Influence of the preparation conditions on the size and morphology of nanocrystalline lanthanum orthoferrite

Nanocrystalline LaFeO₃ is prepared by the dehydration of coprecipitated lanthanum and iron(III) hydroxides. It is shown that the behavior of the samples during heating and the size distribution of LaFeO₃ nanocrystals can be considerably different depending on the scheme used for coprecipitation of lanthanum and iron hydroxides; independently of the method employed for coprecipitation of the initial compounds, sintering of the samples at 950°C leads to the formation of lanthanum orthoferrite crystals up to 100 nm in size.     

Effect of vibration condition and inter-particle frictions on the packing of uniform spheres

We present a numerical study of the packing of uniform spheres under three-dimensional vibration using the discrete element method (DEM), focusing on the effects of vibration condition (amplitude and frequency) and inter-particle frictions (sliding and rolling frictions). The results are analysed in terms of packing density, coordination number (CN), radial distribution function (RDF) and pore structure. It is shown that increasing either the vibration amplitude or frequency causes packing density to increase initially to a maximum and then decrease. Both vibration frequency and amplitude should be considered to characterize the effect of vibration process on packing structure. The sliding and rolling frictions between particles can decrease packing density since they dissipate energy, although the effect of rolling friction is less significant. In line with the change of packing density, microstructural properties such as CN, RDF and pore distribution also change: a looser packing often corresponds to smaller CN, less peaked RDF and larger but more widely distributed pores.     

An empirical study of information technology enabled business process redesign and corporate competitive strategy

Business process redesign (BPR) has been widely touted as a means for leveraging the power of information technology to change business processes radically, resulting in substantial improvements in organizational effectiveness and efficiency. This study represents an early attempt at examining the strategic nature of the phenomenon. Because BPR is radical change and has the ability to alter both the competitive and operational nature of the corporation, it is critical that BPR be coordinated with corporate strategy. Through a survey of information system executives, the relationships between corporate competitive strategy and three types of BPR – intrafunctional, interfunctional and interorganizational – were examined. It was found that organizations following a cost strategy tended to do more BPR projects on interfunctional processes. Furthermore, the positive effect of a cost strategy on interfunctional BPR was found to be strengthened by the degree of integration of IS and business planning. It was also found that while interorganizational BPR was not related to a specific strategy, it was strongly related directly with IS–business planning integration.     

镀锌测厚仪

本文叙述了Ｘ射线荧光测厚仪的原理、特点及测量头的设计考虑原则。并以我们研制的两种镀锌测得仪为例作了详细说明。     

HYSIM软件模拟天然气加工工艺流程的研究(Ⅰ)——系统中无循环物流

本文结合大庆油田天然气矿场加工实际生产装置,讨论了应用HYSIM烃类工艺模拟软件对含有不确定组分的体系进行流程模拟计算的特点、塔设备严格模拟计算过程中输入规定的选择、以及多股流换热器和吸附脱水工艺的模拟计算方法。     

Multitemporal passive microwave mapping in MACHYDRO'90

MACHYDR0'90 was an experiment conducted in Pennsylvania in 1990 to study the synergistic use of remote sensors in multitemporal hydrologic studies. As part of this mission the pushbroom microwave radiometer was flown and used to produce brightness temperature maps. Verification studies and vegetation algorithms for mixed land cover areas are described     

纸张用有机硅抗水剂的制备

采用氨基硅油、十二烷基三甲氧基硅烷、甲基三乙氧基硅烷配成11种抗水剂,用于纸张的抗水处理.通过渗透法和接触角法测试发现,有机硅抗水剂对实验选择的9种纸张均有明显的抗水效果;其中采用氨基硅油配制的抗水剂效果最好,经其处理的生宣纸与空白样相比,接触角由完全润湿提高到125°,渗透时间由0提高到18 s.最佳应用工艺为:将氨基硅油配制成质量分数为2.041%的甲苯溶液,按照10g/m2的涂布量喷涂于纸张表面,自然晾干3～5天至恒定质量.     

Comparative study of the elimination of toluene vapours in twin biotrickling filters using two microorganisms Bacillus cereus S1 and S2

BACKGROUND: To investigate the microbial degradation performance of organic pollutants in the atmosphere using a biotrickling filter, two microorganism strains, Bacillus cereus S1 and Bacillus cereus S2, were selected, identified and inoculated into a twin biotrickling filter for comparison. RESULTS: Both strains showed good performance towards the degradation of model organic pollutants when gas flow rates ranged from 100 to 600 L h⁻¹. For S1, the total maximum removal efficiency (RE) of toluene was maintained nearly 100% not only at gas flow rates of 100 L h⁻¹ corresponding to empty bed residence time (EBRT) 199.44 s, but also at gas flow rates of 200 L h⁻¹ (EBRT = 99.72 s) and 300 L h⁻¹ (EBRT = 66.48 s). However, S2 had a much lower degradation capability; near 100% removal efficiency was obtained only at the gas flow rate of 100 L h⁻¹ although both bacteria belong to the same Bacillus cereus. With further increase in gas flow rate, the total REs for both S1 and S2 decreased slightly at first and then dropped sharply to 46% and 35%, respectively, at an EBRT of 33.24 s, corresponding to a gas flow rate of 600 L h⁻¹. Starvation for between 2 and 10 days resulted in the re‐acclimation times of both strains ranging between 1.0 and 15.5 h. CONCLUSION: Strain S1 would be a better choice for inoculation into a biotrickling filter than strain S2, because of its much higher toluene removal capacity and rapid recovery to full performance. Copyright © 2008 Society of Chemical Industry     

THE APPLICATION OF COKELET''''S WAVE THEORY IN THE CALCULATION OF WAVE-CURRENT FIELD

By using Cokelet's wave theory,the limiting wave height and the relative waveangular frequency in wave-current field were calculated in this paper.It is indicated by numeri-cal calculation that if the water depth is not too small,the result given by authors'calculationare very close to the results of limiting wave height by Dalrymple(1975)and to the data of rel-ative wave angular frequency by linear wave theory;but if water depth is rather small,thereare some discrepancy,     

On/off cycling under multiple stresses

The authors describe an experiment, a model, and an analytic method for on/off vs. continuous policy evaluation. The methodology was developed and verified through experimentation. An experimental life-test of small DC motors was designed and performed; it involved on/off cycling vs. continuous operation under multiple stresses. A stress-factor reliability model based on the two-parameter Weibull proportional-hazards life distribution was fitted to the data. The analysis provides an estimate of the model parameters for the life distribution of the DC motors under two operating policies, while under multiple stresses. The characteristic life was related to the explanatory covariates: voltage, on/off cycling, and load. Due to the proportional hazards (common Weibull shape) nature of the model, acceleration factors were calculated to relate the stress levels. The reliability model was extended to develop a simple rule to aid in a decision between on/off cycling and continuous-run policies (to achieve higher reliability). The proposed model (with covariates) allows a much broader approach to reliability modeling than the usual Weibull model (without covariates) because it predicts the reliability under various environmental combinations