液-液分散性质的研究概况

多相接触器,如反应器、萃取器,其性能无不与相分散的性质有关。分散相尺寸及其分布、相界面积,必然影响两相的流体力学性质、分散相滞存率(hold up)分布和停留时间分布。对于液-液系统而言,液滴的破碎及凝聚速率,对传质效果有重要影响。近年来,溶剂萃取塔的数学模型已有很大进     

振动筛板槽中某些液液分散性质的研究

本文主要对液液分散动力学中的某些重要函数,进行了实验研究.在理论分析及实验数据的基础上,对振动筛板槽中的液滴破碎概率与振动频率、振幅、液滴直径、体系的物理性质以及筛板孔径的关系,进行了关联.探讨了液滴可能发生破碎的临界条件,并根据实验结果,建立了液滴在发生破碎后子滴数的关系式.此外,采用激光平行光技术并与微机结合,在线测量Sauter液滴直径.实验结果与理论计算值相近,并研究了振动频率与振幅对液滴直径的影响.     

一种新型高粘性物料萃取设备

本文讨论了多种形式塔盘结构对粘度高达187～2426cP物料萃取效果的影响。对塔内径为142mm及500mm的萃取塔,分别对转盘、栅板塔盘、齿形塔盘、多孔转盘以及网格塔盘进行静态传质实验。结果说明,网格塔盘传质效果最好。此外,还对塔内径为152mm、高为2m的转盘塔和网格塔进行两相逆流传质实验并进行比较,证明新型网格塔传质效率可提高一倍以上。并获得网格塔传质单元高度与转速、流率、粘度及滞存率等各因素的关联式。     

振动筛板槽中液滴分散动力学的研究——(Ⅱ)实验结果及Monte-Carlo模拟技术的应用

本文根据前文(I)报的理论分析,采用Monte-Carlo方法对实验数据进行模拟.液滴直径的测量采用照相法及透光法.所测得的液滴直径分布数据及平均液滴直径的数据,在微机上进行拟合归纳,得到了振动筛板槽中液滴直径分布模型及液滴平均直径的关联式.模型计算结果与实测值拟合较好.应用Monte-Carlo模拟技术对液滴破碎和凝聚这一随机过程进行了模拟及参数估计,得到了液滴破碎速率及凝聚速率参数.     

振动筛板槽中液滴分散动力学的研究(Ⅰ)实验研究及理论分析

本文通过实验观察发现,液滴的破碎只有在液滴与振动筛板孔口发生碰撞时才发生.基于这个实验现象,建立了振动筛板槽内液滴破碎的新模型.把筛板孔口附近的剪应力作为破碎力,破碎速率可表示为:G(d)=C_12Af/H(?)~n_4(d/d_h)~n_5[1-(d_(cr)/d)~(2n_1+1)]~0.5n(d)液滴的凝聚可以按气体分子碰撞过程来处理.凝聚速率可以用下式表示:ω(d_1,d_2)=C_Ⅱ(d_1+d_2)~(7/3)∈~（1/3)[β_d∈~(2/3)d_1+d_2/σ(d_1+d_2）~（1/3）]~n_6n(d_1)n(d_2)     

Quantitation of the human basal ganglia with positron emission tomography: a phantom study of the effect of contrast and axial positioning

The accurate measurement of the concentration of a radioisotope in small structures with positron emission tomography (PET) requires a correction for quantitation loss due to the partial volume effect and the effect of scattered radiation. To evaluate errors associated with measures in the human basal ganglia (BG), a unilateral model of the BG has been inserted in a 20-cm cylinder. The recovery coefficient (RC=measured activity/true activity) for the BG phantom has been measured on a CTI tomograph with different background concentrations (contrast) and at different axial locations in the gantry. The BG was visualized on four or five slices, depending on its position in the gantry and on the contrast used. The RC was 0.75 with no background (contrast equal to 1.0). Increasing the relative radioactivity concentration in the background increased the RC from 0.75 to 2.00 when the contrast was -0.7 (BG相似文献   

Increased biogas production in a wastewater treatment plant by anaerobic co-digestion of fruit and vegetable waste and sewer sludge - a full scale study

Anaerobic digestion is a well established technology for the reduction of organic matter and stabilization of wastewater. Biogas, a mixture of methane and carbon dioxide, is produced as a useful by-product of the process. Current solid waste management at the city of Prince George is focused on disposal of waste and not on energy recovery. Co-digestion of fresh fruit and vegetable waste with sewer sludge can improve biogas yield by increasing the load of biodegradable material. A six week full-scale project co-digesting almost 15,000 kg of supermarket waste was completed. Average daily biogas production was found to be significantly higher than in previous years. Digester operation remained stable over the course of the study as indicated by the consistently low volatile acids-to-alkalinity ratio. Undigested organic material was visible in centrifuged sludge suggesting that the waste should have been added to the primary digester to prevent short circuiting and to increase the hydraulic retention time of the freshly added waste.     

High-efficiency, argon-laser-pumped Nd:YLF laser system

An Ar-ion laser was used to pump a Nd:YLF laser, in both σ and π polarizations, in a longitudinal scheme. In spite of the small absorption coefficient at the pump (~0.25 cm (-1)), a careful laser design can circumvent this problem, and efficiencies as high as those attained with semiconductor pumping schemes are reported. The laser fundamental parameters were experimentally determined. A double-pass net gain as high as 10(3) was measured, and an output power of 1 W was obtained with a pumping power of 6 W.