A Novel LRRK2 Variant p.G2294R in the WD40 Domain Identified in Familial Parkinson’s Disease Affects LRRK2 Protein Levels

Leucine-rich repeat kinase 2 (LRRK2) is a major causative gene of late-onset familial Parkinson’s disease (PD). The suppression of kinase activity is believed to confer neuroprotection, as most pathogenic variants of LRRK2 associated with PD exhibit increased kinase activity. We herein report a novel LRRK2 variant—p.G2294R—located in the WD40 domain, detected through targeted gene-panel screening in a patient with familial PD. The proband showed late-onset Parkinsonism with dysautonomia and a good response to levodopa, without cognitive decline or psychosis. Cultured cell experiments revealed that p.G2294R is highly destabilized at the protein level. The LRRK2 p.G2294R protein expression was upregulated in the patient’s peripheral blood lymphocytes. However, macrophages differentiated from the same peripheral blood showed decreased LRRK2 protein levels. Moreover, our experiment indicated reduced phagocytic activity in the pathogenic yeasts and α-synuclein fibrils. This PD case presents an example wherein the decrease in LRRK2 activity did not act in a neuroprotective manner. Further investigations are needed in order to elucidate the relationship between LRRK2 expression in the central nervous system and the pathogenesis caused by altered LRRK2 activity.     

Effects of SO2 on selective catalytic reduction of NO with NH3 over a TiO2 photocatalyst

The effect of SO₂ gas was investigated on the activity of the photo-assisted selective catalytic reduction of nitrogen monoxide (NO) with ammonia (NH₃) over a TiO₂ photocatalyst in the presence of excess oxygen (photo-SCR). The introduction of SO₂ (300 ppm) greatly decreased the activity of the photo-SCR at 373 K. The increment of the reaction temperature enhanced the resistance to SO₂ gas, and at 553 K the conversion of NO was stable for at least 300 min of the reaction. X-ray diffraction, FTIR spectroscopy, thermogravimetry and differential thermal analysis, x-ray photoelectron spectroscopy (XPS), elemental analysis and N₂ adsorption measurement revealed that the ammonium sulfate species were generated after the reaction. There was a strong negative correlation between the deposition amount of the ammonium sulfate species and the specific surface area. Based on the above relationship, we concluded that the deposition of the ammonium sulfate species decreased the specific surface area by plugging the pore structure of the catalyst, and the decrease of the specific surface area resulted in the deactivation of the catalyst.     

Analysis of Cerebrospinal Fluid Extracellular Vesicles by Proximity Extension Assay: A Comparative Study of Four Isolation Kits

There is a lack of reliable biomarkers for disorders of the central nervous system (CNS), and diagnostics still heavily rely on symptoms that are both subjective and difficult to quantify. The cerebrospinal fluid (CSF) is a promising source of biomarkers due to its close connection to the CNS. Extracellular vesicles are actively secreted by cells, and proteomic analysis of CSF extracellular vesicles (EVs) and their molecular composition likely reflects changes in the CNS to a higher extent compared with total CSF, especially in the case of neuroinflammation, which could increase blood–brain barrier permeability and cause an influx of plasma proteins into the CSF. We used proximity extension assay for proteomic analysis due to its high sensitivity. We believe that this methodology could be useful for de novo biomarker discovery for several CNS diseases. We compared four commercially available kits for EV isolation: MagCapture and ExoIntact (based on magnetic beads), EVSecond L70 (size-exclusion chromatography), and exoEasy (membrane affinity). The isolated EVs were characterized by nanoparticle tracking analysis, ELISA (CD63, CD81 and albumin), and proximity extension assay (PEA) using two different panels, each consisting of 92 markers. The exoEasy samples did not pass the built-in quality controls and were excluded from downstream analysis. The number of detectable proteins in the ExoIntact samples was considerably higher (~150% for the cardiovascular III panel and ~320% for the cell regulation panel) compared with other groups. ExoIntact also showed the highest intersample correlation with an average Pearson’s correlation coefficient of 0.991 compared with 0.985 and 0.927 for MagCapture and EVSecond, respectively. The median coefficient of variation was 5%, 8%, and 22% for ExoIntact, MagCapture, and EVSecond, respectively. Comparing total CSF and ExoIntact samples revealed 70 differentially expressed proteins in the cardiovascular III panel and 17 in the cell regulation panel. To our knowledge, this is the first time that CSF EVs were analyzed by PEA. In conclusion, analysis of CSF EVs by PEA is feasible, and different isolation kits give distinct results, with ExoIntact showing the highest number of identified proteins with the lowest variability.     

Structure and electrical characteristics of Ce4+-doped Ba2In2O5

The In-site of Ba₂In₂O₅ with Brownmillerite structure was partially substituted for Ce⁴⁺ ions in order to examine the doping effect on the order-disorder transition. Ba₂In_{2 – x} Ce _x O_{5 + x/2} (x = 0.1, 0.2, 0.3, 0.5, 1.0, and 1.5) were prepared by solid state reaction. X-Ray diffraction analyses of these powder samples demonstrated that Ba₂In_{2 – x} Ce _x O_{5 + x/2} (x = 0.1 and 0.2) possesses Brownmillerite structure. With increasing content of Ce⁴⁺ ion the crystal system of Ba₂In_{2 – x} Ce _x O_{5 + x/2} (x = 0.3, 0.5, and 1.0) changed to cubic perovskite structure above the order-disorder transition temperature of Ba₂In₂O₅. Arrhenius plots of the electrical conductivities of Ba₂In_{2 – x} Ce _x O_{5 + x/2} (x = 0.2, 0.3, and 1.0) exhibited no discontinuity. These compounds had high transference numbers of oxide ion above 973 k.     

Strengthening of Preloaded RC Beams Using Hybrid Carbon Sheets

Reinforced concrete (RC) beams subject to service loads of 40 or 60% of steel yielding were strengthened using hybrid continuous carbon fiber sheets. The hybrid systems were made of high-strength and high-modulus carbon sheets, and compared with systems using only high-strength carbon. It was found that the use of high-modulus carbon sheets in hybrid systems could increase the yielding load, the flexural stiffness, the postyielding ductility, and reduce the crack opening in concrete. The slope changes on load-deflection curves at steel yielding are not noticeable in hybrid systems. The tensile strains developed in hybrid sheets after the fracture of high-modulus carbon are higher in magnitude and distributed in a larger area, leading to an ultimate carbon fracture with concrete crushing. These unique features are attributed to the high stiffness and low ultimate tensile strain of the high-modulus carbon fibers which stiffen the structures, avoid or delay the fiber-reinforced polymer debonding, and facilitate the deformability during their subsequent breakdown.     

Boron removal by titanium addition in solidification refining of silicon with Si-Al melt

In order to effectively remove B from Si for its use in solar cells, a process involving B removal by solidification refining of Si using a Si-Al melt with Ti addition was investigated. For clarifying the effect of Ti addition on B removal from the Si-Al melt, TiB₂ solubilities in Si-64.6 at. pct Al melt at 1173 K and Si-60.0 at. pct Al melt at 1273 K were determined by measuring the equilibrium concentrations of B and Ti in the presence of TiB₂ precipitates. The small solubilities of TiB₂ in the Si-Al melt indicate the effective removal of B from the Si-Al melt by Ti addition. Further, solidification experiments of Si-Al alloys containing B by Ti addition were performed, and the effect of Ti addition on the solidification refining of Si with the Si-Al melt was successfully confirmed.     

Selective hydrogenation of oleic acid to 9-octadecen-1-ol: Catalyst preparation and optimum reaction conditions

A new catalyst, ruthenium-tin-alumina is found to selectively hydrogenate oleic acid to 9-octadecen-1-ol (oleyl + elaidyl alcohol) at low pressure with high yield. Catalyst preparation methods, catalyst raw materials and activation conditions have a significant effect on the activity of the catalyst. The optimum atomic ratio of ruthenium to tin is about 1:2. Catalyst prepared by an improved sol-gel method shows higher activity and selectivity than catalysts prepared by impregnation and coprecipitation methods. Chloride is found to have a negative effect on catalytic activity. The best catalyst is prepared from chloride-free ruthenium and tin raw materials. Under the optimum reaction conditions of 250°C and 5.6 MPa, the selectivities for 9-octadecen-1-ol and total alcohol (9-octadecen-1-ol + stearyl alcohol) formation are 80.9% and 97%, respectively, at a conversion of 81.3%.     

Relationship between local immune response to Helicobacter pylori and the diversity of disease: investigation of H. pylori-specific IgA in gastric juice

In order to evaluate the relationship between local immune response to Helicobacter pylori and the diversity of disease, 77 asymptomatic subjects who underwent a health examination were studied. Helicobacter pylori-specific IgG in serum and H. pylori-specific IgA in gastric juice were measured by ELISA, and the measured IgA titre was classified into two grades, low or high. Histological classification of gastritis was performed according to the Sydney system. Cytokines in gastric juice were also measured, and the cytotoxin-associated gene A (cagA) status of H. pylori was tested by PCR. Of the 65 subjects who were positive for H. pylori-specific IgG in serum, 38 (58.5%) were classified as H. pylori-specific IgA low titre in gastric juice and 27 (41.5%) had high titres. In the IgG-positive, IgA-low group, the rate of peptic ulcers (especially duodenal ulcers) in endoscopic findings was higher (P < 0.05); the score of activity and the density of H. pylori were higher (P < 0.001 and P < 0.05, respectively); the score of metaplasia was lower (P < 0.05); and the level of interleukin-1 beta was lower (P < 0.05) than in the IgG-positive, IgA-high group. The positive rate of the cagA gene was 84.4% and there was no significant difference between the two groups. There were differences in endoscopic and histological findings between the IgG-positive, IgA-low and the IgG-positive, IgA-high groups. It is suggested that persons infected with H. pylori can be divided into two different states of disease according to local immune response.     

The effect of furosemide on evoked otoacoustic emissions in guinea pigs

After recording transiently evoked otoacoustic emissions (TEOAEs) to a click stimulus in guinea pigs by using the IL088 which was developed by Bray and Kemp (1987) for easy recording and analysis of TEOAE, the changes after intravenous administration of furosemide (30 mg/kg or 50 mg/kg) were examined. The wave of the TEOAE could be detected from 20 of 24 ears (83%). After the i.v. injection of furosemide (30 mg/kg), TEOAE powers (total echo power and highest peak power in FFT pictures) decreased quickly and showed minimum values after 5-10 min. Then they increased rapidly and recovered normally within 60 min after injection. However, no ears showed TEOAEs during the 5- to 10-min period following the injection of the 50-mg/kg dose of furosemide. They then recovered slowly as compared with the group treated with the lower dose of furosemide (30 mg/kg). These changes are similar to those of the endocochlear potential (EP) after furosemide injection. These data support the notion that the EP can contribute to the mechanism of TEOAE generation.