Energy-efficient video streaming over Bluetooth using rateless coding

Energy-efficient error control for IEEE 802.15.1 (Bluetooth) video communication is proposed. The scheme is based on block-oriented incremental redundancy provided by rateless coding and receiver feedback. Results are presented for time-sensitive video streaming applications under a Markovian channel model. When the proposed algorithm is compared to variations of Bluetooth forward error control, there are improvements of around 3 dB in received video quality and of over 10% in energy efficiency.     

Selectivity Enhancement to the Exclusive Formation of Ethyltoluenes and Hydrogen During Dehydroalkylation of Toluene with Ethane

The dehydroalkylation of toluene with ethane to the isomeric ethyltoluenes was studied on 0.4Pt/H-ZSM-5 at varying contact times (1/WHSV). At a high contact time of 1.0 h, toluene disproportionation and hydrogenolysis reactions dominate, resulting in low selectivity to the desired ethyltoluenes via the alkylation reaction. However, at a low contact time of 0.12 h side reactions are eliminated, resulting in maximum selectivities to the kinetically favored ethyltoluenes and hydrogen. Results at high selectivities to ethyltoluenes provide significant insight into reaction pathways.     

Formation of toxic aldehydes in cod liver oil after ultraviolet irradiation

Formaldehyde, acrolein, malonaldehyde (MA), acetaldehyde and propanal produced from cod liver oil upon ultraviolet irradiation (λ_max=300 nm) were derivatized into nitrogenor sulfur-containing compounds and then analyzed by capillary gas chromatography with a nitrogen-phosphorus detector or a flame photometric detector. Acrolein and MA were formed at levels of 10.9±3.06 and 190.2±38.4 nmol/mg of fish oil, respectively. Maximum levels of formaldehyde, acetaldehyde and propanal formed were 7.0±0.90, 49.1±4.5 and 35.8±4.0 nmol/mg of oil, respectively. Formation of propanal in large quantities corresponded to the high content of ɛ-3 fatty acids in cod liver oil.     

A 2.5-Gb/s 15-mW clock recovery circuit

This paper describes the design of a 2.5-Gb/s 15-mW clock recovery circuit based on the quadricorrelator architecture. Employing both phase and frequency detection, the circuit combines high-speed operations such as differentiation, full-wave rectification, and mixing in one stage to lower the power dissipation. In addition, a two-stage voltage-controlled oscillator is utilized that incorporates both phase shift elements to provide a wide tuning range and isolation techniques to suppress the feedthrough due to input data transitions. Fabricated in a 20-GHz 1-μm BiCMOS technology, the circuit exhibits an rms jitter of 9.5 ps and a capture range of 300 MHz     

Statistical analysis of fiber-optic CDMA communication systems. I. Device modeling

In this paper, we present a new methodology for analysis of all-optical fiber-optic code-division multiple-access (FO-CDMA) networks. In this analysis, we propose statistical models, based on photon-counting techniques, for some basic elements of the network, such as splitters, combiners, star couplers, and FO-CDMA passive encoders/decoders. By following the statistical variation of the photon-count of the string of pulses that constitutes the address sequence in an FO-CDMA network, we will be able to reveal the quantum-limited optical signal-to-noise ratio (OSNR) required at the transmitter output to meet the performance limits. Moreover, considering receiver thermal noise and source extinction ratio, we explore the role of using an optical preamplifier before the detector and the dependence of the performance on the transmitted power and the weight of the employed optical orthogonal codes (OOCs).     

A 6 GHz 68 mW BiCMOS phase-locked loop

The design of a 6 GHz fully monolithic phase-locked loop fabricated in a 1 μm, 20 GHz BiCMOS technology is described. The circuit incorporates a voltage-controlled oscillator that senses and combines the transitions in a ring oscillator to achieve a period equal to two ECL gate delays. A mixer topology is also used that exhibits full symmetry with respect to its inputs and operates with supply voltages as low as 1.5 V. Dissipating 60 mW from a 2 V supply, the circuit has a tracking range of 300 MHz, an rms jitter of 3.1 ps, and phase noise of -75 dBc/Hz at 1 kHz offset     

Superior vena cava syndrome after heart transplantation: percutaneous treatment of a complication of bicaval anastomoses

The aims of this study were to establish a working rabbit heart model of regional myocardial ischaemia in which electrophysiologic parameters and arrhythmogenesis could be correlated and to explore the mechanisms underlying the antiarrhythmic activity of lignocaine. Monophasic action-potential duration (MAPD90), effective refractory period (ERP), and conduction delay were measured at three ventricular sites in isolated hearts paced at 3.3 Hz. The hearts were treated before and throughout 30 min of ischaemia and 15 min of reperfusion with a vehicle or 20 microM lignocaine. In both groups, ischaemia produced a similar shortening in MAPD90. Lignocaine decreased ERP shortening during ischaemia from -56+/-4 to -32+/-6 ms. An ischaemia-induced increase in conduction delay was greater in the lignocaine than the control group (49+/-7 vs. 11+/-2 ms). Ischaemia-induced dispersion of repolarisation was reduced by lignocaine from 66+/-4 to 32+/-7 ms, and dispersion of refractoriness was decreased from 57+/-6 to 16+/-3 ms. Lignocaine decreased inducibility of ventricular fibrillation (VF) during ischaemia from 86 to 25%. We conclude that, in this model, the antiarrhythmic activity of lignocaine during regional ischaemia is associated with an increase in ischaemia-induced conduction delay and reduced dispersion of repolarisation and refractoriness.     

A 200-MHz 15-mW BiCMOS sample-and-hold amplifier with 3 V supply

A sample-and-hold amplifier designed for the front end of high-speed low-power analog-to-digital converters employs a BiCMOS sampling switch and a low-voltage amplifier to achieve a sampling rate of 200 MHz while allowing input/output voltage swings of 1.5 V with a 3-V supply. The circuit also incorporates a cancellation technique to relax the trade-off between the hold-mode feedthrough and the sampling speed. Fabricated in a 20-GHz 1-μm BiCMOS technology, an experimental prototype exhibits a harmonic distortion of -65 dB with a 10-MHz analog input and occupies an area of 220×150 μm². The measured feedthrough is -52 dB for a 50-MHz analog input and the droop rate is 40 μV/ns     

The approximate solution of charged particle motion equations in oscillating magnetic fields using the local multiquadrics collocation method

The charged particle motion for certain configurations of oscillating magnetic fields can be simulated by a Volterra integro-differential equation of the second order with time-periodic coefficients. This paper investigates a simple and accurate scheme for computationally solving these types of integro-differential equations. To start the method, we first reduce the integro-differential equations to equivalent Volterra integral equations of the second kind. Subsequently, the solution of the mentioned Volterra integral equations is estimated by the collocation method based on the local multiquadrics formulated on scattered points. We also expand the proposed method to solve fractional integro-differential equations including non-integer order derivatives. Since the offered method does not need any mesh generations on the solution domain, it can be recognized as a meshless method. To demonstrate the reliability and efficiency of the new technique, several illustrative examples are given. Moreover, the numerical results confirm that the method developed in the current paper in comparison with the method based on the globally supported multiquadrics has much lesser volume computing.

     

Highly efficient synthesis of coumarin derivatives in the presence of H14[NaP5W30O110] as a green and reusable catalyst

A variety of heteropolyanions including: Keggin, Dawson, Preyssler, mixed addenda and sandwich types, catalyzed the formation of 4-methylnaphtho-(1,2-b)-pyran-2-one (coumarin) from the condensation of α-naphthol and ethylacetoacetate in a solvent free system and under heating conditions. Our data vividly indicate that sodium30–tungsto pentaphosphate, [NaP₅W₃₀O₁₁₀]¹⁴⁻, which so-called Preyssler’s anion, with high hydrolytic (pH 0–12) and thermal stability is the catalyst of choice. This catalyst catalyzed the synthesis of other coumarin derivatives in high yields and good selectivity.