Augmentation of boiling heat transfer from horizontal cylinder to liquid by movable particles

This paper presents a series of experimental results on a passive augmentation technique of boiling heat transfer by supplying solid particles in liquid. A cylindrical heater 0.88 mm in diameter is placed in saturated water, in which a lot of mobile particles exist, and the nucleate and film boiling heat transfer characteristics are measured. Particle materials used were alumina, glass, and porous alumina, and the diameter ranged from 0.3 mm to 2.5 mm. Particles are fluidized by the occurrence of boiling without any additive power, and the heat transfer is augmented. The maximum augmentation ratio obtained in this experiment reaches about ten times the heat transfer coefficient obtained in liquid alone. The augmentation ratio is mainly affected by the particle material, diameter, and the height of the particle bed set at no boiling condition. The augmentation mechanism is discussed on the basis of the experimental results. © 2001 Scripta Technica, Heat Trans Asian Res, 31(1): 28–41, 2002     

The significance of urinary N-acetyl-beta-D-glucosaminidase for predicting early stage diabetic nephropathy

We studied urinary N-acetyl-beta-D-glucosaminidase (NAG) in the early stage of diabetic nephropathy in 27 non-insulin-dependent diabetes mellitus (NIDDM) patients with a microalbumin level below 20 mg on 24-hour urine sample. Microalbumin and NAG excretion were measured in 24-hour urine samples collected on three separate occasions within seven days of admission. Creatinine clearance was determined simultaneously. There was a significant negative correlation between the creatinine clearance and 24-hour urinary NAG (r = -0.38, p < 0.05). Elevation of urinary NAG may indicate decreased renal function during early stage NIDDM nephropathy.     

A sensorless brushless dc motor system

This paper describes a brushless dc motor system without position or speed sensor. The brushless motor consists of a permanent magnet synchronous motor and a voltage-source inverter capable of controlling the amplitude and frequency of voltage. The rectangular-shaped stator current with a conducting interval of 120° (electrical) is controlled to be in phase with the trapezoidal back electromotive force. This results in producing maximum torque. Variable speed is achieved by adjusting the average motor voltage similarly to chopper control of dc motors. In this paper, two sensorless position detecting methods, i.e., an “indirect method” suited for the lower-speed range and a “direct method” suited for the higher-speed range are proposed. The combination of the two makes it possible to detect the rotor position over a wide-speed range. Furthermore, a speed-sen-sorless PLL control is proposed in applying the principle of the direct method. Experimental results obtained from a prototype brushless dc motor are shown to confirm the validity of the sensorless drive. The starting procedure of the motor also is discussed because it is impossible to detect the rotor position at a standstill.     

A study of suppression of vapor explosions by adding inversely soluble polymers

The mechanism of the suppression of vapor explosions by adding inversely soluble polymers in water is studied. Vapor explosion experiments and quench experiment are conducted using a silver test piece. Polymetric solution (polyethylene oxide), of concentrations from 0 to 500 wppm, whose normalized viscosity (by water) varies from 1.00 to 2.00, is used. No vapor explosion is observed in the aqueous polymer solution at a concentration higher than 200 wppm. Quench experiments using the silver test piece submerged in the polymer solution and water are performed in order to examine the stability of film boiling. The suppression of the vapor film collapse is attributed to the precipitation of polyethylene as a gel around the vapor film. © 2002 Wiley Periodicals, Inc. Heat Trans Asian Res, 31(4): 297–306, 2002; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/htj.10037     

Inhibition of natural killer cell cytotoxicity by cell growth-related molecules

Certain MHC class I molecules on target cells are known to inhibit the cytotoxic action of NK cells. By using monoclonal antibody (mAb) Cho-1, we have found inhibitory non-MHC class I cell surface molecules that are noncovalently-associated with 200 kDa and 40 kDa antigens. Poly I-C-induced rat NK cells were not cytotoxic to rat fetus-derived fibroblast WFB cell line. In contrast, NK cells were cytotoxic to H-ras oncogene-induced transformants of WFB, W14 and W31. FACS analysis indicated that mAb Cho-1 reacts with WFB, but not with W14 and W31 cells. Thus, this antigen may disappear concomitantly with cell growth and transformation. Cho-1 antigens were also expressed on other NK-resistant lines, such as mouse BALB3T3 fibroblast, EL-4 lymphoma and human fibroblast HEPM. However, they were not expressed on NK-sensitive mouse YAC-1 and H-ras transformant (Brash) of BALB3T3 cells. Furthermore, treatment of target cells with IFN-gamma clearly induced the cell surface expression of Cho-1 antigens, and conferred a resistance to NK cytolysis on target cells. These data strongly suggest that Cho-1 antigen expression may correlate with target cell susceptibility to NK cells. Indeed, treatment of NK-resistant WFB as well as HEPM cells with F(ab')2 fragments of mAb Cho-1 resulted in the acquisition of susceptibility to NK cytolysis. Cho-1 antigens may be novel molecules that regulate the NK resistance of cells.     

Simulation study of eutrophication in Hiroshima Bay: Simulation of particulate and dissolved organic matter using cyclic transformation of carbon

A phytoplankton model, which includes a carbon cycle combined with a constant current obtained by the computation of tidal currents, was applied to the coastal region (Hiroshima Bay, Japan). The transformation rate constants for the carbon cycle were experimentally evaluated.The seasonal variations of particulate and dissolved organic matter by the simulation model were reasonably consistent with the field data. Carbon concentration increased by primary production in the upper layer was approx. 10 times that augmented by loading of carbon from land at the shore in summer. Sinking plays an important role in the elimination of particulate organic matter. On the other hand, horizontal advection and turbulent diffusion are important factors for the diminution of dissolved organic matter.     

Detection of hypervascular hepatocellular carcinoma by using spiral volumetric CT: comparison of US and MR imaging

BACKGROUND: Most hepatocellular carcinomas (HCCs) are hypervascular and arise in the liver with chronicity. Spiral volumetric CT (SVCT) is a new rapid-scan technique that offers whole-liver scanning during the arterial-dominant phase. The main aim of the present study is to evaluate the detectability of hypervascular HCC with SVCT as compared with ultrasonography (US) and magnetic resonance (MR) imaging. METHODS: Forty-three hypervascular HCCs in 512 patients with chronic liver disease were examined with US, precontrast SVCT, postcontrast SVCT during the arterial-dominant phase (CT-ADP) and during the equivalent-phase (CT-EP) noncontrast MR imaging and angiography including SVCT during arteriography and arterial portography. Angiographic and follow-up findings were used as the gold standard if the lesion was not confirmed histologically. RESULTS: The sensitivity was 61% with precontrast CT, 84% with CT-ADP, 58% with CT-EP, 70% with US, 72% with MR, and 95% with the combination of these five modalities. Five HCCs (12%) were detected with only CT-ADP. The vascularity of HCC was correctly evaluated as hypervascular in 38 nodules (88%) with the combination of precontrast CT and CT-ADP. CONCLUSIONS: We suggest that the combination of precontrast SVCT and CT-ADP is an essential modality to screen for HCC in patients with chronic liver disease. CT-EP did not contribute to the detection of hypervascular HCC.     

Quantitative structural analysis of twin boundary in alpha-Zn7Sb2O12 using HAADF STEM method

The structure and composition of the 1/4{110} twin boundary in alpha-Zn7Sb2O12 have been determined by using quantitative high-angle annular dark field scanning transmission electron microscopy (HAADF STEM) analysis. The noise in the experimental HAADF STEM images is reduced by using the maximum entropy method and average processing, and the parameters used in dynamical simulations are experimentally determined. From the analysis, it has been found that octahedral sites in the twin boundary slightly shift parallel to the [110] direction, and a reduction of the Sb concentration at the octahedral sites on the plane adjacent to the twin boundary was detected. The reduction was measured from three regions in the same twin boundary, and the Sb concentrations were 4 +/- 3, 8 +/- 3 and 19 +/-2 at% from 33 at%.     

Relationship of occupation to blood pressure among middle-aged Japanese men--the significance of the differences in body mass index and alcohol consumption

To clarify how and why blood pressure differs between occupations, the proportions of hypertensives, and the measures of blood pressure, body mass index (BMI) and alcohol consumption among the individuals not taking antihypertensive drugs were compared between the eight occupational categories using the data from a health check-up for 589 middle-aged Japanese males, mostly randomly selected from five areas in Japan. After adjusting for age, the relationships of occupation to the proportion of hypertensives and the mean systolic and diastolic blood pressure substantially differed among the five areas. However, after further adjustment for residence, these blood pressure levels (the proportion of hypertensives, and the mean systolic and diastolic blood pressure) were found to be higher for the "Personnel in transport and communications", the "Clerical personnel", the "Managerial and civil personnel" and the "Professional and technical personnel", whereas these values were consistently lowest in the "Service personnel". Age and residence-adjusted mean BMI was also higher for the four occupational categories with the increased blood pressure levels. According to a weighted multiple regression analysis across the eight occupations, the age and residence-adjusted mean BMI was a significant predictor of the age and residence-adjusted mean systolic and diastolic blood pressure (p = 0.068 and 0.018, respectively). These results suggest that the occupation-related changes in BMI may largely contribute to the occupation-related changes in blood pressure.     

Development of a pulse control-type MEMS microrobot with a hardware neural network

This article presents the micro-electro-mechanical systems (MEMS) microrobot which demonstrates locomotion controlled by hardware neural networks (HNN). The size of the microrobot fabricated by the MEMS technology is 4 × 4 × 3.5 mm. The frame of the robot is made of silicon wafer, and it is equipped with a rotary-type actuator, a link mechanism, and six legs. The rotary-type actuator generates rotational movement by applying an electrical current to artificial muscle wires. The locomotion of the microrobot is obtained by the rotation of the rotary-type actuator. As in a living organism, the HNN realized robot control without using any software programs, A/D converters, or additional driving circuits. A central pattern generator (CPG) model was implemented as an HNN system to emulate the locomotion pattern. The MEMS microrobot emulated the locomotion method and the neural networks of an insect with the rotary-type actuator, the link mechanism, and the HNN. The microrobot performed forward and backward locomotion, and also changed direction by inputting an external trigger pulse. The locomotion speed was 0.325 mm/s and the step width was 1.3 mm.