Delay time compensation based on coefficient of restitution for collision hybrid motion simulator

A hybrid motion simulator embeds a hardware experiment in a numerical simulation loop. However, it is often subjected to the inherent problem of an energy increase in the collision of two pieces of hardware in a loop because of the delay time. This paper proposes a delay time compensation method based on contact dynamics model for a collision hybrid motion simulator under delay time and establishes a compensation method for coupled translational and rotational motion. The model developed in this paper describes linear uniform motion of a floating object during the period of the delay time until the force and torque are observed and non-linear motion according to environmental stiffness after the initial delay time period in contact. By using the above model, compensation parameters are designed based on desired coefficient of restitution with iterative calculation. The proposed method achieves accurate delay time compensation and simultaneously realizes a variable desired coefficient of restitution over a wide range of frequencies. Furthermore, the compensation method for multi-dimensional motion is established under the assumption that the friction effect is very small. The efficiency of the proposed method is verified through collision experiments for the coupled motion in two dimensions.     

Low‐Energy Electron Beam Induced Charging and Secondary Electron Emission Properties of FEP Film Used on Satellite Surfaces

Many kinds of insulating materials are used outside a spacecraft. They include FEP films, polyimide films, and so on, and are used as thermal control materials. These materials are exposed to a charged‐particle environment around the spacecraft. Thus then become charged due to charged particles, especially electrons. It has been pointed out that charging of these materials is likely to cause discharges on the surfaces. From this viewpoint, we investigated the charging potential characteristics of 127‐μm‐thick FEP film, a typical thermal control material, by exposing it to electron irradiation at various energies below 20 keV. In the dependence of the charging potential on the electron energy, we found that the electron energy at which no charge‐up occurs is about 2.7 keV. This appears to be the energy at the which secondary electron emission yield becomes unity. This indicates that electron irradiation of FEP film with energies lower than 2.7 keV induces positive charging. From the charge decay characteristics after electron irradiation, the volume resistivity of the film was also obtained as a function of the electric fields in the bulk of the FEP film.     

The Ameliorative Effect of Dexamethasone on the Development of Autoimmune Lung Injury and Mediastinal Fat-Associated Lymphoid Clusters in an Autoimmune Disease Mouse Model

In our previous study, we revealed the ameliorative therapeutic effect of dexamethasone (Dex) for Lupus nephritis lesions in the MRL/MpJ-Fas ^lpr/lpr (Lpr) mouse model. The female Lpr mice developed a greater number of mediastinal fat-associated lymphoid clusters (MFALCs) and inflammatory lung lesions compared to the male mice. However, the effect of Dex, an immunosuppressive drug, on both lung lesions and the development of MFALCs in Lpr mice has not been identified yet. Therefore, in this study, we compared the development of lung lesions and MFALCs in female Lpr mice that received either saline (saline group “SG”) or dexamethasone (dexamethasone group “DG”) in drinking water as a daily dose along with weekly intraperitoneal injections for 10 weeks. Compared to the SG group, the DG group showed a significant reduction in the levels of serum anti-dsDNA antibodies, the size of MFALCs, the degree of lung injury, the area of high endothelial venules (HEVs), and the number of proliferating and immune cells in both MFALCs and the lungs. A significant positive correlation was observed between the size of MFALCs and the cellular aggregation in the lungs of Lpr mice. Therefore, this study confirmed the ameliorative effect of Dex on the development of lung injury and MFALCs via their regressive effect on both immune cells’ proliferative activity and the development of HEVs. Furthermore, the reprogramming of MFALCs by targeting immune cells and HEVs may provide a therapeutic strategy for autoimmune-disease-associated lung injury.     

Evaluating a behavioral demand response trial in Japan: evidence from the summer of 2013

This paper presents results from a behavioral demand response trial targeted to both grid and residential peak hours, in which weekly feedback via paper-based reports, real-time feedback via an in-home display, 30-minute tiered rate, and email prompts are adopted to almost 230 residential customers of a condominium in Funabashi, a city located in Greater Tokyo. Through a randomized experiment, we find that the peak saving impact during grid peak hours (1–4 pm, weekdays only) was 11.6 %, given that all the four interventions provided all at once. In addition, the results show that the variation in peak saving effects by household characteristics exists, and the variation differs among packages of peak saving interventions. Furthermore, we analyzed how much informational elements in weekly reports are considered as useful by residential customers. These results suggest that feedback-based approaches for peak saving can promote households’ energy conservation behavior.     

Thermal conductivity of non-stoichiometric americium oxide: A molecular dynamics study

The aim of this paper is to investigate the influence of multi-valency of americium in its oxide for the lowering of the thermal conductivity and the uncertainty in measurement. In the present study, thermal conductivity of non-stoichiometric americium oxide was evaluated up to 2000 K by the non-equilibrium molecular dynamics calculations using the Born-Mayer-Huggins interatomic potential with the partially ionic model. The oxygen-to-americium ratio (O/Am) was varied from 1.6 to 1.9, which corresponded to the variation of the ratio of Am³⁺/Am⁴⁺. So, we prepared potential parameters for both Am³⁺ and Am⁴⁺. The calculated thermal conductivity of non-stoichiometric americium oxide decreased with an increase of temperature, and the degree of the temperature dependence became smaller with a decrease of the O/Am ratio. This was mainly caused by the phonon-scattering due to oxygen vacancies induced with Am³⁺ ions. Comparing two supercells in which (1) short-range ordered Am³⁺ clusters were contained and (2) Am³⁺ ions were randomly distributed, the thermal conductivity of the former seemed to be somewhat larger than that of the latter.     

Synthesis of Nanohole‐Structured Single‐Crystalline Platinum Nanosheets Using Surfactant‐Liquid‐Crystals and their Electrochemical Characterization

Nanohole‐structured single‐crystalline Pt nanosheets have been synthesized by the borohydride reduction of Na₂PtCl₆ confined to the lyotropic liquid crystals (LLCs) of polyoxyethylene (20) sorbitan monooleate (Tween 80) with or without nonaethylene‐glycol (C₁₂EO₉). The Pt nanosheets of around 4–10 nm in central thickness and up to 500 nm or above in diameter have a number of hexagonal‐shaped nanoholes ∼1.8 nm wide. High‐resolution electron microscope images of the nanosheets showed atomic fringes with a spacing of 0.22 nm indicating that the nanosheets are crystallographically continuous through the nanoholed and non‐holed areas. The inner‐angle distributions for the hexagonal nanoholes indicate that the six sides of the nanoholes are walled with each two Pt (111), Pt (1 1) and Pt (010) planes. The formation mechanism of nanoholed Pt nanosheets is discussed on the basis of structural and compositional data for the resulting solids and their precursory LLCs, with the aid of similar nanohole growth observed for a Tween 80 free but oleic acid‐incorporated system. It is also demonstrated that the nanoholed Pt nanostructures loaded on carbon exhibit fairly high electrocatalytic activity for oxygen reduction reaction and a high performance as a cathode material for polymer‐electrolyte fuel cells, along with their extremely high thermostability revealed through the effect of electron‐irradiation.     

Carbon-supported growth of cross-linked platinum nanowires by surfactant templating and their elecrochemical characterization

Platinum/carbon (Pt/C) composite materials were prepared by the hydrazine reduction of H2PtCl6 confined to a mixed surfactant lytropic liquid crystal (LC)/C mixture with varying amounts of water. The reaction at relatively low water contents successfully yielded cross-linked Pt nanowires with wire-widths of 2-5 nm. The novel Pt nanostructure is believed to be from poorly hydrated hexagonal domains formed together with layered domains by the phase separation of the precursory LC mixture in the presence of carbon. Electrochemical measurements using cyclic volutammetry and membrane electrode assemblies revealed that the cross-linked nanowired Pt/C composite exhibits fairly high electrocatalytic activity for oxygen reduction reaction, as well as a high performance as the cathode material for polymer electrolyte fuel cells.     

Change of chemical states of niobium in the oxide layer of zirconium–niobium alloys with oxide growth

The change of chemical states of niobium with oxide growth was examined in the oxide layers of Zr–2.5Nb around the first kinetic transition by the conversion electron yield – X-ray absorption near-edge structure measurements. The detailed depth profiles of niobium chemical states were obtained in both the pre- and the post-transition oxide layers of Zr–2.5Nb formed in water at 663 K for 40–280 d. The depth profiling revealed that the inner oxide layer remained protective to oxidizing species even though in the post-transition region and this excellent stability of barrierness would be attributed the suppression of hydrogen pickup.