Anomalies of the tracheobronchial tree in patients with esophageal atresia

Bone marrow examination revealed a lipid-laden histiocytosis in seven patients undergoing long-term total parenteral nutrition necessitated by extensive short-bowel surgical resection. Clinical abnormalities occurred during this treatment which required bone marrow examination. These included hepatosplenomegaly and peripheral blood cytopenia; the median time to the detection of these abnormalities was 64 months. The most striking change within the bone marrow was the presence of many pigment-laden histiocytes which had the typical morphology of sea-blue histiocytes seen in the so-called idiopathic sea-blue histiocyte syndrome. The occurrence of sea-blue histiocytosis in the bone marrow in association with long-term parenteral nutrition for short-bowel syndrome has not, to our knowledge, been reported previously and should now be considered in the differential diagnosis of bone marrow sea-blue histiocytosis.     

Characterization and electrochemical properties of CF4 plasma-treated boron-doped diamond surfaces

The effect of CF₄ plasma etching on diamond surfaces, with respect to treatment time, was investigated using scanning electron microscopy (SEM), Raman spectroscopy, X-ray photoelectron spectroscopy (XPS), and electrochemical measurements. SEM observations and Raman spectra indicated an increase in surface roughening on a scale of 10–20 nm, and an increase in crystal defect density was apparent with treatment time in the range of 10 s to 30 min. In contrast, alteration of the diamond surface terminations from oxygen to fluorine was found to be rather rapid, with saturation of the F/C atomic ratio estimated from XPS analysis after treatment durations of 1 min and more. The redox kinetics of Fe(CN)₆^3−/4− was also found to be significantly modified after 10 s of CF₄ plasma treatment. This behavior shows that C–F terminations predominantly affect the redox kinetics compared to the effect on the surface roughness and crystal defects. The double-layer capacitance (C_dl) of the electrolyte/CF₄ plasma-treated boron-doped diamond interface was found to show a minimum value at 1 min of treatment. These results indicate that a short-duration CF₄ plasma treatment is effective for the fabrication of fluorine-terminated diamond surfaces without undesirable surface damage.     

TRVs and fault clearing stresses in extra-high-voltage radial networks

To cope with the high rate of increase of power demand in the main industrialized districts in Japan, 550-kV transmission systems covering the districts have been reinforced, with most of the main power plants connected directly to these systems. Through 550-/300-kV substations, the majority of power to the districts is supplied by 300-kV systems. To limit the excess short-circuit capacity in the 300-kV systems, they tend to be reconstructed as so-called radial networks. In radial networks with high short-circuit capacity and relatively small number of transmission lines connected to the substation busbars, the rate of rise of TRV can be far higher than standard value. This paper analyzes the transient recovery voltages (TRV) in such extra-high-voltage radial networks in Japan, together with the relevant stresses to circuit-breakers during fault clearings. Future system conditions have also been introduced. As the typical rate of rise of the TRV values, more than twice that of today's standard ones are probable.     

Some experimental findings in compression-after-impact (CAI) tests of CF/PEEK (APC-2) and conventional CF/epoxy flat plates

Compression-after-impact (CAI) tests have been conducted for quasi-isotropic thick plates with 48 plies by using the NASA method and on plates with 32 plies by using the SACMA method. Specimens are made of CF/PEEK (APC-2) and conventional CF/epoxy for the NASA plates and CF/epoxy for the SACMA plates. In the NASA CAI tests, the sequence of delamination buckling and its propagation is clearly revealed through various experimental techniques. One major technique is moiré topography, and the other is thermo-mechanical stress analysis with a high-accuracy infrared sensor. The arrest of delamination propagation just before catastrophic failure due to high fracture toughness is clearly captured by the moiré camera. This behavior provides good CAI values of CF/PEEK. The initial buckling properties of the delaminated region by the impact are then extensively discussed. Numerical predictions of initial buckling stress have been obtained by modelled geometry of the delaminated region simplified from its precise structure clarified by ultrasonic C-scanning. They agree fairly well with the experimental results. The in-plane stress distribution in the delaminated region before initial buckling is measured by an infrared stress graphic system. This compared favorably with finite element predictions. Two types of symmetric buckling modes with respect to the central plate surface, twin and single peak ones, are experimentally captured.     

Disaccharide analysis of human skin glycosaminoglycans in sun-exposed and sun-protected skin of aged people

The negative conduction effect of quinidine on each of the successive phases of the ventricular depolarization was investigated using an original noninvasive method: the spatial velocity electrocardiogram of the QRS complex (SVECG-QRS). We performed a randomized placebo-controlled trial in 10 healthy subjects with a single oral dose of quinidine (330 mg) or placebo. Electrocardiographic acquisition and processing (220 recordings for the complete trial) were performed using the Lyon vectorcardiographic program. For each SVECG-QRS curve, the position of seven specific points from A (onset of QRS) to G (end of QRS) were determined precisely. The six successive time intervals between these points (AB-FG) and five velocity values (B-F) were then calculated. The QRS complex was longer under quinidine than placebo (102.4 +/- 1.6 vs. 100.3 +/- 1.5 ms). The difference was at the periphery of statistical significance (p = 0.05), and this lack of statistical difference may be mainly due to the low serum levels of quinidine obtained at the peak of the concentration (1.46 +/- 0.4 mg/1). All six QRS time intervals were longer under quinidine, but only the BC interval was significantly different (9.3 +/- 1.1 vs. 18.8 +/- 1.1 ms; p < 0.05) suggesting a more pronounced negative conduction effect at the onset of ventricular depolarization. No significant modifications were observed for the velocity values. We conclude that (1) the negative conduction effect of quinidine is heterogeneous, but a further study with a higher dose of quinidine (concentration-dependent effect) is required to confirm this hypothesis and (2) the spatial velocity electrocardiogram of the QRS complex allows a detailed analysis of the ventricular conduction phases. The results of the measurement were found to be reproducible. This noninvasive tool could be used in clinical practice to assess effects of antiarrhythmic drugs on successive ventricular depolarization phases.     

Stability of large-scale coal-fired MHD channels

Stability of large-scale coal-fired MHD channels is studied by (1) linearized stability analysis, and (2) time-dependent 1-D analysis. The channel length is 15 m with 600 electrode pairs, and the output power ranges from 220.6 MW through 258.7 MW. Linearized stability analyses show that the Faraday channels operated with fixed loading resistance are stable, whereas the two waves of u and u–a (u, a: gas and sound velocity) become unstable in the Faraday channel with fixed loading factor. Two waves of u and u–a are unstable in the diagonal channel with fixed loading current and the u + a wave becomes unstable in the diagonal channel with fixed electrode current. Time-dependent one-dimensional analyses indicate that the Faraday channels with fixed load resistance are smooth without growth of fluctuation. The diagonal channels with fixed electrode current are smooth with no fluctuation, though the linear theory indicates that the u + a wave is unstable. The diagonal channel with fixed load current suffers large disturbance along the latter half of the channel, being consistent with the linearized analysis which indicates that the u - a and u waves are unstable.     

Histo-pathological study of a glass-ionomer/resin (Geristore) restoration system

The purpose of this experiment was to investigate histo-pathologically the pulpal reaction to a glass-ionomer/resin (Geristore) restoration system in human teeth. Black's class I cavities were prepared in 22 human teeth; these were divided into 2 groups, one with the Geristore after cavity was cleaned with 10% NaOCl solution and 3% H2O2 solution (Group G) and the other with the Geristore after the cavity was applied with Mirage-Bond (Group MG). The treated teeth were observed clinically over 90 days after operation. They were then extracted for histological examination. No unpleasant symptoms were noted. A few pathological changes were observed. No histo-pathological score differences were observed between groups G and MG. The average evaluation score of pathological results in both groups G and MG were excellent. Microorganisms observed in the cavity dentin of the group G was fewer than in group MG. In some cases, microorganisms were observed along the dentin walls. In conclusion, the pulpal injury due to this Geristore restoration system was slight, and the system was considered to be safe for the pulp and clinically useful.