1-GHz-spaced 16-channel arrayed-waveguide grating for a wavelength reference standard in DWDM network systems

We fabricated a 1-GHz-spaced 16-channel arrayed-waveguide grating (AWG) by using a new AWG configuration where the path of each arrayed waveguide winds backward and forward across a 4-in diameter wafer without crossing any other waveguides. The ultra-narrow (< 1 GHz) and stable transmission bands of this AWG can be used to construct a wavelength reference standard covering the S, C, and L bands in the dense wavelength-division-multiplexing network systems whose frequency deviation is /spl plusmn/160 MHz.     

Cover Picture: UV‐Light‐Induced Swelling and Visible‐Light‐Induced Shrinking of a TiO2‐Containing Redox Gel (Adv. Mater. 9/2007)

Polyacrylate gels containing Ag⁺ and TiO₂ nanoparticles are shown to swell under UV light and shrink under visible light in water. In work reported by Tetsu Tatsuma and co‐workers on p. 1249, the TiO₂ absorbs UV light and reduces the Ag⁺, whereas the deposited Ag absorbs visible light and dissolves itself. These redox reactions change the interactions between the polymer chains and eventually the volume of the gel, as shown on the cover.     

Generation of gas bubbles in microflow using micropipette with ultrasound

Ultrasound was applied to a micropipette micromixer to improve dispersion of gas and liquid in a microchannel. Flow visualization using a high-speed camera was performed to examine the effect of ultrasonic irradiation on bubble generation in the microchannel. Basically, nitrogen gas was injected using a (0.5 µm ID) glass micropipette into ethanol flowing in a rectangular (100 µm×200 µm) microchannel on polydimethylsiloxane (PDMS). Gas and liquid flow rates were regulated using mass flow controllers. At aflow condition that is typical of bubbly flow, ultrasound was transmitted into the microchannel using a piezo-electric (PZT) transducer over a range of operating voltages (2 to 200 Vp-p) and frequencies (50 to 60 kHz). Images captured during the action of the PZT transducer indicate that bubble formation is influenced by ultrasound. When subjected to ultrasound above 50 Vp-p and at the resonant frequency of the PZT transducer, bubbles formed that were smaller and closer together, signifying enhanced shearing of the gas at the micropipette tip by the liquid. The observation of gas slugs occurring sooner might be attributed to the coalescence of gas bubbles that became closely spaced.     

Lack of carcinogenicity of medium-viscosity liquid paraffin given in the diet to F344 rats

The carcinogenicity of medium-viscosity liquid paraffin was examined in Fischer 344 rats. Groups of 50 males and 50 females were given the material at dietary doses of 0 (control), 2.5 or 5% for 104 wk. Slight increases in food consumption and body weight were observed in both sexes of the 5% group. However, no significant differences between the control and treated groups were noted with regard to clinical signs, mortality and haematology findings. A variety of tumours developed in all groups, including the control group, but all the neoplastic lesions were histologically similar to those known to occur spontaneously in F344 rats, and no statistically significant increase in the incidence of any tumour type was found for either sex in the treated groups. Granulomatous inflammation in the mesenteric lymph nodes, considered to be a reaction to paraffin absorption, was observed with similar incidence and severity in both sexes of the 2.5 and 5% groups. Thus, it is concluded that under the present experimental conditions, the high dose, about 2000-200,000 times higher than the current temporary acceptable daily intake, does not have any carcinogenic potential in F344 rats. Furthermore, granulomatous inflammation observed in mesenteric lymph nodes were not associated with any development of neoplastic lesions.     

Formation and Characterization of Ce3ZrO8 Prepared by the Hydrazine Method

A compound denoted as (Ce_0.75Zr_0.25)O₂ (Ce, ZrO₈) is formed near room temperature from cerium and zirconium nitrates using hydrazine monohydrate. It has a cubic unit cell with a = 0.5342 nm. Characterization of powders heated to various temperatures at 10°C/min demonstrates that the specific surface area does not decrease below 20 mVg until >1000°C.     

Involvement of brain serotonergic function in lidocaine-induced convulsions in mice

Influences of drug-induced manipulations of central serotonergic function on lidocaine- and pentylenetetrazol (PTZ)-induced convulsions were examined in mice. Agents that suppressed serotonergic transmission increased, whereas drugs that facilitated serotonin (5-HT) function decreased the incidence of lidocaine-induced convulsions. These treatments had similar influences on the incidence of PTZ-induced convulsions. Lidocaine (10(-5)-10(-3) M) reduced the stimulation evoked [3H]5-HT release from cortical slices, followed with an increased spontaneous [3H] overflow at higher concentrations. These results may suggest that brain 5-HT neurons are causally involved as inhibitory neurons in lidocaine-induced convulsions as in the case of PTZ-induced convulsions.     

Rutile-type TiO2 thin film for high-k gate insulator

We investigated rutile-type titanium dioxide (TiO₂) films for possible use as a high-k gate insulator. The TiO₂ thin films were directly deposited on Si substrates using a RF magnetron sputtering method with a sintered oxide target. A single phase of rutile-type TiO₂ whose dielectric constant of approximately 75 was obtained when the film was deposited in an inert gas atmosphere and annealed at 800 °C in an oxidizing gas atmosphere. The oxygen ions were deficient in the as-deposited film, and consequently, a sufficient oxygen supply was needed to crystallize the film to a single phase of rutile during the post-annealing. However, the interfacial SiO₂ layer between the TiO₂ and the Si substrate simultaneously grew thicker than 2 nm. As the interfacial SiO₂ grew, the leakage current was decreased and the equivalent oxide thickness was increased, in the Au/rutile-type TiO₂/Si capacitor. Therefore, we concluded that the growth of the interfacial SiO₂ layer thicker than 2 nm is inevitable to form the single phase of rutile-type TiO₂ and to decrease the leakage.     

A 6-ns ECL 100 K I/O and 8-ns 3.3-V TTL I/O 4-Mb BiCMOS SRAM

The authors report a 4 M word×1 b/1 M word×4 b BiCMOS SRAM that can be metal mask programmed as either a 6-ns access time for an ECL 100 K I/O interface to an 8-ns access time for a 3.3-V TTL I/O interface. Die size is 18.87 mm×8.77 mm. Memory cell size is 5.8 μm×3.2 μm. In order to achieve such high-speed address access times the following technologies were developed: (1) a BiCMOS level converter that directly connects the ECL signal level to the CMOS level; (2) a high-speed BiCMOS circuit with low threshold voltage nMOSFETs; (3) a design method for determining the optimum number of decoder gate stages and the optimum size of gate transistors; (4) high-speed bipolar sensing circuits used at 3.3-V supply voltage; and (5) 0.55-μm BiCMOS process technology with a triple-well structure     

Infrared sensing properties of positive temperature coefficient thermistors with large temperature coefficients of resistivity

Infrared (IR) detecting elements were prepared using positive temperature coefficient (PTC) thermistors with large temperature coefficients of resistivity (α). Their compositions were denoted as Ba_1−x Sr _x Nb_0.003Ti_0.997O₃ + 1 mol % TiO₂ + 0.07 mol %MnO (x=0, 0.2), and their temperature coefficients of resistivity were 78 and 50% K⁻¹, respectively. Their IR sensing properties were measured under the self-regulating heating conditions, and were compared with those of a detector with small α (18 % K⁻¹). It was shown that large α was effective for controlling the element temperature by self-regulating heating and for improving sensitivity. The responsivity,R _v of the element withx=0.2 was 980 VW⁻¹, and was as large as those of pyroelectric detectors. Expressions which normalize the sensitivity and the thermal time constant were derived. From these expressions, criteria for improving some IR sensing properties were obtained.