Sharing of SRAM Tables Among NPN-Equivalent LUTs in SRAM-Based FPGAs

This article introduces a novel lookup table (LUT) and its usage in the configurable logic block (CLB) architectures for SRAM-based field-programmable gate array (FPGA) architectures. The proposed CLB allows sharing of SRAM tables of LUTs among NPN-equivalent functions to reduce the size of memories used for storing the functions and also reduces the number of configuration bits required. We measured many different characteristics of FPGAs using our new CLB architecture, including area, delay, routing, and power requirements. We experimentally found that for many different FPGA architectures, CLBs can share one-fourth of their SRAM tables between two basic logic elements (BLEs), which reduced both power consumption and area without negatively affecting routing or wirelength, and there was only a negligible increase in critical path delay of 0.27%. Specifically, we find that FPGAs consisting of CLBs with 16 BLEs and 34 inputs can be implemented with eight normal SRAMs and four SRAMs shared between two BLEs, for an overall reduction of four out of sixteen SRAM tables per CLB. With this new CLB architecture, we measured an approximate reduction in overall power consumption of 2% and an estimated reduction in area of 3%     

Fatigue performance of metastable β titanium alloys: Effects of microstructure and surface finish

This investigation examined the role of microstructure and surface finish on the high cycle fatigue (HCF) performance of TIMETAL LCB (Ti-6.8Mo-4.5Fe-1.5Al). The as-received microstructure of LCB consisted of elongated β grains with a semicontinuous grain boundary α layer. In contrast, a fine equiaxed β + spheroidized α LCB microstructure was achieved by hot swaging and solution (recrystallization) anneal. The latter modification of the prior β grain structure, together with the size, morphology, and distribution of the primary α phase, resulted in a significant enhancement in the tensile and HCF properties. Furthermore, prestraining (PS), as would be expected during the fabrication of an automotive coil spring, and prior to aging for 30 min at temperatures between 500 and 550 °C, led to additional increases in tensile strength. In contrast, the HCF performance was always reduced when PS prior to aging was included in the overall processing procedure. Finally, shot-peening and roller-burnishing both resulted in an increased fatigue life in the finite life regimen; however, significant reductions in the 10⁷ cycle fatigue strengths were observed when these procedures were used. These observations have been explained by including the effect of process-induced residual tensile stresses in the fatigue analysis, resulting in subsurface fatigue crack nucleation. This paper was presented at the Beta Titanium Alloys of the 00’s Symposium sponsored by the Titanium Committee of TMS, held during the 2005 TMS Annual Meeting & Exhibition, February 13–16, 2005 in San Francisco, CA.     

Range Extension in IEEE 802.11ah Systems Through Relaying

A great number of Internet of Things (IoT) and machine-to-machine (M2M) based applications, which are telecommunication areas with the highest foreseen growth in the future years, require energy efficient, long range and low data rate wireless communication links. In order to offer a competitive solution in these areas, IEEE 802.11 standardization group has defined the “ah” amendment, the first sub-1 GHz WLAN standard, with flexible channel bandwidths, starting from 1 MHz, up to 16 MHz, and many other physical and link layer improvements, enabling long-range and energy efficient communications. However, for some regions, like Europe, the maximum transmitted power in dedicated frequency band is limited to only 10 mW, thus disabling the achievement of ranges which would be close to targeted of up to 1 km. In this paper we examine possibilities for range extension through implementation of half-duplex decode-and forward (DF) relay station (RS) in communication between an access point (AP) and an end-station (ST). Assuming a Rician fading channel between AP and RS, and a Rayleigh fading channel on RS–ST link, we analytically derive results on achievable ranges for the most robust modulation and coding schemes (MCSs), both on downlink (DL) and uplink (UL). Analyses are performed for two different standard adopted deployment scenarios on RS–ST link, and variable end-to-end link outage probabilities. Moreover, we have analyzed whether the considered most robust MCSs, known for supporting the longest range, but the lowest data rates, can meet the defined requirement of at least 100 kb/s for the greatest attainable AP–RS–ST distances. We examine data rate enhancements, brought by coding and using of short packets, for both DL and UL. Finally, we present bit error rate results, obtained through simulations, of a dual-hop DF IEEE 802.11ah relay system for the considered MCs. All presented results confirm that IEEE 802.11ah systems through deployment of relay stations, become an interesting solution for M2M and IoT based applications, due to flexibility they offer in many aspects, meeting requirements for wide transmission ranges in such applications.     

Towards Future Low Exposure Mobile Cellular Networks

Explosive growth of different type of wireless networks in the last decade has raised an issue of influence of electromagnetic fields originating from radio frequencies to human health. Thus, more and more researchers working on the solutions for the next generation wireless communication systems now have in mind the necessity of keeping the level of radiated power on the minimum level necessary for achieving the required performances. In this paper we analyze solutions for human exposure reduction in dual-hop Orthogonal Frequency Division Multiplexing (OFDM) based decode-and-forward (DF) relay systems, as this type of relay system is adopted for LTE-Advanced networks, also denoted as 4G. In our approach we seek for the solutions that keep the certain performance metric, i.e. system capacity in this analysis, on the same level like in baseline OFDM DF relay system, but attain exposure reduction from relay station (R) on downlink (DL). In one of the considered solutions, R station, having more than one antenna for DL communication, implements transmit antenna selection (TAS) on subcarrier basis, jointly with ordered subcarrier mapping (SCM). TAS solution assumes that on each subcarrier position, the transmit antenna having the best subcarrier channel transfer function is chosen. Ordered SCM is a technique where subcarriers from the first hop are mapped to corresponding subcarriers on the second hop in accordance to their instantaneous signal-to noise ratios. It is proven to be a mapping scheme that maximizes the achievable capacity in OFDM based DF relay systems, enabling bit error rate improvement at the same time. Besides this solution, we analyze the level of human exposure reduction in the cases where only SCM technique is implemented at R, as well as where only TAS is implemented. We have developed a simulation model for assessing the level of human exposure to EMF, with included real-case simulation parameters given in LTE-Advanced relay reference scenario. In this way, we have obtained and analyzed data on the level of human exposure reduction attained with the proposed solutions in indoor and outdoor environment, and for the different positions of end-users relative to R station.     

Characterization of Non-Alloyed Ohmic Contacts to Si-Implanted AlGaN/GaN Heterostructures for High-Electron Mobility Transistors

This paper reports results of a study of non-alloyed ohmic contacts on Si-implanted AlGaN/GaN heterostructures, obtained from current–voltage characteristics of transfer-length method (TLM) test structures. It is shown that the measured contact resistance from the Ti/Au/Ni metal contacts, deposited on Si-implanted regions, to the two-dimensional electron gas channel at the AlGaN/GaN heterointerface of the non-implanted region, is formed by three different components: (i) contact resistance between the metal␣and the semiconductor (0.60 ± 0.16 Ω mm), (ii) resistance of the implanted region (0.62 ± 0.03 Ω mm) and (iii) an additional resistance (0.72 ± 0.24 Ω mm) giving a total value of 1.9 ± 0.3 Ω mm. The specific ohmic contact resistance was determined to be (2.4 ± 0.5) × 10⁻⁵ Ω cm².     

Levels of PCBs and their metabolites in the serum of residents of a highly contaminated area in eastern Slovakia

The over-riding aim of the present investigation was to obtain information concerning exposure that can be used as a basis for studies on the health of individuals residing in the Michalovce area of eastern Slovakia which is heavily contaminated by polychlorinated biphenyls (PCBs). Accordingly, this work focused on determination of serum concentrations of hydroxylated (OH-PCBs) and methylsulfonyl-substituted (MeSO2-PCBs) metabolites of PCBs. One hundred and twenty-two men and women, 20-59 years of age, living in the contaminated area and 175 from the control Stropkov/Svidnik district were selected randomly from 2047 sampled individuals. Following a specially designed cleanup, the levels of various congeners of OH-PCBs and MeSO2-PCBs in their serum were quantitated by gas chromatography and mass spectrometry, with comparison to authentic reference standards. The median concentrations of PCB congeners and their OH-PCB and MeSO2-PCB metabolites were 2-3-fold higher in residents of Michalovce than in the control region. The levels of certain OH-PCB metabolites were in the same high range as those of individual PCB congeners, whereas the MeSO2-PCB levels were significantly lower. The PCB and their metabolites were present at slightly higher concentrations in men than in women, and the serum levels of PCBs and MeSO2-PCBs increased with increasing age. Thus, the environmental contamination resulting from previous industrial production of PCBs has led to elevated concentrations of PCBs and their metabolites in the serum of individuals living in the Michalovce area.     

Scanning Ion Probe Studies of Silicon Implantation Profiles in AlGaN/GaN HEMT Heterostructures

This paper reports results of scanning ion probe studies of silicon implantation profiles in source and drain regions of AlGaN/GaN high-electron-mobility transistor (HEMT) heterostructures. It is shown that both the undoped channel length and the transition region between implanted and non- implanted regions become wider with increasing depth in the structure. These results may explain the previously reported existence of resistance associated with the transition region between implanted and non-implanted semiconductor regions in AlGaN/GaN HEMT heterostructures with non-alloyed Si-implanted source and drain ohmic contact regions.     

Dirofilaria immitis and Dipetalonema reconditum infections in Oklahoma dogs

Following an episode of rheumatic carditis, severe mitral incompetence developed in a 9-year-old girl. A mitral annuloplasty succeeded for a short time in ameliorating her symptoms of cardiac failure. However, mitral incompetence recurred and was accompanied by severe anemia and hemosiderinuria. Distortion of erythrocytes was evident on a peripheral blood smear. A second mitral annuloplasty resulted in resolution of the hemolytic anemia.     

Experimental transmission of Ehrlichia canis (Rickettsiales: Ehrlichieae) by Dermacentor variabilis (Acari: Ixodidae)

Four trials were conducted in which laboratory-reared Dermacentor variabilis nymphs were exposed to Ehrlichia canis by feeding on experimentally infected dogs as soon as classical morulae were detected in peripheral blood monocytes. After molting 25, 50 or 90 adult tick pairs were permitted to feed on 7 Ehrlichia-naive dogs. Transmission occurred in trials 1 (1/1 dog), 3 (1/1 dog) and 4 (2/2 dogs) but not in trial 2 (0/3 dogs), with 4 of 7 dogs becoming infected. Successful transstadial transmission was demonstrated by detection of morulae in peripheral blood lymphocytes and by seroconversion to Ehrlichia canis 30 d post-exposure. Incubation periods ranged between 17 and 22 days (mean = 19). Clinical signs, typical of ehrlichiosis, included mucopurulent ocular discharge, lymphadenopathy and malaise with accompanying pyrexia, leukopenia and thrombocytopenia. Pyrexia, thrombocytopenia and erythrophagocytosis and vacuolization of the cytoplasm of monocytic cells were observed 1-4 d prior to detection of morulae. This is the first demonstration that a tick other than Rhipicephalus sanguineus is capable of transstadial transmission of this important pathogen of dogs.     

Intrahospital transport of neuro ICU patients

Neuroscience intensive care unit (NICU) patients are frequently transported out of the critical care environment for diagnostic and interventional procedures. Four hundred and seventy-one such transports from seventeen clinical centers were studied to identify the characteristics of intrahospital transport. Data collected included the destination and duration of transport, number and type of personnel involved, changes in monitoring and treatment during transport, adverse patient responses and the impact on patients left in the unit. Differences between transports characterized as elective or emergent in nature were noted. Results validate that intrahospital transport of NICU patients is both time and labor intensive. The study also suggests that the optimal process for safe and efficient transport is yet to be designed.