Effects of Surface Concentration on Drying Behavior of Carbohydrate Solutions

As the surface properties of the drying materials are very important not only for the drying rate but also for the quality change during drying, the effects of surface concentration on the drying behavior of liquid foods (sugar solutions) were investigated by isothermal drying experiments and by numerical calculation experiments. The isothermal drying experiments with gelled sugar solution systems (sucrose and maltodextrin) were carried out at various relative humidity (RH) values (RH = 0 to 84%). Separate experiments were carried out for determination of the desorption isotherms.

The isothermal drying curves of sugar solutions at RH = 0 to 51% were very similar. Numerical simulations also showed that the drying curves of these sugars at the surface concentration = 0 and 0.1 are almost the same, although the concentration distributions are different.

When a small amount of gelatin was added to sugar solutions, the drying rate decreased remarkably as the gelatin might form a thin film (skin) near the surface, and consequently the retention of ethanol increased.     

Metabolism of tetramethrin isomers in rat: II. Identification and quantitation of metabolites

1. To examine the metabolic fate of (1RS, trans)- or (1RS, cis)-tetramethrin [3, 4, 5, 6-tetrahydrophthalimidomethyl (1RS, trans)- or (1RS, cis)-chrysanthemate], rat was administered a single oral dose of trans- or cis-[alcohol-14C]tetramethrin at dose levels of 2 or 250 mg/kg. 2. The radiocarbon was almost completely eliminated from rat within 7 days after administration in all groups. 14C-recoveries (expressed as percentages relative to the dosed 14C) in faeces and urine were 38-58 and 42-58% respectively in rat administrated trans-[alcohol-14C]tetramethrin, and in faeces and urine were 66-91 and 9-31% respectively in rat administered cis-[alcohol-14C]tetramethrin. 3. Fourteen metabolites found in excreta were purified by using several chromatographic techniques and identified by spectroanalyses (nmr and MS). Five sulphonate derivatives and three dicarboxylic acid derivatives were found. 4. The main metabolites were sulphonate derivatives in the faeces, and in the urine, alcohols, dicarboxylic acid and reduced metabolites derived from the 3,4,5,6-tetrahydrophthalimide moiety.     

Impulse breakdown voltages of triggered multistage vacuum gap

Several sealed-off triggered vacuum gaps are connected in series to improve hold-off voltage. The characteristics of impulse breakdown voltage of these series-connected gaps are investigated experimentally. The sum hold-off voltage of series-connected gaps decreases to a unit hold-off voltage when the maximum value of voltage division ratio across the gaps increases to unity. Self-breakdown probability of the series-connected gaps is always higher than that of a single gap under the same conditions. Hence, stage efficiency of the multistage gap decreases with increasing number of stages. Its value is 90 percent with 2-stage gap and 75 percent with 5-stage gap, respectively, under the same voltage division ratio and the same gap length (2.0 mm) in each stage. Triggered breakdown voltage of 2- or 3- stage gap is several hundred volts when all gaps are triggered simultaneously at the peak of the main impulse wave and a working voltage range is nearly 100 percent in this case. The working voltage range decreases with number of stages. Its value is 45 percent with 3-stage gap and 15 percent with 5-stage gap, respectively, when one triggered gap is fired for switching.     

Far-Infrared Reflection Spectra of Dielectric Ceramics for Microwave Applications

Far-infrared reflection spectra of dielectric ceramics, BaSm₂Ti₅O₁₄, BaTi₄O₉, and some pcrovskites such as Ba(Zn_1/3Nb_2/3)O₃, have been measured at room temperature using a Fourier transform infrared spectrometer in order to investigate the effect of the crystal structure on the dielectric properties. As for perovskites, Sr(Zn_1/3Nb_2/3)O₃ and Sr(Mg_1/3Nb_2/3)O₃, in which B site ions are ordered, were also measured. Reflectance data were analyzed by means of a factorized form of dielectric functions instead of the classical dispersion theory, and all of the spectra were well fitted. The values of dielectric constants and tan δ calculated from the reflectance data were in good agreement with resonant cavity measurements at 5 GHz. Furthermore, results of this study have shown that the main contribution to the microwave dielectric properties is caused by low-frequency optically active modes located at 50 to about 300 cm⁻¹, and for perovskite structures it is suggested that the ordering of B site ions is significant in obtaining low dielectric losses.     

Functional monomers and polymers, 64. Synthesis of poly-β-alanine from β-alanine, β-alanyl-β-alanine,and β-alanyl-β-alanyl-β-alanine 4-dodecanoyl-2-nitrophenyl esters

Active 4-dodecanoyl-2-nitrophenyl esters of β-alanine, β-alanyl-β-alanine, and β-alanyl-β-alanyl-β-alanine were prepared, and tried to polymerize in various solvents. Nonpolar solvents were found to be convenient for the polycondensation reaction. The yield of the polycondensation was high for the monopeptide ester, and less for the dipeptide and tripeptide esters. The effect of temperature on the polycondensation reaction was also studied.     

Microscopic structure of athabasca oil sand

A refined structural model for in situ oil sands is proposed in terms of the mutual arrangement of sand grains, fines, water and bitumen. In the Athabasca deposit, the sand grains consist mainly of quartz and their packing is such that the porosity is about 35%. In rich oil sand, 10–15% of the pore space is occupied by connate water whereas the remainder is occupied by bitumen. For lower grade oil sands, a direct correlation exists between the water content and the amount of fines (particles smaller than 44 μm) and an inverse correlation exists between the bitumen content and the amount of fines. These relationships are successfully explained in terms of the irreducible water saturation in a porous medium and the double layer interaction between sand and bitumen surfaces.     

Guinea pig bone marrow cells treated with platelet-activating factor generate factor(s) which affects their DNA synthesis and microbicidal activity

We have previously reported that platelet-activating factor (PAF) induces proliferation and microbicidal activity of guinea pig bone marrow cells. In the present study, we have found that the conditioned medium of PAF- or nonmetabolizable PAF agonist-treated guinea pig bone marrow cells augmented DNA synthesis and induced microbicial activity of bone marrow cells. A PAF specific antagonist, CV-6209, inhibited generation of the active conditioned medium by PAF. Addition of the PAF antagonist only partially suppressed the augmentative effect of the active conditioned medium on DNA synthesis; this is consistent with the fact that, because of the rapid breakdown, no appreciable amount of PAF remained in the conditioned medium of PAF-treated cells. Although mouse bone marrow cells did not respond to PAF unlike guinea pig cells, their DNA synthesis was significantly enhanced by the conditioned medium of PAF-treated guinea pig bone marrow cells. Thus, some newly generated factor(s) distinct from the originally inoculated PAF seemed to modulate the bioactions of PAF on bone marrow cells. An appreciable amount of PAF was produced by calcium ionophore-treated guinea pig bone marrow cells. These findings indicate that PAF synthesized in guinea pig bone marrow cells induces generation in the cells of some factor(s) which affects proliferation or microbicidal activity. Presented at The Third International Conference on Platelet-Activating Factor and Structurally Related Ether Lipids, Tokyo, Japan, May 1989.     

New coprimeness over multivariable polynomial matrices and its application to control delay systems

This paper presents a new notion of coprimeness over multivariable polynomial matrices, where a single variable is given priority over the remaining variables. From a characterization through a set of common zeros of the minors, it is clarified that the presented coprimeness is equivalent to weakly zero coprimeness in the particular variable. An application of the presented coprimeness to control systems with non-commensurate delays and finite spectrum assignment is also presented. Because the presented coprimeness is stronger than minor coprimeness, non-commensurate delays are difficult to deal with in algebraic control theory. The “rational ratio condition” between delays, which can reduce non-commensurate delays to commensurate delays, proves to be both powerful and practical concept in algebraic control theory for delay systems.     

Colorimetric microdetermination of sulphites in foods by use of the modified rankine apparatus. IV.

Summary Detection and determination of traces of sulphites in foods was attempted by use of the modified Rankine apparatus and pararosaniline colorimetry. Replacement of alkaline titration reported previously by pararosaniline colorimetry lowered the absolute detection limit from 30 g (titration method) to 2 g. In view of clean analysis, in the color developing system, 0.1 N-sodium hydroxide was used in place of mercuric chloride solution commonly used as an absorbant of sulphites. In order to prevent oxidative decomposition of sulphites during operation, nitrogen gas was used as carrier instead of air. Dimedone and sodium azide were used for the elimination of aldehydes and nitrites, respecitvely, in the sample, which will disturb the color development of sulphites with pararosaniline-formaldehyde reagents. With this improved method, it was possible to determine the residual sulphites in frozen peeled shrimps, sugared beans and other foods with low sulphite contents accurately.

---

Colorimetrische Mikrobestimmung von Sulfiten in Lebensmitteln bei Anwendung der modifizierten IV. Rankine Apparatur

Zusammenfassung Geringe Sulfitmengen in Lebensmitteln (geschälte Garnelen, gezuckerte Bohnen) können colorimetrisch bestimmt werden. Die neuentwickelte Methode beruht auf einer Kombination von colorimetrischer Bestimmung mittels p-Rosanilin und der Bestimmungsmethode nach Rankine. Auf diese Weise lassen sich Gehalte von 2 g noch genau bestimmen. Bei der Farbentwicklung wurde das giftige Quecksilbertetrachlorid durch 0.1 n-NaOH ersetzt, anstelle von Luft Stickstoff als Trägergas verwendet und somit eine Oxydation des Sulfits während der Bestimmung vermieden. Da Nitrit und Aldehyde die Farbentwicklung stören, wurde ihr Einfluß durch Dimedon und Natriumazid ausgeschaltet.

---

---

Studies on the Analyses of Sulphites in Foods (IV)     

Leak-tightness characteristics concerning the containment structures of the HTTR

The containment structures of the HTTR consist of the reactor containment vessel, the service area, and the emergency air purification system, which minimise the release of fission products in postulated accidents, which lead to fission product release from the reactor facilities. The reactor containment vessel is designed to withstand the temperature and pressure transients and to be leak-tight in the case of a rupture of the primary concentric hot-gas duct, etc. The pressure inside the service area is maintained at a negative pressure by the emergency air purification system. The emergency air purification system will also remove airborne radioactivity and will maintain a correct pressure in the service area.The leak-tightness characteristics of the containment structures are described in this paper. The measured leakage rates of the reactor containment vessel were enough less than the specified leakage limit of 0.1%/d confirmed during the commissioning tests and annual inspections. The service area was kept in a way that the design pressure becomes well below its allowable limitation by the emergency air purification system, which filters efficiency of particle removal and iodine removal well over the limited values.The obtained data demonstrate that the reactor containment structures were fabricated to minimise the release of fission products in the postulated accidents with fission product release from the reactor facilities.