On the uniqueness of some helical flows of a second grade fluid

Summary The uniqueness of some helical flows of a second grade fluid, between two infinite circular cylinders, is proved. Initially, the fluid is at rest and flow is produced by the motion of the cylinders. Finally, the special case of a flow in a circular cylinder is considered.     

New integrated buried laser-ridge modulator with identical active layer

Integrated laser modulators are attractive devices for wavelength-division-multiplexing optical systems due to their compactness, high output power, and low cost. Their fabrication simplicity is a way to decrease further the transmitter cost and address new opening markets of short range and metropolitan networks. We report a new integration scheme electroabsorption-modulator distributed feedback (DFB) laser based on well-established industrial solutions for discrete buried ridge (BRS) DFB lasers and discrete shallow ridge modulators. Processing simplification with an identical active layer has been possible due to a good behavior of strongly positively detuned BRS lasers. The integrated devices demonstrated 30-dB extinction ratio with 10-GHz bandwidth and P/sub out/=10 dBm for emission in 1.55-/spl mu/m range.     

Syndiotactic Polystyrene/Organoclay Nanocomposites: Synthesis via In Situ Coordination‐Insertion Polymerization and Preliminary Characterization

Summary: Syndiotactic polystyrene (sPS)/organophilic clay nanocomposites were obtained by in situ coordination‐insertion polymerization of styrene. Two cationic surfactants (alkylammonium and alkylphosphonium) were used for the intercalation of montmorillonite (MMT). For each organically modified clay, three protocols were performed using an MAO‐activated hemi‐metallocene catalyst, in order to compare the influence of experimental conditions on the composite microstructure and on its thermal stability. The microstructures of nanocomposites were investigated by wide angle X‐ray scattering and DSC. Partially exfoliated or intercalated materials were obtained in all cases and a decrease of crystallinity is observed. Thermal properties were also studied by DSC and thermogravimetric analysis. The presence of clay does not have a strong influence on the sPS thermal transitions but the thermal decomposition process of the material was slowed down in the presence of few organoclay percents, particularly in the degradation beginning. The influence of these two organically modified clays on the thermal stability of the material is discussed.

Gel and suspension formed from the combination of cloisite with toluene (left) and styrene (right), respectively.     

Recommendation of RILEM Technical Committee 250-CSM: Test method for Textile Reinforced Mortar to substrate bond characterization

Textile Reinforced Mortar (TRM), also known as Fabric Reinforced Mortar or Fabric Reinforced Cementitious Matrix, composites are an emerging technology for the external repair and strengthening of existing structures. For most applications, the effectiveness of the TRM reinforcement relies on its bond performance. This recommendation identifies the best practice to characterize the bond behaviour of TRM. A shear bond test method is proposed to determine the peak axial stress (associated with the maximum load that can be transferred from the structural member to the externally bonded TRM reinforcement), the stress–slip relationship and the failure mode that controls the TRM-to-substrate load transfer capacity. Guidelines on specimen manufacturing, experimental setup, test execution, and determination of test results are provided.     

Design and fabrication of a p-i-n photodiode with high responsivity and large alignment tolerances for 40-gb/s applications

This letter demonstrates an evanescently coupled p-i-n photodiode combined with a multimode diluted waveguide using a simple all 2-in InP processing that includes on-wafer mirrors etching and antireflection coating. A high responsivity of 0.81 A/W at 1.55 /spl mu/m with less than 0.4-dB polarization dependence and a large -1-dB vertical alignment tolerance of 2.70 /spl mu/m were achieved simultaneously with a bandwidth of 47 GHz. Stable operation for over 1000 h was obtained under bias stress and temperature at 200/spl deg/C.     

Starting solutions for some unsteady unidirectional flows of a second grade fluid

Exact solutions corresponding to the motions of a second grade fluid, due to the cosine and sine oscillations of an infinite flat plate as well as those induced by an oscillating pressure gradient are determined by means of the Fourier sine transforms. These solutions, presented as sum of the steady-state and transient solutions, satisfy both the governing equations and all associate initial and boundary conditions. In the special case when α₁ → 0, they reduce to those for a Navier-Stokes fluid.     

On Expressivity and Compositionality in Logics for Coalgebras

This paper attempts to unify some of the existing approaches to defining modal logics for coalgebras, from the point of view of constructing the languages employed by these logics. An abstract framework for defining languages for coalgebras from so-called language constructors, corresponding to one-step unfoldings of the coalgebraic structure, is introduced, and a method for deriving expressive languages for coalgebras from suitable choices for the language constructors is described. Moreover, it is shown that the derivation of such languages by means of language constructors is well-behaved w.r.t. various forms of composition between coalgebraic types.     

Betulinic Acid in Complex with a Gamma-Cyclodextrin Derivative Decreases Proliferation and in Vivo Tumor Development of Non-Metastatic and Metastatic B164A5 Cells

Betulinic acid, a very promising anti-melanoma agent, has very low water solubility that causes low bioavailability. To overcome this inconvenience, a highly water-soluble cyclodextrin was used (octakis-[6-deoxy-6-(2-sulfanyl ethanesulfonic acid)]-γ-cyclodextrin). The complex was physico-chemically analyzed using differential scanning calorimetry (DSC), X-ray and scanning electron microscopy (SEM) methods and then in vitro tested for its antiproliferative activity by the MTT assay and by cell cycle analysis. Finally, the complex was tested in vivo using an animal model of murine melanoma developed in C57BL/6J mice, where it caused a reduction in tumor volume and weight. The study revealed the beneficial influence of betulinic acid inclusion into the cyclodextrin in terms of antiproliferative activity and in vivo tumor development.