Reliable eye-diagram analysis of data links via device macromodels

This paper addresses the impact of device macromodels on the accuracy of signal integrity and performance predictions for critical digital interconnecting systems. It exploits nonlinear parametric models for both single-ended and differential devices, including the effects of power supply fluctuations and receiver bit detection. The analysis demonstrates that the use of well-designed macromodels dramatically speeds up the simulation as well it preserves timing accuracy even for long bit sequences.     

On the use of 2-D coding techniques for ECG signals.

This paper discusses the convenience of using two-dimensional (2-D) coding techniques for the compression of electrocardiogram (ECG) signals. These signals present a very clear periodicity that can be exploited by the use of a 2-D time/frequency transform to decorrelate it as much as possible. A brief theoretical approach is given to justify the use of this technique, and a comparison is made between a 2-D and a one-dimensional (1-D) uniform quantization scenarios. The influence of the error as well as the frame size on the estimation of the fundamental period is studied.     

Physico-chemical characterization of hybrid polymers obtained by 2-hydroxyethyl(methacrylate) and alkoxides of zirconium

Hybrid monolithic materials were prepared through polymerisation of 2-hydroxyethyl methacrylate (HEMA) mixed with zirconium alkoxides (Zr(OBuⁿ)₄, Zr(OPrⁿ)₄ and Zr(OEt)₄), modified by acetylacetonate groups. The molar ratio HEMA/Zr varied between 1 and 4. Thermo-Gravimetry coupled with Mass Spectroscopy (TG-MS) analyses, ¹³C MAS NMR and Dynamical Mechanical Thermal Analysys (DMTA) indicated the polymeric chains were interconnected by the inorganic component.The presence of zirconium alkoxides modified substantially the poly-HEMA properties. Glass transition temperature of hybrid materials derived from butoxy and propoxy was found in the range 50-80 °C, depending on the composition. The typical swelling of p-HEMA in the water, was suppressed by the presence of zirconium compounds. After immersion in distilled water, hybrid polymers showed an initial slight weight increase, followed by a small mass loss, which increases proportionally to the length of alkoxyl group (ethoxide(propoxide(butoxide) and reaches a constant value after about 40 days. The hybrids remained always rigid and transparent. Flexural modulus and strength of about 400-900 and 4-8 MPa were measured.     

Implementation of RNS-Based Distributed Arithmetic Discrete Wavelet Transform Architectures Using Field-Programmable Logic

Currently there are design barriers inhibiting the implementation of high-precision digital signal processing (DSP) objects with field programmable logic (FPL) devices. This paper explores overcoming these barriers by fusing together the popular distributed arithmetic (DA) method with the residue number system (RNS) for use in FPL-centric designs. The new design paradigm is studied in the context of a high-performance filter bank and a discrete wavelet transform (DWT). The proposed design paradigm is facilitated by a new RNS accumulator structure based on a carry save adder (CSA). The reported methodology also introduces a polyphase filter structure that results in a reduced look-up table (LUT) budget. The 2C-DA and RNS-DA are compared, in the context of a FPL implementation strategy, using a discrete wavelet transform (DWT) filter bank as a common design theme. The results show that the RNS-DA, compared to a traditional 2C-DA design, enjoys a performance advantage that increases with precision (wordlength).     

Identification of in vitro phosphorylation sites in the growth cone protein SCG10. Effect Of phosphorylation site mutants on microtubule-destabilizing activity

SCG10 is a neuron-specific, membrane-associated protein that is highly concentrated in growth cones of developing neurons. Previous studies have suggested that it is a regulator of microtubule dynamics and that it may influence microtubule polymerization in growth cones. Here, we demonstrate that in vivo, SCG10 exists in both phosphorylated and unphosphorylated forms. By two-dimensional gel electrophoresis, two phosphoisoforms were detected in neonatal rat brain. Using in vitro phosphorylated recombinant protein, four phosphorylation sites were identified in the SCG10 sequence. Ser-50 and Ser-97 were the target sites for protein kinase A, Ser-62 and Ser-73 for mitogen-activated protein kinase and Ser-73 for cyclin-dependent kinase. We also show that overexpression of SCG10 induces a disruption of the microtubule network in COS-7 cells. By expressing different phosphorylation site mutants, we have dissected the roles of the individual phosphorylation sites in regulating its microtubule-destabilizing activity. We show that nonphosphorylatable mutants have increased activity, whereas mutants in which phosphorylation is mimicked by serine-to-aspartate substitutions have decreased activity. These data suggest that the microtubule-destabilizing activity of SCG10 is regulated by phosphorylation, and that SCG10 may link signal transduction of growth or guidance cues involving serine/threonine protein kinases to alterations of microtubule dynamics in the growth cone.     

Interaction of triton X-100 on silica: A relationship between surface characteristics and adsorption isotherms

Adsorption of Triton X-100 on various silica substrates has been investigated. A number of solids, including a natural quartz, this quartz washed with HCl acid and subsequently heated at 1273 K; two aerosils and one Kieselgel silicas were studied. These solids exhibit surface areas in the range of 5 to 430 m² g^?1. All the Triton adsorption isotherms display an S-shape at the adsorption temperatures studied (298 and 308 K). It has been found that the pretreatments of natural quartz (by water washing, impurities removed by acid and/or high temperature calcination) affect considerably the amounts of TX-100 adsorbed. Measurements of surface composition have been made by X-ray photoelectron spectroscopy (XPS) with particular emphasis on the presence of impurities and on the number of OH groups at the surface of the samples. The nature of the surface hydroxyl has also been studied by infrared spectroscopy. Furthermore, the specific number of hydroxyl groups on the surface of the silica samples has been determined by thermogravimetric analysis. Finally an attempt to correlate solid surface characteristics with adsorption isotherms has been developed.     

Magnetic resonance of the encephalon in 17 patients with ocular Beh?et''s disease

OBJECTIVE: To evaluate the relationships between patient and physician pretreatment expectations of pain relief and subsequent pain relief reported by chronic pain patients immediately after treatment. DESIGN: Prospective study of consecutive patients undergoing a procedure in a pain clinic for treatment of chronic pain. Patients rated their current pain level and their expectation of pain relief immediately prior to undergoing a procedure (e.g., intravenous drug infusion, nerve block) for the treatment of chronic pain. Simultaneously and independently, the treating physician completed a similar questionnaire. At completion of the procedure, patients rated their current pain level and degree of pain relief. SETTING: University of Washington Multidisciplinary Pain Center procedure suite. PATIENTS: Forty-six consecutive chronic pain patients. INTERVENTION: Intravenous drug infusions and nerve blocks. OUTCOME MEASURES: Current pain and pain relief ratings. RESULTS: Patients' pain relief expectation ratings were not correlated significantly with their postprocedure pain relief ratings or pre-post procedure changes in pain ratings. However, a statistically significant correlation was found between physician expectations of pain relief and patient pain relief ratings and patient pre-post procedure changes in pain. CONCLUSIONS: The results of this study suggest that physicians are better predictors than are patients of patients responses to these procedures and/or that physicians may somehow subtly communicate their expectations to patients during the procedure, and these expectations then influence patient response. Patient pretreatment expectations may not always play a significant role in nonspecific treatment effects.     

Snowboard traumatology: an epidemiological study

OBJECTIVE: To estimate the frequency of perioperative morbidities in patients who underwent anesthesia and a surgical procedure with no preoperative laboratory testing. MATERIAL AND METHODS: We conducted an electronic database search of medical records of 56,119 patients who underwent surgical or diagnostic procedures and anesthesia at Mayo Clinic Rochester in 1994 and found 5,120 who had no laboratory tests done within 90 days before the procedure. From this group, we randomly selected 1,044 patients (87 from each month) to document the absence of preoperative tests, the presence of preexisting disease (by organ system), the type of anesthetic agent, and the outcomes and tests intraoperatively and postoperatively. RESULTS: The 1,044 patients ranged in age from 0 to 95 years (median age, 21). No deaths or major perioperative morbidities occurred (0.0%; exact 95% confidence interval, 0.00 to 0.35%). Although 10 patients underwent blood typing and screening for antibodies immediately preoperatively, no blood transfusions were necessary. Intraoperatively, 17 laboratory tests and 1 electrocardiogram were obtained, and 3 results were abnormal. Postoperatively, 42 blood tests and 2 electrocardiographic procedures were performed. Five of the 42 blood tests showed abnormal results (hemoglobin levels in 3, serum sodium in 1, and arterial blood gases in 1). One electrocardiogram showed normal findings, and the other revealed normal results except for premature ventricular contractions. No laboratory test done intraoperatively or postoperatively was found to change surgical or medical management substantially. One patient who had unanticipated blood loss during an outpatient procedure was admitted to the hospital for observation. CONCLUSION: All 1,044 patients, 97% of whom were relatively healthy, with no recent laboratory testing safely underwent anesthesia and an operation. We conclude that patients who have been assessed by history and physical examination and determined to have no preoperative indication for laboratory tests can safely undergo anesthesia and operation with tests obtained only as indicated intraoperatively and post-operatively. Current anesthetic and medical practices rapidly identify perioperative indications for laboratory evaluation as they arise.     

Properties of poly(ethylene terephthalate)–poly(ethylene naphthalene 2,6‐dicarboxylate) blends with montmorillonite clay

The production and properties of blends of poly(ethylene terephthalate) (PET) and poly(ethylene naphthalene 2,6‐dicarboxylate) (PEN) with three modified clays are reported. Octadecylammonium chloride and maleic anhydride (MAH) are used to modify the surface of the montmorillonite–Na⁺ clay particles (clay–Na⁺) to produce clay–C18 and clay–MAH, respectively, before they are mixed with the PET/PEN system. The transesterification degree, hydrophobicity and the effect of the clays on the mechanical, rheological and thermal properties are analysed. The PET–PEN/clay–C18 system does not show any improvements in the mechanical properties, which is attributed to poor exfoliation. On the other hand, in the PET–PEN/clay–MAH blends, the modified clay restricts crystallization of the matrix, as evidenced in the low value of the crystallization enthalpy. The process‐induced PET–PEN transesterification reaction is affected by the clay particles. Clay–C18 induces the largest proportion of naphthalate–ethylene–terephthalate (NET) blocks, as opposed to clay–Na⁺ which renders the lowest proportion. The clay readily incorporates in the bulk polymer, but receding contact‐angle measurements reveal a small influence of the particles on the surface properties of the sample. The clay–Na⁺ blend shows a predominant solid‐like behaviour, as evidenced by the magnitude of the storage modulus in the low‐frequency range, which reflects a high entanglement density and a substantial degree of polymer–particle interactions. Copyright © 2005 Society of Chemical Industry     

Probing the thermal decomposition process of layered double hydroxides through in situ <Superscript>57</Superscript>Fe Mössbauer and in situ X-ray diffraction experiments

The thermal decomposition properties of Mg–Fe hydrotalcites were studied through in situ ⁵⁷Fe Mössbauer spectroscopy and in situ X-ray diffraction. Abrupt changes in the quadrupolar splitting measured in the Mössbauer spectra revealed a phase transition from the starting lamellar structure to a new crystalline arrangement. By analyzing the Mössbauer parameters we show that the material is highly disordered in the 300–400 °C temperature range. This hypothesis is confirmed by the X-ray results whose diffractograms indicated the collapse of the lamellar structure and the formation of a solid solution.