全文获取类型
收费全文 | 54篇 |
免费 | 7篇 |
国内免费 | 5篇 |
专业分类
电工技术 | 1篇 |
综合类 | 4篇 |
化学工业 | 11篇 |
金属工艺 | 6篇 |
机械仪表 | 11篇 |
矿业工程 | 1篇 |
能源动力 | 5篇 |
水利工程 | 1篇 |
石油天然气 | 1篇 |
无线电 | 6篇 |
一般工业技术 | 13篇 |
冶金工业 | 5篇 |
自动化技术 | 1篇 |
出版年
2023年 | 1篇 |
2022年 | 1篇 |
2020年 | 2篇 |
2019年 | 3篇 |
2018年 | 2篇 |
2017年 | 3篇 |
2016年 | 3篇 |
2015年 | 1篇 |
2014年 | 2篇 |
2013年 | 6篇 |
2012年 | 10篇 |
2010年 | 7篇 |
2009年 | 4篇 |
2008年 | 6篇 |
2007年 | 3篇 |
2006年 | 6篇 |
2004年 | 5篇 |
1997年 | 1篇 |
排序方式: 共有66条查询结果,搜索用时 250 毫秒
1.
研究了掺Cu/Ti凝胶的氧化铝胶凝体特性、烧结行为以及微波介电性能.研究发现随着Cu/Ti比的增加,系统成胶凝体条件苛刻,易出现沉淀现象;在(C4H9O)4Ti,(CH3COO)2Cu的乙醇混合溶液中添加Al2O3粉料,Cu/Ti在氧化铝表面形成均质的胶状体;氧化铝的胶状体在750℃热处理后,CuO和TiO2结晶完全,形成Al2O3-CuO-TiO2混合体系,温度升高到1 050℃左右,生成CuO-TiO2低熔点化合物,促使氧化铝烧结温度降至1 360℃以下,剩余的TiO2弥散在氧化铝的晶粒间;以Cu/Ti=0.510的氧化铝胶凝体的综合性能最佳,在1 360℃烧结4 h,其微波介电性能为εr≈10.92,Q×f=30 540 GHz,τf=-5.6×10-6/℃. 相似文献
2.
3.
以不同锆掺杂量的前钙钛矿结构钛酸铅和铁酸钴为原料,采用原位固相烧结法合成了一系列单晶锆钛酸铅-铁酸钴(PZT-CFO)复合纳米纤维。X射线衍射、扫描电子显微镜和能谱分析结果表明,一维单晶PZT-CFO复合纳米纤维同时存在钙钛矿相的锆钛酸铅和尖晶石相的铁酸钴。高分辨透射电子显微镜研究证实锆钛酸铅和铁酸钴之间存在外延生长关系。采用振动样品磁强计对PZT-CFO复合纳米纤维的磁学性能进行测试,发现该复合纳米纤维具有明显的铁磁性能,其剩余磁化强度和矫顽力随着锆掺杂量的增加而增加。 相似文献
4.
采用传统熔体冷却法制备添加不同质量分数(0~3.0%)Bi_2O_3的SiO_2-Al_2O_3-MgO系玻璃,研究Bi_2O_3添加量对玻璃热稳定性、结构稳定性以及物理与力学性能的影响。结果表明:添加Bi_2O_3可有效降低玻璃的软化点;随着Bi_2O_3添加量的增加,玻璃析晶温度与玻璃化转变温度之差先增大后减小,光学带隙先减小后增大,说明玻璃的热稳定性和结构稳定性先提高后降低,同时玻璃的密度、弯曲强度、压缩强度和压缩模量也呈先增大后降低的趋势;当Bi2O3的质量分数为1.5%时,玻璃的结构稳定性、热稳定性、物理与力学性能最优异,此时玻璃析晶温度与玻璃化转变温度之差为244K,光学带隙为3.50eV,密度为2.67g·cm~(-3),弯曲强度为82.72 MPa,压缩强度为236.24MPa,压缩模量为110.06GPa。 相似文献
5.
采用传统熔体冷却法制备TiO2掺杂量(物质的量分数)为0~5.0%的CaO-Al2O3-SiO2(CAS)系玻璃,研究了TiO2掺杂量对该玻璃微观结构、热稳定性、弯曲强度的影响规律。结果表明:TiO2在CAS系玻璃网络中主要以[TiO5]单元的形式存在,随着TiO2掺杂量的增加,玻璃中的[TiO5]单元和Ti-O-Si键数量先增加后降低,玻璃网络中的桥氧数量先增多后减少,玻璃的光学带隙先增大后减小,且均在TiO2掺杂量为4.0%时达到最大值;随着TiO2掺杂量的增加,CAS系玻璃的热稳定性和弯曲强度均先提高后降低,当TiO2掺杂量为4%时综合性能最好,此时玻璃化转变温度、弯曲强度和光学带隙分别为798.24℃,95.58 MPa, 3.75 eV。 相似文献
6.
7.
以硝酸钙、硝酸镁、正硅酸乙酯为先驱体,利用溶胶-凝胶法合成了(Ca0.7Mg0.3)SiO3陶瓷粉体,研究了不同物相和粒径粉体的烧结特性以及陶瓷的微波介电性能.结果表明:干凝胶的煅烧温度低于800°C时,所得粉体士要为尢定型态,煅烧温度超过900°C后,晶相大量形成;当以无定型粉体或900°C煅烧获得的细小粒径粉体为原料时,均难以获得致密结构的陶瓷;形成完整的粉体原料晶相以及粒径的增大,有利于陶瓷体的致密烧结和微波介电性能的提高.粒径分别为50~100nm以及90~300nm的陶瓷粉体,在1320°C烧结后均获得良好的微波介电性能,介电常数Er分别为6.62、6.71,品质因数Q Xf值分别为36962、41842GHz,谐振频率温度系数Tf分别为-48.32 × 106°C、49.63×106/°C. 相似文献
8.
Spectroscopic properties of Er3+/Yb3+-doped transparent oxyfluoride borosilicate glass ceramics containing YOF nanocrystals were systematically investigated. X-ray diffraction (XRD) confirmed the formation of YOF nanocrystals in the glassy matrix. Based on the Judd-Ofelt theory, the intensity parameters Ωi (i=2, 4, 6), spontaneous emission probability, radiative lifetime, radiative quantum efficiency and the effective emission bandwidth were investigated. The upconversion luminescence intensity of Er3+ ions in the glass ceramics increased significantly with the increasing crystallization temperature. The transition mechanisms of the green and red upconversion luminescence were ascribed to a two-photon process, and the blue upconversion luminescence was a three-photon absorption process. 相似文献
9.
Preparation and photoluminescence of Eu-doped oxyfluoride borosilicate glass ceramics 总被引:1,自引:0,他引:1
Eu-doped transparent oxyfluoride borosilicate glass ceramics containing Ba2GdF7 nanocrystals were prepared by controlling crys-tallization of melt-quenched glass fabricated under a reductive atmosphere.In the oxyfluoride borosilicate glass ceramics,the mean crystal size of Ba2GdF7 nanocrystals was about 30 nm,which could be observed by X-ray diffraction(XRD) and transmission electron microscopy analysis.The photoluminescence spectra of the samples excited at 392 nm showed that,besides the characteristic sharp emissions of Eu3+ ions,a very intense broadband emission of Eu2+ ions centered at 450 nm appeared.The photoluminescence intensity of Eu3+ and Eu2+ ions in the glass ceramics was much stronger than that in the as-made precursor.The long decay lifetimes of Eu3+ and Eu2+ ions evidenced the partitions of Eu3+ and Eu2+ ions into the Ba2GdF7 nanocrystals.The energy transfer from Gd3+ ions to Eu3+ and Eu2+ ions was confirmed by the excita-tion and emission spectra. 相似文献
10.
本文主要通过理论分析、实例验证阐述了如何通过调控化学成分、保证金相组织,而获得不经过调质处理,就具有较高弹性模量等机械性能的活塞环。 相似文献