Prenatal development of intrafetal and maternal-fetal synchrony.

Fetal and maternal data were monitored serially at 6 gestational ages from 20 to 38 weeks in 195 Peruvian fetuses. Digitized data included fetal heart rate and motor activity, as well as maternal heart rate and electrodermal conductance. Time series analysis evaluated the development of synchrony in 2 streams of fetal functioning and between mothers and fetuses. Intrafetal synchrony between heart rate and motor activity developed in an orderly fashion, with peak cross-correlation approaching an asymptote at 5 s at 28 weeks. Synchrony was not observed between fetal heart rate and maternal measures. Fetal motor activity exhibited synchrony with both maternal electrodermal and heart rate activity. Implications for revealing fundamental properties of neural development prior to birth are discussed. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Fetal Neurobehavioral Development: A Tale of Two Cities.

Longitudinal neurobehavioral development was examined in 237 fetuses of low-risk pregnancies from 2 distinct populations-Baltimore, Maryland, and Lima. Peru-at 20. 24. 28. 32, 36. and 38 weeks gestation. Data were based on digitized Doppler-based fetal heart rate (FHR) and fetal movement (FM). In both groups. FHR declined while variability, episodic accelerations, and FM-FHR coupling increased, with discontinuities evident between 28 and 32 weeks gestation. Fetuses in Lima had higher FHR and lower variability, accelerations, and FM-FHR coupling. Declines in trajectories were typically observed 1 month sooner in Lima, which magnified these disparities. Motor activity differences were less consistent. No sex differences in fetal neurobehaviors were detected. It is concluded that population factors can influence the developmental niche of the fetus. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Ignition and Charring of PVC-Based Electric Cables

Fire Technology - The ignition of four different PVC-based electric cables was studied using cone calorimeter and the influence of the charring phenomenon on ignition was investigated. The...     

Cable tray FIRE tests simulations in open atmosphere and in confined and mechanically ventilated compartments with the CALIF3S/ISIS CFD software

Fire hazard in nuclear power plants (NPPs) is particularly often investigated as potential cause of safety equipment failure and confinement loss. Many fire events recorded in NPPs involve electric cables, widely used throughout facilities. IRSN is developing the CALIF3S/ISIS computational fluid dynamics software devoted to fire simulation in large‐scale confined and mechanically ventilated compartments. This paper presents two aspects of the CALIF3S/ISIS code ability to simulate fires. The first one concerns vertical and horizontal spreading of a cable tray fire in open atmosphere using an approach based on the FLASH‐CAT cable fire spread model. Resorting to the suitable parameters of the FLASH‐CAT model based on video fire analyses of tests enables to properly compute the heat release rate of the fire. The second aspect concerns the ability to simulate the evolution and consequences of fires in confined and mechanically ventilated compartments. For these cases, the heat release rate measured during the corresponding experiment is used as input data for the calculations. The predicted evolutions of pressure or gas temperatures are in relatively good accordance with the experiments. The major discrepancy concerns gas concentrations in the fire room which is attributed to a lack of information about the properties of the fuel material.     

Carbon nanotubes as photoacoustic molecular imaging agents in living mice

Photoacoustic imaging of living subjects offers higher spatial resolution and allows deeper tissues to be imaged compared with most optical imaging techniques. As many diseases do not exhibit a natural photoacoustic contrast, especially in their early stages, it is necessary to administer a photoacoustic contrast agent. A number of contrast agents for photoacoustic imaging have been suggested previously, but most were not shown to target a diseased site in living subjects. Here we show that single-walled carbon nanotubes conjugated with cyclic Arg-Gly-Asp (RGD) peptides can be used as a contrast agent for photoacoustic imaging of tumours. Intravenous administration of these targeted nanotubes to mice bearing tumours showed eight times greater photoacoustic signal in the tumour than mice injected with non-targeted nanotubes. These results were verified ex vivo using Raman microscopy. Photoacoustic imaging of targeted single-walled carbon nanotubes may contribute to non-invasive cancer imaging and monitoring of nanotherapeutics in living subjects.     

Preparation and characterization of grafted polyethylene based azo-polymer films

A series of grafted azo-polymers was prepared from commercial low density polyethylene thin plates (PE). Polyethylene was reacted in the presence of acryloyl chloride using gamma irradiation to give precursor grafted polymers. These materials were esterified in the presence of six different commercial azo-dyes: (E)-2-(ethyl(4-((4-nitrophenyl)diazenyl)phenyl)amino)ethanol (Disperse Red-1, DR-1), (E)-2-((4-((2-chloro-4-nitrophenyl)diazenyl)phenyl)(ethyl)amino)ethanol (Disperse Red-13, DR-13), (E)-2,2′-(4-((4-nitrophenyl)diazenyl)phenylazanediyl)diethanol (Disperse Red-19, DR-19), (E)-4-((4-nitrophenyl)diazenyl)aniline (Disperse Orange-3, DO-3), 4-((E)-(4-((E)-phenyldiazenyl)naphthalen-1-yl)diazenyl)phenol (Disperse Orange-13, DO-13) and 2-methyl-4-((E)-(4-((E)-phenyldiazenyl)phenyl)diazenyl)phenol (Disperse Yellow-7, DY-7) to give the expected grafted azo-polymer films. The obtained polymers were fully characterized; their thermal, optical properties and morphology were studied. In particular, the influence of the irradiation conditions and the incorporated azo-dye on the polymer properties is discussed.     

Nonlinear System Identification Using Methods for Subspace

The identification of Wiener systems has been an active research topic for years. A Wiener system is a series connection of a linear dynamic system followed by a static nonlinearity. The difficulty in obtaining a representation of the Wiener model is the need to estimate the nonlinear function from the input and output data, without the intermediate signal availability. This paper presents a methodology for the nonlinear system identification of a Wiener type model, using methods for subspaces and polynomials of Chebyshev. The subspace methods used are MOESP （multivariable output-error state space） and N4SID （numerical algorithms for subspace state space system identification）. A simulated example is presented to compare the performance of these algorithms.     

Experimental study of smoke effects on energized electrical cabinets located nearby a lubricant oil pool fire

This paper presents an experimental study of smoke exposure effects on potential malfunction of three electrical cabinets located nearby an oil pool fire. This study was performed as part of the PRISME‐2 international OECD project. Lubricant oil was used as fire source, and three real energized electrical cabinets were used as targets exposed to smoke in the adjacent room to the fire room. The main fire properties, as well as the fire consequences, such as gas temperatures and smoke concentrations in the rooms, and the cabinets are presented in detail. The heat release rate was thus assessed at around 500 kW for nearly all the fire duration, and maximum gas temperatures reached 300°C in the fire room, and 120°C in the adjacent room. Moreover, the maximum gas temperatures and soot mass concentrations inside the cabinets ranged from 90 to 120°C and from 0.3 to 1 g/m³, respectively. Nevertheless, continuous electrical monitoring of the three cabinets did not highlight malfunction. After the experiment, monitoring test of the cabinets was conducted to investigate the potential effects. The isolation resistance of electrical circuits on the most severe smoke exposed cabinet reduced during the monitoring test. It seemed the soot deposition have caused it.