Synergistic Effects of Polybenzimidazole and Aramide on Enhancing Flame-Retardancy and Solubility

Aromatic and functional polymers with processibility derived from biobased starting materials are prerequisite considering sustainable society. Poly(2,5-benzimidazole)s are rigid-rod polymers to show ultrahigh thermal stability such as flame retardance, while usually suffer from poor solubility. Here, poly(benzimidazole-co-amide)s are synthesized from two biobased monomers, 3,4-diaminobenzoic acid and a semirigid comonomer, 4-aminohydrocinnamic acid. The copolymers with an amide composition of 80 mol% and higher are soluble in widely used polar solvents to fabricate the films keeping high flame retardance, which is comparable with popular high-performance polymers such as aromatic polyimides, polyetheretherketone, polyphenylene sulfide, etc.     

Tuning-current splitting network for three-section DBR lasers

A simple current-splitting network for DBR-laser frequency tuning is proposed that distributes a single control current among two tuning sections and can adjust the current distribution without yielding impedance mismatching. The nonlinear characteristics of the tuning sections realise the non-proportional current splitting suitable for continuous tuning; 470 GHz (3.8 nm) tuning range is achieved     

Evaluation of inelastic constitutive models under plasticity-creep interaction for steel at 600°C

Uniaxial tests to identify plasticity-creep interaction in steel at 600°C were carried out as the Benchmark Project by the Subcommittee on Inelastic Analysis and Life Prediction, JSMS. The purpose of this paper is to present recent experimental data and predictions of constitutive models obtained in the project. Ten types of constitutive models were utilized to compare analytical predictions to sixteen benchmark experiments which are grouped into four categories: (I) tensile and creep tests under monotonic loading, (II) mixed mode tests under plastic and creep loading, (III) ratcheting deformation tests under program loads, and (IV) cyclic deformation tests under the combination of different strain rates. The benchmark tests in Group IV are used to estimate the creep-fatigue life of steel; the results will be published in a separate paper.     

Electrochemically induced asymmetrical etching in InAlAs/InGaAs heterostructures for MODFET gate-groove fabrication

We have achieved a self-controlled asymmetrical etching in metalorganic chemical vapor deposition-grown InAlAs/InGaAs heterostructures, which can be suitable for fabricating modulation-doped field-effect transistors (MODFETs) with gate-groove profiles for improved performance. The technology is based on electrochemical etching phenomena, which can be effectively controlled by using different surface metals for ohmic electrodes. When surface metals of Pt and Ni are deposited on the source and the drain, respectively, the higher electrode potential of Pt results in slower etching on the source side than on the drain side. Thus, asymmetry of gate grooves can be formed by wet-chemical etching with citric-acid-based etchant. This represents a new possibility to conduct “recess engineering” for InAlAs/InGaAs MODFETs.     

An automatic torque ripple compensation system for direct drive motors

A serious problem in motion control is the occurrence of torque ripple. Since a direct drive (DD) motor with a magnet rotor uses a rare-earth magnet, the torque ripple is more serious than that of conventional servomotors. This paper presents an auto-compensation of torque ripple using a software-implemented torque observer. The frequency and amplitude of torque ripple can be obtained in the controller by using the estimated torque from an observer, and the autonomous generation of a compensating current component for a torque ripple is possible. The proposed algorithm has been verified by experiments.     

The importance of electrochemistry-related etching in thegate-groove fabrication for InAlAs/InGaAs HFETs

For the first time, the surface metal on nonalloyed ohmic electrodes is found to significantly change the profiles of gate grooves, when resist openings are employed to monitor drain current during wet-chemical gate recess for sub-micron InAlAs/lnGaAs heterojunction field-effect transistors (HFETs). The surface metal of Ni enhances the etching rate in comparison with that in the absence of electrodes by a factor of 4 and 10, laterally and vertically, which is favorable to fabricate deep gate grooves with small side etching. The Pt surface metal, however, leads to preferential etching of InGaAs over InAlAs, which can be useful to realize large side etching. The existence of an electrochemistry-related etching component, which arises when the ohmic electrodes are present during recess etching, is considered to be responsible for these behaviors     

Design and characteristics of InGaAs/InP composite-channel HFET's

A design for composite-channel structures consisting of an InGaAs channel and an InP subchannel for use as heterostructure field-effect transistors is presented for the first time. This novel channel structure takes advantage of both the high drift velocity and low impact ionization of InP at high electric fields as well as the high electron mobility of InGaAs at low electric fields. It is shown that the doping density of the InP subchannel is the key parameter to realize the advantages of the composite channel. A very high transconductance of 1.29 S/mm and a current gain cutoff frequency of 68.7 GHz are achieved with 0.6 and 0.7 /spl mu/m gates, respectively. The average velocity of electrons in the composite channel is 2.9/spl times/10/sup 7/ cm/s. The devices have no kink phenomena in their I-V characteristics possibly due to low impact ionization in the InP subchannel.<>     

Inhibitory effect of alpha-tocopherol on methemoglobin formation by nitric oxide in normal and acatalasemic mouse hemolysates

The inhibitory effect of alpha-tocopherol on methemoglobin formation in normal and acatalasemic mice was studied by exposing their hemolysates to nitric oxide. Methemoglobin formation in normal and acatalasemic mouse hemolysates exposed to nitric oxide were significantly inhibited by the addition of alpha-tocopherol at final concentrations ranging from 1.2 to 5.8 mM. Negative correlations were observed between the logarithm of alpha-tocopherol concentration and the methemoglobin formation. The formation of methemoglobin in acatalasemic mouse hemolysates was greater than that in normal mouse hemolysates with or without added alpha-tocopherol. The methemoglobin formation in acatalasemic mice was also significantly inhibited by addition of more than 500 units/ml of catalase, and the methemoglobin formation in normal and acatalasemic mice was also inhibited with sodium diethyldithiocarbamate at a final concentration of 1 M.     

Changes in cerebral blood flow and oxygen metabolism related to magnetic resonance imaging white matter hyperintensities in Alzheimer's disease

We studied changes in cerebral perfusion and oxygen metabolism to elucidate the pathophysiological nature and clinical significance of white matter hyperintensities in Alzheimer's disease (AD). METHODS: Sixteen AD patients (age 71.6 +/- 3.1 yr) whose T2-weighted MR images showed white matter hyperintensities, and 16 age-matched AD patients (age 71.0 +/- 4.3 yr) without white matter hyperintensities were compared. Regional cerebral blood flow (CBF), oxygen metabolism (CMRO2) and oxygen extraction fraction (OEF) were measured by using (15)O steady-state method and PET. RESULTS: There was no significant difference in cognitive impairment between the two groups. Compared to the patients without white matter hyperintensities, those with them had significantly low CBF values and significantly high OEF values in all cortical and white matter regions. However, there were no significant differences in CMRO2 values between the two groups. Severity of white matter hyperintensities correlated with the mean cortical and mean white matter OEF. CONCLUSION: In AD patients, white matter hyperintensities on T2-weighted MR images represent ischemic changes in which oxygen metabolism and function are fairly compensated. These changes are not disease-specific but are age-associated coincidences, as in normal aging with or without vascular risk factors.