Delay compensated control of the Stefan problem and robustness to delay mismatch

This paper presents a control design for the one‐phase Stefan problem under actuator delay via a backstepping method. The Stefan problem represents a liquid‐solid phase change phenomenon which describes the time evolution of a material's temperature profile and the interface position. The actuator delay is modeled by a first‐order hyperbolic partial differential equation (PDE), resulting in a cascaded transport‐diffusion PDE system defined on a time‐varying spatial domain described by an ordinary differential equation (ODE). Two nonlinear backstepping transformations are utilized for the control design. The setpoint restriction is given to guarantee a physical constraint on the proposed controller for the melting process. This constraint ensures the exponential convergence of the moving interface to a setpoint and the exponential stability of the temperature equilibrium profile and the delayed controller in the norm. Furthermore, robustness analysis with respect to the delay mismatch between the plant and the controller is studied, which provides analogous results to the exact compensation by restricting the control gain.     

Fabrication of lotus-type porous carbon steel by the continuous zone melting method and its mechanical properties

A lotus-type porous carbon steel with cylindrical pores was fabricated by the continuous zone melting method in a pressurized mixture of hydrogen and helium gases. The porosity increases with increasing partial pressure of the hydrogen gas, while the pore diameter remains almost constant, independent of the pressure. The ultimate tensile strength of the specimen with cylindrical pores parallel to the tensile direction is lower than the estimated value, assuming that the strength is decreased in proportion to the decrease of the cross-sectional area of the specimen, while the yield strength is higher than the estimated value. The compressive yield strength is also higher than the estimated value. The increase in yield strength is considered to be due to precipitation strengthening. The tensile strength is increased by quenching and tempering, while the elongation decreases. Such mechanical properties are discussed in terms of the microstructural analysis.     

Multipath structure for FSR expansion in waveguide-based optical ring resonator

A multipath structure of a ring resonator is proposed to expand the free spectral range. Simulation work indicates that the multipath ring resonator has 25 GHz-adjacent-channel crosstalk of -41 dB, maximum interchannel crosstalk of -18 dB, and -1 dB bandwidth of 4 GHz for a typical expansion factor of 10. The results show the advantages of characteristics compared with a double-cavity ring resonator and a triple-coupler ring resonator.     

Transmission capacity of optical path overhead transfer schemeusing pilot tone for optical path network

Photonic networks based on the optical path concept and wavelength division multiplexing (WDM) technology require unique operation, administration, and maintenance (OAM) functions. In order to realize the required OAM functions, the optical path network must support an effective management information transfer method. The method that superimposes a pilot tone on the optical signal appears very interesting for optical path overhead transfer. The pilot tone transmission capacity is determined by the carrier to noise ratio which depends on the power spectral density of the optical signal. The pilot tone transmission capacity of an optical path network employing WDM technology is elucidated; 4.5 kb/s transmission can be realized when the pilot tone modulation index is set at 3%     

Cell density-dependent DNA fragmentation and its suppression by heparin in primary culture of adult rat hepatocytes

We show here that the internucleosomal DNA fragmentation, which is a biochemical hallmark of apoptosis, was induced in a cell density-dependent manner in primary culture of adult rat hepatocytes. This DNA fragmentation could be suppressed by a gene expression inhibitor, indicating the active nature of this process. Moreover, the viability changes in high and low cell density cultures showed a tendency corresponding with the incidence of the DNA fragmentation in them. These results suggest that in hepatocytes there may be a cell density-dependent apoptosis mechanism. In this report, we also show that heparin could suppress this DNA fragmentation with high specificity, and the cell death to some extent.     

Simulation of Strength Distribution in Ground Ceramics by Incorporating Residual Stress Effect

Strength of ground ceramics may be affected by residual stress as well as surface flaws induced by grinding. Strength prediction for ground ceramics is convenient for mechanical design of ceramic components. In this article, a numerical procedure based on fracture mechanics was proposed to estimate strength distribution of ground ceramics by considering grinding-induced residual stress. Bending strength and residual stress of ground ceramics were measured for three grinding-conditions. By comparison of simulated results with experimental ones, it was revealed that strength characteristics in experiments were well simulated by using the proposed procedure.     

Laser coupling to single-mode fibre using graded-index lenses and compact disc 1.3 ?m laser package

A 1.3 ?m laser in a compact disc package is coupled to single-mode fibre using two graded-index lenses in a nearly confocal scheme. An increase in the alignment tolerance at the lens-lens interface by a factor of six suggests the design for a potentially very low-cost connectorised laser package. The coupling efficiency of approx. 6% (?12 dB) is shown to be adequate for local loop applications.     

Construction of the plasmid PMEX8-HAK1 and random site-directed mutagenesis of human cytosolic adenylate kinase

The pMEX8-hAK1 vector was devised from the pAK plasmid (Kim J. H. et al., 1989, Protein Engineering 5, 379-386), which could directly express human adenylate kinase proteins without recombination and its single strand DNA could be withdrawn with helper phage for random site-directed mutagenesis. The conserved key residues at Lys21, Lys27, and Thr39 were engineered to obtain mutants for kinetic analysis. Three mutants were obtained as K21P, K27R, and T39S, their specific activities were strikingly reduced compared to those of wild type adenylate kinase. This pMEX8-hAK1 will be a powerful tool for site-directed mutagenesis to detect the substrate-enzyme interaction for human adenylate kinase including various other enzymes.