An important factor affecting synergism on coprocessing of Taiheiyo coal with Athabasca oil sand bitumen

A series of mixtures of Japanese subbituminous Taiheiyo coal and Athabasca oil sand bitumen (AOB) with various coal concentrations (0–100 wt%) was coprocessed in a 70 ml autoclave at 420°C for 1 h in the presence of H₂ (50 kg/cm² at room temperature) and sulfided Ni---Mo/Al₂O₂ catalyst. The mixture containing 2 wt% coal produced the largest amount of hexane soluble fraction (HS) and the smallest amount of benzene insoluble fraction (BI). Thus, a synergistic liquid production occurred for this mixture with 2 wt% coal by suppressing the retrogressive reactions which proceeded for pure AOB. The HS obtained from mixtures with 2–30 wt% showed higher H/C ratios and lower heteroatom contents than those obtained from pure AOB and the mixtures with more than 30 wt% coal. The amounts of transferable hydrogen contained in the mixtures were estimated using anthracene as a hydrogen acceptor. The mixtures with 2–10 wt% coal contained higher amounts of donor hydrogen than pure AOB. The HS yield from the various mixtures was correlated with the amount of donor hydrogens contained in the mixtures, except for the mixture with 10 wt% coal. Thus, the important factor which results in synergism is suggested to be the amount of donor hydrogens contained in the feed mixtures.     

On the sliding and profile of a liquid droplet on a rotating disk

This theoretical and experimental study was conducted to investigate the critical condition at which a liquid droplet starts to move on a rotating disk. The critical rotational speed ω was theoretically calculated based on the force balance between the surface tension and the centrifugal force, where ω was experimentally measured for each combination between three kinds of test plates and test liquids. The movements of droplets were judged from the careful observation of infinitesimal motion of the three‐phase contact line. The calculated rotational speeds agreed well with measured ones for arbitrary contact angle when the droplets were set on the plate. The three‐dimensional surface profiles of droplets were calculated from the approximate Laplace equation in which the contact line was assumed as the combination of two ellipses with different ratio of measure to minor axis. The measured profiles on the rotating disk were approximated well by the method proposed in this study. © 2009 Wiley Periodicals, Inc. Heat Trans Asian Res; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/htj.20276