裂缝性油气藏采收率：100个裂缝性油气田实例的经验总结

通过对世界上100个裂缝性油气藏的综合评价，研究储集层及流体本身的性质(包括孔隙度、渗透率、黏度、可动油比例、含水饱和度、润湿性及裂缝分布特征等)和驱动机制及油藏管理战略(优化日产量和采用不同类型的提高采收率技术)对其最终采收率的影响。将裂缝性油气藏分为4类：I类的基质几乎没有孔隙度和渗透率，裂缝是储存空间和流体流动的通道；Ⅱ类的基质有较低的孔隙度和渗透率，基质提供储存空间，裂缝提供流动通道；Ⅲ类(微孔隙)的基质具有高孔隙度和低渗透率，基质提供储存空间，裂缝提供流动通道；Ⅳ类(大孔隙)的基质具有高的孔隙度和渗透率，基质提供储存空间和流动通道，裂缝仅增加渗透率。对26个Ⅱ类油气藏和20个Ⅲ类油气藏的开采历史的研究表明：Ⅱ类油气藏的采收率受水驱强度和最优日产量控制，日产量过高会很容易破坏Ⅱ类油气藏，一些Ⅱ类油气藏如果管理得当，采收率可以很高，不需要二次或三次采油；Ⅲ类油气藏的采收率主要受岩石和流体本身性质的影响，特别是基质渗透率、流体重度、润湿性以及裂缝强度等，不进行二次或三次采油不可能完全开采，往往需要采用一些提高采收率的专门技术。以往将Ⅱ类和Ⅲ类裂缝性油气藏归为一类，认识它们的区别将有助于选择更好的开发策略。     

Effect of precyclic loading on stress-corrosion-cracking initiation in an X-65 pipeline steel exposed to near-neutral pH soil environment

A study was carried out to understand the effect of precyclic loading on stress-corrosion-crack initiation in an X-65 pipeline steel exposed to a near-neutral-pH soil environment. The test specimens were precyclically loaded before corrosion exposure to represent a service history of up to about 20 years, depending on the severity of pressure fluctuation. Microcracks had initiated on the polished surface of the X-65 pipeline steel after long-time exposure at open-circuit potential (OCP) in a near-neutral-pH synthetic soil solution. These microcracks were mostly initiated from pits at metallurgical discontinuities such as grain boundaries, pearlitic colonies, and banded phases in the steel. Strong preferential dissolution was observed along planes of the banded structures in the steel. The selective corrosion attack at these metallurgical discontinuities is attributed to the galvanic nature of those areas to their neighbors. Cyclic loading prior to corrosion exposure had significant effects on microcrack initiation and propagation during subsequent corrosion exposure. Cyclic loading prior to corrosion exposure either reduced or increased the probability of crack initiation and the rate of crack propagation, depending upon the magnitude of the stress cycles. The largest reduction was seen at a peak cyclic stress of about 0.8 of the yield strength. This cyclic-loading-dependent cracking behavior might be related to the alteration of the substructures and the residual stress in the steel as a result of precyclic loading.     

Effect of temperature on methyl radical generation over Sr/La2O3 catalysts

The role of gas phase CH₃ radicals in the oxidative coupling of CH₄ over 1 wt% Sr/La₂O₃ is supported by the observations that (i) this is a very effective catalyst for the generation of CH₃ · radicals and (ii) the concentration of CH₃ · radicals increases with temperature over the range of 450 °C–800 °C.     

FORUM for International Cooperation on Fire Research

The FORUM for International Cooperation on Fire Research is an informal group of people committed to fire research and the application of fire-research results. Since it was formed in 1988, the FORUM has brought together organizational leaders who direct resources for fire research throughout the world. This article is reprinted from the Nordic Fire Safety Engineering Symposium, Development and Verification of Tools for Performance Codes, August 30–September 1, 1993, in Espoo, Finland.     

A dynamic measure of order in structural glasses

Although some patterns of physical behavior are common in the glass transition and in the properties of supercooled liquids and glasses (characteristic viscoelasticity, temperature dependence of viscosity and relaxation times, property evolution through “physical aging”, difficulties in performing equilibrium measurements or simulations, etc.), it is difficult to arrive at a definition of the glass transition which distinguishes it from other phenomena exhibiting similar features. The present paper addresses this problem by defining a dynamical measure of order involving the average “shape” of particle trajectories in supercooled liquids. This dynamic order parameter should provide a measure of “closeness” to the glass transition and some indirect insights into the physical nature of supercooled liquids and glasses. Arguments are given that the proposed dynamic measure of order [“generalized capacity”, C(T)] is related to the temperature-dependent “effective hydrodynamic radius” R_H(T) measured in supercooled liquids and model numerical calculations are given to support this view. Some consequences of the intermittent particle motion at low temperatures for stress relaxation are also discussed.     

THE RECURSIVE FITTING OF SUBSET VARX MODELS

Abstract. A vector time series model of the form A(L)y(t) + B(L)x(t) =ε(t) is known as a vector autoregressive model with exogenous variables (VARX model) and involves a regressand vector y(t) and a regressor vector x(t). This paper provides a method for the recursive fitting of subset VARX models. It suggests the use of ascending recursions in conjunction with an order selection criterion to choose an 'optimum' subset VARX model.     

Solvent fractionation of petroleum pitch for mesophase formation

Petroleum pitch (Ashland A240) has been subjected to thermal treatment and solvent fractionation to produce refined pitches to be evaluated as impregnants for C-C composites. The solvent fractions were obtained by sequential Soxhlet extraction with solvents such as hexane, benzene, and pyridine. Thermal treatment to 408 °C produced a mesophase pitch (≈50% mesophase); an appreciable portion of the mesophase was soluble in strong solvents. There were substantial differences in chemical composition and in pyrolysis behaviour of the fractions. As the depth of fraction increased, the pyrolysis yield and bloating increased, and the microstructure of the coke became finer until glassy microconstituents were formed in the deepest fractions.     

Study of the Interfacial Reaction of Styrene/Maleic Anhydride Copolymerand (Amine)-Terminated Butadiene-Acrylonitrile Copolymer Using FTIR Imaging Techniques

The interfacial reaction between styrene/maleic anhydride copolymer (SMA) and amine-terminated butadiene-acrylonitrile copolymer (ATBA) was observed using Fourier transform infrared (FTIR) imaging spectroscopy. The anhydride and amine reacted to form an imide. Each component was detected using a characteristic wavenumber, which was 1601 cm -1 for SMA, 2237 cm -1 for ATBA, and 1701 cm -1 for the imide. FTIR images were taken as the reaction proceeded at 150, 160, 170, and 180°C. At low temperatures (150 and 160°C), diffusion-controlled kinetics were observed since interdiffusion between the reactants did not appear in the images. On the other hand, both the diffusion front and the reaction front are observed in the images at high reaction temperatures (170 and 180°C), which indicates that the kinetics became reaction-controlled rather than diffusion-controlled. Absorbance profiles were extracted from the images and used for the calculation of the extent of reaction. The data were analyzed using the Frederickson and Milner theory based on the assumption of diffusion-controlled kinetics, and this theory fit the low reaction temperature data.