High-purity mullite ceramics, promising engineering ceramics for high-temperature applications, were fabricated using transient liquid phase sintering to improve their high-temperature mechanical properties. Small amounts of ultrafine alumina or silica powders were uniformly mixed with the mullite precursor depending on the silica-alumina ratio of the resulting ceramics to allow for the formation of a transient liquid phase during sintering, thus, enhancing densification at the early stage of sintering and mullite formation by the reaction between additional alumina and the residual glassy phase (mullitization) at the final stage of sintering. The addition of alumina powder to the silica-rich mullite precursor resulted in a reaction between the glassy silica and alumina phases during sintering, thereby forming a mullite phase without inhibiting densification. The addition of fine silica powder to the mullite single-phase precursor led to densification with an abnormal grain growth of mullite, whereas some of the added silica remained as a glassy phase after sintering. The resulting mullite ceramics prepared using different powder compositions showed different sintering behaviors, depending on the amount of alumina added. Upon selecting an optimum process and the amount of alumina to be added, the pure mullite ceramics obtained via transient liquid phase sintering exhibited high density (approximately 99%) and excellent high-temperature flexural strength (approximately 320 MPa) at 1500 °C in air. These results clearly demonstrate that pure mullite ceramics fabricated via transient liquid phase sintering with compositions close to those of stoichiometric mullite could be a promising process for the fabrication of high-temperature structural ceramics used in an ambient atmosphere. The transient liquid phase sintering process proposed in this study could be a powerful processing tool that allows for the preparation of superior high-temperature structural ceramics used in the ambient processing atmosphere. 相似文献
A single-ended amplifier using small packaged GaN-FETs exhibits a record 2.14 GHz W-CDMA output power. The amplifier, composed of paralleled 48 mm gate periphery FET die, delivers a peak saturated output power of 371 W with a linear gain of 11.2 dB at a drain voltage of 45 V under 2.14 GHz 3GPP W-CDMA signal input. The output power density (output power/package size) of 1.1 W/mm/sup 2/ is twice as high as that of the existing over 300 W GaAs-FET amplifiers. A low 5 MHz offset ACLR of -36 dBc with a drain efficiency of 24% is also obtained at 8 dB power back off from the saturated output power. 相似文献
Behaviormetrika - In this paper, we propose a new clustering method based on the concept of maximum likelihood (ML) estimation. In general, the problem of local minima arises when we try to use the... 相似文献
In this paper, we propose a new hierarchical clustering method, which is useful to find appropriate clusters of attributes from given dichotomous or frequency data. Important features of our method are 1) the similarity between two attributes is defined as a probability of their pattern vectors being observed under the hypothesis of independence, 2) for each generated cluster, one pattern vector is defined in a natural manner, and 3) it can be used freely without distinguishing the frequency data from the dichotomous one.
A typical frequency data is analyzed to illustrate how our method works effectively. The discussion on similarities among objects is also included to propose a new similarity measure based on our clustering method.
Here various approaches to understanding the complex relationship among the local atomic arrangements, the distribution of charge/holes and the superconductivity characteristics are discussed for a variety of multi-layered copper-oxide superconductors. Regarding the structural parameters, i.e. bond lengths and angles, no single parameter is revealed to control the superconductivity characteristics alone. As a matter of fact, superconductivity properties are found to be correlated with the whole delicately balanced fine-structure that is described by a set of multiple parameters: it is shown that Tc and Hirr are enhanced in somewhat opposite ways. Expressing the delicately balanced fine-structure through the charge/hole distribution, it is concluded that the more homogeneously distributed the charge carriers are the more enhanced is the Hirr characteristics, while the opposite is likely to apply to the Tc value. 相似文献
We have developed a novel immunoassay method using bacterial magnetic particles for the determination of immunoglobulin G (IgG). Fluorescein isothiocyanate (FITC) conjugated anti IgG-bacterial magnetic particles were prepared. The fluorescence quenching caused by agglutination of FITC-anti IgG antibody-bacterial magnetic particle conjugates was measured by using a fluorescence spectrophotometer. The aggregates based on specific immunoreaction were separated by a gelatin solution. The aggregation of bacterial magnetic particle conjugates was enhanced by application of a magnetic field. The relative fluorescence intensity correlated linearly with a concentration of IgG in the range 0.5-100 ng/mL. 相似文献
The patient was a 83-year-old female with 2' T2-type gastric cancer associated with positive H. pylori in the lesser curvature of the stomach. The patient was treated with oral UFT-E alone in a daily dose of 400 mg. The tumor exhibited an O' IIa + IIc-like appearance 4 weeks after the start of administration and became scarred 8 weeks later, revealing marked tumor reduction in a short period of time. At 8 weeks, biopsy showed marked polymorphonuclear cells infiltration of gastric mucosa with no evidence of malignancy. In an attempt to eradicate H. pylori, 30 mg of lansoprazole, 400 mg of clarithromycin, and 2.0 g of ecabet-Na (3.0 g of Gastrom) were administered for 2 weeks. H. pylori was found to have been successfully eradicated, and the inflammatory lesions were no longer visible histologically. UFT-E was highly effective in this patient, and the eradication of H. pylori may contribute to the prevention of cancer recurrence. 相似文献
Antitumor polyacetylenic alcohol, panaxynol, was isolated and purified from a powder of the root of Panax ginseng C.A. Meyer. Panaxynol inhibited the growth of various kinds of cultured tumor cell lines in a dose-dependent manner. In this paper we demonstrated the first specific antibody production against panaxynol. Anti-panaxynol antibody was elicited in rabbits by immunization with panaxynol hemisuccinate-bovine serum albumin conjugate (panaxynol hemisuccinate-BSA conjugate). An enzyme immunoassay (EIA) for the determination of panaxynol was established using a double-antibody technique. The EIA was highly specific against panaxynol although the antibody showed a minimal cross-reactivity with other types of polyacetylenic alcohol, i.e. panaxydol (12.0%) and panaxytriol (0.77%). Panaxynol at a concentration as low as 6.4 ng/ml can be detected. Using this assay we reconfirmed the rapid consumption of panaxynol by target tumor cells in an in vitro-culture system. The anti-panaxynol antibody may be a valuable tool for studies of the biological properties of polyacetylenic compounds. 相似文献
The constituents in the fruit of Anthriscus sylvestris Hoffm. were investigated, and four lignans [deoxypodophyllotoxin, morelensin, (-)-deoxypodorhizone, and (-)-hinokinin], one phenylpropanoid [1-(3',4'-dimethoxyphenyl)-1 xi-hydroxy-2-propene], two phenylpropanoid esters [3',4'-dimethoxycinnamyl (Z)-2-angeloyloxymethyl-2-butenoate and 3',4'-dimethoxycinnamyl (Z)-2-tigloyloxymethyl-2-butenoate], and one polyacetylenic compound (falcarindiol) were isolated. Their antiproliferative activity against MK-1, HeLa and B16F10 cell lines is reported. 相似文献
An ultrahigh-speed 8 bit multiplexer (MUX) has been developed for future-generation optical-fiber communication systems having a data rate of 20 Gb/s. This IC was fabricated using a 0.5 μm WNx/W-gate GaAs MESFET process based on optical lithography, ion implantation, and furnace annealing for good reproducibility and high throughput. The WNx/W bilayer gate has a low sheet resistance, improving the circuit high frequency performance. To attain 20 GHz operation, advanced circuit techniques for the source-coupled FET logic (SCFL) were introduced. A cross coupled source-follower (CCSF) was developed mainly for the highest speed buffers to enhance the bandwidth. The first-stage T-type flip-flop was designed with optimization techniques and operated up to 21.1 GHz 相似文献