Flashover voltage characteristics of contaminated station insulators under temporary ac overvoltages in the ac system connected with a frequency converter station

According to the recent analysis results of temporary ac overvoltage in the ac system connected with a frequency converter station, large-magnitude over-voltages were confirmed to occur under some special system conditions. Most of the station insulators currently used cannot withstand such overvoltages according to an evaluation based on the data obtained earlier. The necessity of tests to be done to evaluate such performance more accurately was recognized. Both power frequency and switching impulse overvoltage flashover tests were made on contaminated insulators by the method well simulating the natural wetting condition. Switching impulse flashover voltage with the waveshape having a long wavefront time of 2 ms can be well correlated with the flashover voltage characteristics of temporary ac overvoltage. Higher flashover voltage characteristics were obtained by a clean fog test method compared with those obtained by equivalent fog test method.     

Effect of intrathecal nimodipine on spinal cord blood flow and evoked potentials in the normal or injured cord

A method was developed for administering intrathecal pharmacotherapy in a rat model of spinal cord injury. The effects of intrathecal administration of nimodipine on spinal cord blood flow (SCBF) and evoked potentials (EPs) were measured in the normal and injured spinal cord. It had previously been shown that systemic nimodipine caused severe hypotension after spinal cord injury. After baseline SCBF and EPs, 15 uninjured rats were blindly allocated to one of three groups: one placebo group (n = 5); and two groups with intrathecal nimodipine, 0.05 mg/kg (n = 5), or 0.2 mg/kg (n = 5). Ten other rats received a 35 g acute clip compression injury of the spinal cord for 1 minute and, were allocated to one of two groups: placebo (n = 5); and intrathecal nimodipine 0.05 mg/kg (n = 5) given 60 min after injury. In the uninjured groups, neither 0.05 nor 0.2 mg/kg of nimodipine increased SCBF during, or 30 min after, intrathecal infusion. However, the mean arterial blood pressure (MABP) decreased significantly to 69.73.1% after the infusion of 0.2 mg/kg nimodipine and did not recover by 98 min. In all three groups of uninjured rats, the amplitude of the cerebellar EP was decreased 30 min after infusion. After spinal cord injury, there were significant decreases in MABP, SCBF and EP amplitude in both placebo and treatment groups, but there was no therapeutic benefit from nimodipine. Thus, intrathecal infusion of nimodipine did not prevent the hypotension encountered with systemic administration and exerted no beneficial effect on SCBF or EPs after acute spinal cord injury.     

Radiative ignition mechanism of solid fuels

Transmittance of external radiation from a CO₂ laser through a boundary layer of decomposition products over a vertical sample surface is measured during the ignition period. The results indicate that there is significant absorption of the external radiation for PMMA, and a lesser but still not negligible amount, for red oak. An increase in gas phase temperature over surface temperature is observed over much of the ignition interval. Using the experimentally measured incident flux at the sample surface, surface temperature history was calculated from a model that included re-radiation and convection losses from the surface, endothermic decomposition and conduction into the material. The results confirm the significant effect of gas phase absorption on surface temperature. Steady-state-derived surface regression rate expression was used for PMMA in this model. The results raise questions about the validity of such data for the dynamic heating conditions during the ignition period. Further studies needed to understand the radiative ignition mechanism are identified.     

Observation of cold-rolling texture and partially recrystallized texture in polycrystalline 3 pct Si-Fe by high-resolution electron backscattered diffraction

Cold-rolling texture and partially recrystallized texture of polycrystalline 3 pct Si-Fe were investigated using high-resolution electron backscattered diffraction (EBSD) method. From the measurement on a deformed grain with {211}〈011〉∼{111}〈011〉 orientations, deformation bands with {12 4 1}〈014〉 orientation were found. It turned out that the orientation rotation relationship between deformation bands and surrounding deformed grain can be explained by the activation of the slip system, which has a common slip plane with an adjacent grain. Oriented nucleation of recrystallized grains with {12 4 1}〈014〉 orientation was observed in a deformed grain with {211}〈011〉∼{111}〈011〉 orientation. Exactly the same orientation relationship that was observed between deformed grain and the deformation bands was also observed between the deformed grain and the recrystallized grain. A hypothesis that recrystallization nuclei are generated directly from the deformation bands formed by an activation of the slip system that has a common slip plane of neighboring deformed grains was proposed from the present experimental results.     

Ru-catalyzed anode materials for direct hydrocarbon SOFCs

A solid oxide fuel cell using a thin ceria-based electrolyte film with a Ru-catalyzed anode was directly operated on hydrocarbons, including methane, ethane, and propane, at 600 °C. The role of the Ru catalyst in the anode reaction was to promote the reforming reaction of the unreacted hydrocarbons by the produced steam and CO₂, which avoided interference from steam and CO₂ in the gas-phase diffusion of the fuels. The resulting peak power density reached 750 mW cm⁻² with dry methane, which was comparable to the peak power density of 769 mW cm⁻² with wet (2.9 vol.% H₂O) hydrogen. More important was the fact that the cell performance was maintained at a high level regardless of the change in the methane utilization from 12 to 46% but was significantly reduced by increasing the hydrogen utilization from 13 to 42%. While the anodic reaction of hydrogen was controlled by the slow gas diffusion, the anodic reaction of methane was not subject to the onset of such a gas-diffusion process.     

Coupling ratio control of polymeric waveguide couplers by bending

Directional couplers are successfully fabricated on acrylic substrates using polymers synthesised from deuterated methacrylate and deuterated fluoromethacrylate monomers. The excess loss of a 50 mm long coupler is about 0.7 dB including waveguide and fibre coupling losses. A novel method is proposed for tuning the coupling ratio. By bending the coupler, high precision control of within 1% is attained without optical polarisation dependence.<>     

Solid-Phase Syntheses of Two Deacetyl-Thymosin β4 Analogues with Substitution at Position 12 and Their Effects on Impaired Blastogenic Response of T Lymphocytes of Uremic Patients

Two deacetyl-thymosin β₄ analogues containing Phe(4Br) or D-Phe(4Br) as position 12 were synthesized by the manual solid-phase method, and their immunological effects on the impaired blastogenic response of phytohemagglutinin-stimulated T lymphocytes of uremic patients with infectious diseases were studied. Bromination of the p-position of Phe¹² resulted in a marked restorative effect on the impaired blastogenic response of T lympocytes compared with that of our synthetic deacetyl-thymosin β₄ The synthetic [Phe(4Br)¹²]deacetyl-thymsin β₄ was approximately equal in potency to our synthetic [Phe(4F)¹²]deacetyl-thymosin β₄ in uremic patients, but the other analogue, [D-Phe(4Br)¹²]deacetyl-thymosin β₄, had no effect.     

Effects of nondensifying inclusions on the densification and microstructure of zinc oxide matrix composites

The densification and microstructure development of ZnO containing Zn₇Sb₂O₁₂, ZrO₂, and aggregated ZnO were investigated to elucidate the effect of nondensifying inclusions on the sintering of ceramic/ceramic composites. The inclusion retarded the densification, and the degree of retardation was found to depend on the chemical species of inclusion; Zn₇Sb₂O₁₂ had the largest effect, followed by ZrO₂ and then aggregated ZnO last. The experimental results for aggregated ZnO was explained by the theory which predicts the generation of backstresses. The backstresses give a less significant effect on the densification. For Zn₇Sb₂O₁₂ and ZrO₂, the microstructure of the matrix varied with distance from an inclusion particle; much porosity was observed in the region surrounding the inclusion. Circumferential voids, which are responsible for the suppression of densification, form during the initial stage of sintering. Inclusion particles generate an anchoring effect which retards the densification of the matrix immediately surrounding the inclusion particle during the intermediate stage.Supported by the Inamori Foundation.     

Development of 170 GHz/500 kW gyrotron

A development of 170GHz/500kW level gyrotron was carried out as R&D work of ITER. The oscillation mode is TE_31,8. In a short pulse experiment, the maximum power of 750kW was achieved at 85kV/40A. The efficiency was 22%. In the depressed collector operation, 500kW/36%/50ms was obtained. The maximum efficiency of 40% was obtained at P_RF=470kW whereas the power decrease by the electron trapping was observed. Pulse extension was done up to 10s at P_RF=170kW with the depressed collector operation. The power was limited by the temperature increase of the output window.     

High performance liquid chromatographic separation of stereoisomeric bile acids as their UV-sensitive esters

High performance liquid chromatographic separation of a series of mono-, di- and trihydroxylated 5β-cholanic acids which differ only in position and configuration of hydroxyl groups at positions C-3, C-7 and/or C-12, is reported. The C-24 free acids were derivatized to four different classes of UV-sensitive esters, i.e.,p-bromophenacyl (BP),m-methoxyphenacyl (MP), 4-nitrophthalimidemethyl (NPM) and 9-anthrylmethyl (AM) esters, and chromatographed on two, variants of C₁₈ reversed-phase columns (Nova-Pak C₁₈ and Zorbax ODS) with methanol-water systems as mobile phase. Separation efficiency and elution order of some isomeric pairs were influenced by both the structure of the C-24 ester groups and the nature of the columns used. Excellent chromatographic properties were found for those derivatives, particularly for the NPM esters.