum spanning tree problem, the tree-defining part is based on the Miller–Tucker–Zemlin constraints while the only earlier paper available in the literature on this problem uses single and multi-commodity flow-based formulations that are well studied for the case of upper degree constraints. We propose a new set of constraints for the degree-enforcing part that lead to significantly better solution times than earlier approaches when used in conjunction with Miller–Tucker–Zemlin constraints.     

Fuzzy Bayesian reliability and availability analysis of production systems

To have effective production planning and control, it is necessary to calculate the reliability and availability of a production system as a whole. Considering only machine reliability in the calculations would most likely result unmet due dates. In this study, a new modelling approach for determining the reliability and availability of a production system is proposed by considering all the components of the system and their hierarchy in the system structure. Components of a production system are defined as production processes; components of the processes are defined as sub-processes. In this hierarchical structure we could model all kinds of failures such as material and supply, management and personnel, and machine and equipment. In the analysis, a fuzzy Bayesian method is used to quantify the uncertainties in the production environment. The suggested modelling approach is illustrated on an example. In the example, also a separate reliability and availability analysis is conducted which only considered machine failures, and the results of both analyses are compared.