Long-term sensor measurements of lung deposited surface area of particulate matter emitted from local vehicular and residential wood combustion sources

Abstract

Lung deposited surface area (LDSA) is a relatively new metric that has been argued to be more accurate at predicting health effects from aerosol exposure. For typical atmospheric aerosol, the LDSA concentration depends mainly on the concentration of ultrafine particles (e.g. vehicular exhaust emissions and residential wood combustion) and therefore optical methods cannot be used to measure and quantify it. The objective of this study was to investigate and describe typical characteristics of LDSA under different urban environments and evaluate how a diffusion charging-based Pegasor AQ Urban sensor (Pegasor Ltd., Finland) can be used as an alternative to optical sensors when assessing local combustion emissions and respective LDSA concentrations. Long-term (12?months) sensor measurements of LDSA were carried out at three distinctly different measurement sites (four sensor nodes) in the Helsinki metropolitan area, Finland. The sites were affected mainly by vehicular exhaust emission (street canyon and urban background stations) and by residential wood combustion (two detached housing area stations). The results showed that the accuracy of the AQ Urban was good (R² = 0.90) for the measurement of LDSA when compared to differential mobility particle sizer. The mean concentrations of LDSA were more than twice as high at the street canyon (mean 22 µm² cm^?3) site when compared to the urban background site (mean 9.4 µm² cm^?3). In the detached housing area, the mean concentrations were 12 µm² cm^?3, and wood combustion typically caused high LDSA peaks in the evenings. High correlations and similar diurnal cycles were observed for the LDSA and black carbon at street canyon and urban background stations. The utilization of a small-scale sensor network (four nodes) showed that the cross-station variability in hourly LDSA concentrations was significant in every site, even within the same detached housing area (distance between the two sites ～670?m).     

Design of High Sensitive Temperature Sensor Based on Two-Dimensional Photonic Crystal

In this effort, a two-dimensional photonic crystal ring resonator (2DPCRR) is simulated. This device is developed for temperature detection in harsh enviro     

Bio-derived fuels may ease the regeneration of diesel particulate traps

Particulate is the most problematic emission from diesel engines. To comply with environmental regulations, these engines are often equipped with particulate traps, which must be regenerated frequently for the sake of efficiency. The regeneration is commonly achieved by rising the temperature in the trap till the particulate self-ignites. However, this method implies energy losses and thermal shocks in the trap. Alternatively, catalysts and additives have been recently considered for reducing the ignition temperature of particulate, but these techniques suffer from poisoning and undesirable byproducts. The present experimental study shows that the ignition temperature of particulate from seed-derived oils (SO) and from blends of SO with diesel fuel oil (DO) can be lower than that of particulate from neat DO. If substantiated by more extensive studies, such finding could have noteworthy implications on the future of fuels and traps.     

Towards a Dual-Tip STM Application in Mesoscopic Electron Transport

A new design for a dual-tip scanning tunneling microscope (STM) is presented. The design is a variation on the mechanically controllable break-junction with two electron beam-induced deposition nano-tips. The new design enables one to scan surfaces simultaneously with two probes having a nano-gap separation. By collecting the lateral current flowing between the tips, the transconductance map can then be compared with the STM images for local characterizations of the electron transport. Since the lateral beam carries the property of the density of states of the surface at momentum space, the dispersion of the electronic structure should give an orientation and position dependence of the local transconductance current. In addition, the reduced terminal separation, on the order of the characteristic mesoscopic length scales, is likely to be sensitive to a variety of typically observed interactions and interference effects.     

Is the development of adenoma and carcinoma in proximal colon related to apolipoprotein E phenotype?

BACKGROUND & AIMS: Alterations in plasma lipoprotein levels and bile acid metabolism observed in patients with colorectal adenoma and carcinoma may reflect a genetic background predisposing to altered lipid metabolism and tumors. This study was designed to determine whether the polymorphism of apolipoprotein E, one of the key regulatory proteins in cholesterol metabolism, is associated with proximal or distal colonic neoplasia. METHODS: Apolipoprotein E phenotype was determined in 135 patients with colorectal adenoma, 122 patients with colorectal carcinoma, and 199 randomly selected control subjects. RESULTS: The frequency of the epsilon 4 allele of apolipoprotein E was low (0.075 and 0.073) in patients with proximal adenoma and those with carcinoma, respectively, compared with the control subjects (0.181) (P < 0.05). In patients with distal tumors, there was no alteration in epsilon 4 frequency. In all subjects with the epsilon 4 allele compared with subjects without epsilon 4, the odds ratio for proximal adenoma was 0.36 (95% confidence interval, 0.14-0.89), and the odds ratio for proximal carcinoma was 0.35 (95% confidence interval, 0.14-0.86). CONCLUSIONS: The data suggest that the epsilon 4 allele of apolipoprotein E provides protection from the development of adenoma and carcinoma of the proximal colon. These results support the theory that there are common susceptibility genes modulating the susceptibility to external carcinogenic factors.     

Hydrogels based on graft copolymers of collagen synthesis

Graft copolymerization of 2-hydroxyethyl methacrylate in combination with hydrophobic monomers onto soluble collagen was employed in the synthesis of hydrogels. The hydrogels were formed by simultaneous graft copolymerization and crosslinking. In order to study the effect of various crosslinking agents on the water retention character of the hydrogels, three different crosslinking agents, namely, N,N′-methylene bis acrylamide, 1,4-butanediol dimethacrylate, and hexamethylene urethanediacrylate were used. Hexamethylene urethanediacrylate crosslinked systems require a minimum amount of crosslinking agent to attain maximum water content in comparison to the other systems.     

UV-shielding by a polyurethane/f-Oil fly ash-CeO2 protective coating

A waste material called oil fly ash (OFA) was acid-functionalized, yielding f-OFA-COOH, which was then reacted with cerium oxide (CeO₂) to make CeO₂-functionalized OFA, or f-OFA-CeO₂. Pristine OFA and f-OFA-CeO₂ were used to make waterborne polyurethane (WBPU) dispersions, referred to as WBPU/OFA and WBPU/f-OFA-CeO₂, respectively, with defined OFA and f-OFA-CeO₂ content. All the dispersions were applied to mild steel as organic coatings to evaluate their protective properties, such as their hydrophobicity, adhesive strength and UV-shielding resistance. These protective properties varied based on the OFA and f-OFA-CeO₂ content. The highest water contact angle, minimum water swelling and maximum adhesive strength were found using WBPU/f-OFA-CeO₂-20 coating (using 2.00 wt% f-OFA-CeO₂), which also showed the maximum ultraviolet (UV) absorption via UV–vis spectroscopy analysis. This UV shielding result also matched field test results, as that coating was found to exhibit the lowest UV degradation near a marine atmosphere, as shown by X-ray photoelectron spectroscopy (XPS) analysis. The least affected hydrophobicity was also recorded for the sample with the WBPU/f-OFA-CeO₂-20 coating.     

A robust estimation approach for uncertain systems with perturbed measurements

This paper deals with state estimation problem for uncertain continuous‐time systems. A numerical treatment is proposed for designing interval observers that ensures guaranteed upper and lower bounds on the estimated states. In order to take into account possible perturbations on the system and its outputs, a new type of interval observers is introduced. Such interval observers consist of two coupled general Luenberger‐type observers that involve dilatation functions. In addition, we provide an optimality criterion in order to find optimal interval observers that lead to tight interval error estimation. The proposed existence and optimality conditions are expressed in terms of linear programming. Also, some illustrative examples are given. Copyright © 2015 John Wiley & Sons, Ltd.     

Preference-based content replacement using recency-latency tradeoff

This work introduces and establishes a new model for cache management, where clients suggest preferences regarding their expectations for the time they are willing to wait, and the level of obsolescence they are willing to tolerate. The cache uses these preferences to decide upon entrance and exit of objects to and from its storage, and select the best copy of requested object among all available copies (fresh, cached, remote). We introduce three replacement policies, each evicts objects based on ongoing scores, considering users’ preferences combined with other objects’ properties such as size, obsolescence rate and popularity. Each replacement algorithm follows a different strategy: (a) an optimal solution that use dynamic programming approach to find the best objects to be kept (b) another optimal solution that use branch and bound approach to find the worst objects to be thrown out (c) an algorithm that use heuristic approach to efficiently select the objects to be evicted. Using these replacement algorithms the cache is able to keep the objects that are best suited for users preferences and dump the other objects. We compare our proposed algorithms to the Least-Recently-Used algorithm, and provide evidence to the advantages of our algorithms providing better service to cache’s users with less burden on network resources and reduced workloads on origin servers.