Influence of impact-ionization-induced base current reversal onbipolar transistor parameters

In this paper we describe a set of measurements representing a complete characterization of impact-ionization effects in bipolar transistors. We demonstrate that impact-ionization significantly influences the dependence of base resistance on current and voltages applied to the device. A dc method for the simultaneous extraction of all parasitic resistances in bipolar transistors is presented. The method can separate the influence of current-crowding on the base resistance from that of base width and conductivity modulation; the collector parasitic resistance is measured in the active region. Starting from the parameters extracted by means of these techniques, a complete and accurate circuit-model of impact-ionization effects can be defined     

The Simon effect occurs relative to the direction of an attention shift.

We investigated whether the Simon effect depends on the orienting of attention. In Experiment 1, participants were required to execute left-right discriminative responses to 2 patterns that were presented to the left or right of fixation. The 2 patterns were similar, and the discrimination was difficult. A letter at fixation signaled whether the current trial was a catch trial. The results showed a reversal of the Simon effect. That is, spatially noncorresponding responses were faster than spatially corresponding responses. In Experiment 2, the discrimination of the relevant stimulus attribute was easy. In Experiment 3, the discrimination of the relevant stimulus attribute was difficult, but the stimulus exposure time was long. In either experiment, the regular Simon effect was reinstated. In Experiment 4, the letter that signaled a catch trial appeared to the left or right of the imperative stimulus. The Simon effect occurred relative to the position of the letter. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

埃及Ain Sukhna Ezz带钢厂的电弧炉

埃及Ain Sukhna Ezz带钢厂的电弧炉是达涅利公司建造的最大的电弧炉之一,由于可选用多种入炉原料,采用最优化熔炼和精炼方法,可在电弧炉上以转炉生产成本生产转炉优质钢种.     

Removal of fulvic acid from aqueous media by adsorption onto modified vermiculite

Clay minerals are low cost materials that can be structurally modified and exploited for removal of natural organic matter from freshwaters. The present study shows that vermiculites modified by ion exchange with hexadecyltrimethylammonium or intercalation with poly(hydroxy iron) cations are potential adsorbents for removal of fulvic acid, whereas the adsorption on the raw clay mineral is negligible. The efficiency of the modified vermiculite was evaluated by measuring adsorption isotherms by the batch technique using initial fulvic acid concentrations between 2.5 and 50.0 mg L^− 1, with one hour of contact time. At least 94% of the fulvic acid initially present in a 20 mg L^− 1 solution was sorbed onto either the intercalated poly(hydroxy iron) cations or the organically modified vermiculite. Up to an initial concentration of 5.0 mg L^− 1 the adsorption is irreversible, and no quantifiable fulvic acid was measured in the desorption experiments. For initial fulvic acid concentrations between 10.0 and 50.0 mg L^− 1, desorption was between 2.3% and 4.9% for Fe(III) intercalated vermiculite, and between 1.4% and 9.2% for the organoclay. The adsorption percentages on intercalated poly(hydroxy iron) cations increased upon lowering pH and increasing the ionic strength, indicating the occurrence of strong binding mechanisms such as ligand exchange. Adsorption percentage of fulvic acid onto the organoclay also increased with lowering of pH, but in this case the adsorption percentages showed a small decrease at high ionic strength, suggesting that electrostatic attraction plays an important role in the adsorption process.     

Enhancing thermal and dynamic-mechanical properties of epoxy reinforced by amino-functionalized microcrystalline cellulose

In this study, microcrystalline cellulose (MCC) was chemically modified with 3-(aminopropyl)triethoxysilane and added to epoxy to improve chemical, thermal and dynamic-mechanical characteristics of the composites. The composites were manufactured aided by sonication with 1.0%, 2.5%, or 5.0% wt/wt of untreated MCC or amino-functionalized MCC (MCC-Si). The epoxy/MCC-Si composites showed a decrease in the ─OH band by Fourier-transform infrared spectroscopy, and X-ray diffraction analysis indicated better dispersion. The incorporation of MCC-Si in epoxy resin decreased the heat of reaction, increased activation energy values (E_a) and pre-exponential factor (A), and did not affect thermal degradation. All conversion degree (α) versus temperature curves for the composites showed a sigmoidal shape. MCC-Si composites showed better dynamic-mechanical properties than the MCC counterparts, and the functionalization effect was evidenced in storage modulus (E') and loss modulus (E"). At 2.5% wt/wt of MCC-Si content an increase of 119% in E' at the glassy region, 127% in E' at the rubbery region and 173% in E" was observed compared to the neat resin, whereas the T_g barely changed among samples. Good adhesion between the amino-functionalized MCC and the epoxy matrix was observed at the fracture surface, evidencing that surface modification of MCC improves their chemical interaction.     

Aramid pulp treated with imidazolium ionic liquids as a filler in rigid polyurethane bio-foams

This article reports an aramid pulp (AP) treated with two ionic liquids (IL), namely 1-n-butyl-3-methylimidazolium chloride (C₄.Cl) and 1-carboxymethyl-3-methylimidazolium chloride (HO₂C), and its use as a filler in reinforced rigid polyurethane foams (RPUF). The RPUF were incorporated with the treated AP at three weight fractions (c.a. 0.1, 0.5, and 1.0 wt%) and were produced by the free rising method. The results showed that the studied IL promoted a better interaction between the AP and the RPUF system, which increased the overall reactivity, imparting a higher cell anisotropy. This also yielded a positive effect in mechanical properties and thermal stability of the RPUF. Compared to the neat RPUF, outstanding increases of approximately 50 and 20% were achieved in compressive modulus and strength, respectively. In all, the use of IL promoted increased compatibility between matrix and reinforcement, especially that HO₂C IL.     

Optimizing one-shot learning with binary synapses

A network of excitatory synapses trained with a conservative version of Hebbian learning is used as a model for recognizing the familiarity of thousands of once-seen stimuli from those never seen before. Such networks were initially proposed for modeling memory retrieval (selective delay activity). We show that the same framework allows the incorporation of both familiarity recognition and memory retrieval, and estimate the network's capacity. In the case of binary neurons, we extend the analysis of Amit and Fusi (1994) to obtain capacity limits based on computations of signal-to-noise ratio of the field difference between selective and non-selective neurons of learned signals. We show that with fast learning (potentiation probability approximately 1), the most recently learned patterns can be retrieved in working memory (selective delay activity). A much higher number of once-seen learned patterns elicit a realistic familiarity signal in the presence of an external field. With potentiation probability much less than 1 (slow learning), memory retrieval disappears, whereas familiarity recognition capacity is maintained at a similarly high level. This analysis is corroborated in simulations. For analog neurons, where such analysis is more difficult, we simplify the capacity analysis by studying the excess number of potentiated synapses above the steady-state distribution. In this framework, we derive the optimal constraint between potentiation and depression probabilities that maximizes the capacity.     

Tracing pathway activities with kinase inhibitors and reverse phase protein arrays

Controlling aberrant protein kinase activity is a promising strategy for a variety of diseases, particularly cancer. Hence, the development of kinase inhibitors is currently a focal point for pharmaceutical research. In this study we utilize a chip-based reverse phase protein array (RPA) platform for profiling of kinase inhibitors in cell-based assays. In combination with the planar wave-guide technology the assay system has an absolute LOD down to the low zeptomole range. A431 cell lysates were analyzed for the activation state of key effectors in the epidermal growth factor (EGF) and insulin signaling pathways to validate this model for compound screening. A microtiter-plate format for growing, treating, and lysing cells was shown to be suitable for this approach, establishing the value of the technology as a screening tool for characterization of large numbers of kinase inhibitors against a wide variety of cellular signaling pathways. Moreover, the reverse array format allows rapid development of site-specific phosphorylation assays, since in contrast to ELISA type systems only a single antigen-specific antibody is required.