Effect of CaO–ZrO2 addition to Ni supported on γ-Al2O3 by sequential impregnation in steam methane reforming

Ni catalysts supported on (CaO–ZrO₂)-modified γ-Al₂O₃ were prepared by sequential impregnation. The effects of varied CaO to ZrO₂ mole ratios at 0, 0.20, 0.35, 0.45, and 0.55 on the activity and stability of the modified Ni catalysts were studied. As a result of using CaO–ZrO₂ as a promoter, each catalyst contained CaO–ZrO₂ at only 5%. γ-Al₂O₃ used as support was modified by CaO–ZrO₂ before the deposition of nickel oxide. The addition of CaO–ZrO₂ at an optimum ratio was expected to improve the stability of Ni catalysts due to the decrease of carbon formation resulting from carbon gasification. All the fresh catalysts were characterized by ICP, XRD, BET surface area, TGA in H₂, and TPR before catalytic testing in steam methane reforming at 600 °C. The spent catalysts were examined by TEM and TGA to observe the catalysts deactivation. The identification of CaO–ZrO₂ phases indicated that CaO and ZrO₂ reacted with each other to be monoclinic solid solution ZrO₂, CaZr₄O₉, CaZrO₃, and CaO corresponding to the phase diagram of CaO–ZrO₂. The existence of CaZrO₃ for 0.55 mol ratio of CaO/ZrO₂ enhanced activity in steam methane reforming because oxygen vacancies in CaZrO₃ greatly preferred the water adsorption creating the favorable conditions for carbon gasification and, then, water gas shift. The prominence and continued existence of these two reactions on the Ni catalysts leads to the particular increase of H₂ yield. Moreover, the increasing amount of CaZrO₃ in the Ni catalysts significantly improved carbon gasification. However, the Ni catalysts with CaZrO₃ showed whisker carbon after catalytic testing; this carbon specie has not been tolerated in steam methane reforming. Therefore, these results significantly differed from the hypothesis.     

Fabrication of electrolyte materials for solid oxide fuel cells by tape-casting

In this research, solid oxide fuel cell electrolytes were fabricated by aqueous tape-casting technique. The basic compositions for SOFC electrolyte systems were focused on yttria-stabilized zirconia (YSZ) system. The powders used in this study were from different sources. ZrO₂-based system doped with 3, 8, and 10 mol% of Y₂O₃, and 8YSZ electrolyte tape illustrated the desirable properties. The grain size of the sintered electrolyte tapes was in the range of 0.5–1 μm with 98–99% of theoretical density. Phase and crystal structure showed the pure cubic fluorite structure for 8–10 mol% YSZ and tetragonal phase for 3 mol% doped. The electrolyte tapes sintered at 1450 °C for 4 h had the highest ionic conductivity of 30.11 × 10⁻³ S/cm which was measured at 600 °C. The flexural strengths were in the range of 100–180 MPa for 8–10 mol% YSZ, and 400–680 MPa for 3 mol% YSZ.