Photoelastic Effects in Phosphate Glasses

The stress-optical coefficients of RO-Pz05 glasses (R = Mg, Ca, Sr, Ba, and Zn) were measured, and the photoelasticity mechanisms were analyzed based on the equation expressing the relation among the photoelastic constants, the elastic moduli, and the refractive index of glasses. No simple relation was found between the stress-optical coefficient and the elastic modulus, indicating that the factor (p – q), where p and q are the Neumann strain-optical coefficients, is important. The change of (p – q) with glass composition is governed mainly by changes in the effect of the atoms, rather than the lattice. The atomic effect increases with decreasing radius of the divalent cation, except for Zn²⁺. The ZnO-containing glasses exhibit extraordinarily large atomic effects. The photo-elasticity mechanism is discussed in relation to the nature of the chemical bonds.     

Development of Reference Shunt for Short‐Time Alternating High Current Tests and Study of Measuring System

Short‐circuit tests for power circuit breakers and others require alternative short‐time current measurement, from a few kA to over several tens kA. However, the reference measurement system as a national standard or a specified secondary standard instrument to directly perform comparative test as a complete calibration test in high current class has not yet been established globally. The Japan Short‐Circuit Testing Committee (hereinafter referred to as “JSTC”) has therefore developed a shunt resistor that can be used as a standard instrument for high current measurement. Reference system using this shunt resistor is also considered by JSTC. The performance of the newly developed shunt resistor has been checked through several methods, such as resistance measurement, high power current test, high frequency current test, temperature rise test, and interference test. The results of the tests proved satisfactory performance. Resistance of the shunt resistor before and after the tests was invariant and stable. This makes the shunt resistor adequate for a reference in practical use. In addition, evaluation of uncertainty of the whole reference system including this shunt resistor satisfactorily fulfills the requirements of IEC 62475 edition 1.0, 2010.     

The Influence Analysis that a Phase Characteristic of the High‐Level Earthquake Gives to Vibration Response Characteristic of the 550‐kV Disconnectors

We developed the 550‐kV disconnectors that strengthened earthquake proofing by the addition of the damper unit and weight reduction of conductive part based on the damage of the 550‐kV disconnectors by the Great East Japan earthquake (March 11, 2011) and inspected the earthquake proofing performance by shake table test. In shake table test, we performed the test by the artificial seismic wave that varied in phase characteristic in addition to the test by resonance method. And, in a high‐level earthquake area, we analyzed it about the influence that a phase characteristic of the artificial seismic wave gave to stress to occur in disconnectors. As a result, it is thought that the stress to occur in disconnectors is decided by a primary natural frequency basically because a bending strain to occur to the disconnectors in the time when the resonance frequency ingredient becomes the big acceleration response value grows big. But, on a particular phase condition, it was confirmed that the bending strain to occur in disconnectors might grow big conspicuously. As for this, the possibility is thought about by influence of higher natural frequency doing superposition.     

Study on Power Fluctuation Dispatch and Capacity Design of Short Period Power Fluctuation Compensation System in Consideration of Power Loss

Since the output of photovoltaic (PV) generation includes power fluctuations caused by natural conditions, the installation of PV on a large scale is expected to affect load frequency control of the power grid. One method of compensating power fluctuations is the use of energy storage (ES), such as batteries and capacitors. A power fluctuation compensation system composed of an electrical double layer capacitor energy storage system (ESS) and a Li‐ion battery energy storage system is considered. The power loss characteristics of both ESSs during power fluctuation compensation are modeled by equivalent circuits based on ES impedance spectra. The models are validated by experiments simulating power fluctuation compensation. Using these ES models, simulations were carried out to determine the power fluctuation dispatch method between the two ESSs and the capacity of the ESSs in consideration of power loss minimization.     

NUCLEATION AND GROWTH OF OXIDE NANOPARTICLES PREPARED BY INDUCTION THERMAL PLASMAS

The reactive evaporation method of injected metal powders was investigated for preparing oxide nanoparticles. The method has advantages such as evaporation is enhancement of the injected powder owing to exothermic reaction heat of the metal powder oxidation in induction thermal plasmas. Tangential gas flow injection to the plasma tail flame controls the diameter and the yield of the oxide nanoparticles. The purpose of this research is to investigate the effect of the injection gas flow on the preparation mechanism of oxide nanoparticles in thermal plasmas by experimental work and numerical analysis. An increase in the flow rate of the injection gas leads to an increase in the diameter as well as the yield of the prepared nanoparticles. Numerical analysis for nucleation and growth provides the preparation mechanism of the oxide nanoparticles; however, a more sophisticated model should be developed.     

ESTIMATION OF DAILY INTAKE OF FOUR KINDS OF TRIHALOMETHANE BY JAPANESE HOUSEWIVES

Duplicate portions of the daily meals consumed by 30 housewives were collected for 3 consecutive days in the cities of Nagoya and Yokohama in Japan.
Meals were analyzed for chloroform, bromodichloromethane (BDCM), chlorodibromomethane (CDBM) and bromoform by using a purge-trap procedure. The average concentration (and the range) of these four kinds of trihalomethane in each of the 24 h duplicate meals were, chloroform 19.6±18.1 ppb(n.d.-106.8 ppb), BDCM 0.3±0.3 ppb(n.d.-1.7 ppb), CDBM 0.1±0.2 ppb(n.d.-0.6 ppb) and bromoform 0.5±1.3 ppb(n.d.-8.1 ppb).
The mean daily dietary intake of the four kinds of trihalomethane by housewives were, chloroform 40.0±25.4 μg, BDCM 0.6±0.5 μg, CDBM 0.3±0.3 μg and bromoform 0.9±1.3 μg.     

铝诱导晶化真空蒸镀多晶硅薄膜的研究

采用真空蒸镀的方法在玻璃衬底上沉积1层非晶硅薄膜,再通过铝诱导晶化的方法制备出晶粒分布较均匀、晶粒尺寸0.5～5μm、晶化率达到89%的多晶硅薄膜。研究了衬底距离、衬底温度、退火温度对薄膜表面形貌、晶粒尺寸和分布及晶化率的影响。结果表明适中的衬底距离下得到的薄膜晶粒分布均匀,表面平整度好,薄膜厚度较大。薄膜的晶化率随着衬底温度和退火温度的提高而增大;随着退火温度的进一步提高,薄膜的晶化率达到最大值然后降低。     

Compositional Trends in Photoelastic Constants of Borate Glasses

The stress-optical coefficients of binary and ternary borate glasses were measured and the factor ( p·q ), where p and q are the Neumann strain-optical coefficients, was determined. As a modifier oxide was added to B₂O₃ glass, the stress-optical coefficient decreased monotonically. It was found that the stress-optical coefficient is determined mainly by the elastic modulus, but the factor ( p·q ) becomes significant when the content and polarizability of the modifier cation are high. It was also found that the factor ( p·q ) decreases when the content and polarizability of the modifier cation increase. The ( p·q ) was divided into the lattice effect and the atomic effect, and their compositional dependences were discussed.