Peer drug associations and emotional restraint: Causes or consequences of adolescents' drug use?

A 3-wave longitudinal design was used to examine the relationships among emotional restraint, peer drug associations, and gateway drug use in a sample of 1,256 middle school students. Structural equation modeling was used to compare 3 models: (1) One model viewed drug use as a consequence of emotional restraint and peer variables; (2) 1 viewed drug use as a cause of restraint and peer variables; and (3) 1 included reciprocal effects. All 3 models fit the data fairly well. However, the reciprocal model fit the data significantly better than either of the others. Within this model, low emotional restraint was significantly related to subsequent increases in gateway drug use among boys. In contrast, peer drug models and peer pressure were not related to subsequent changes in gateway drug use. Changes in peer drug models were, however, predicted by previous levels of gateway drug use. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Sequential tripping strategy for a transmission network back-upprotection expert system

This paper describes a sequential tripping strategy used in a wide area back-up protection expert system (BPES) to combat situations in which protection relays have maloperated or information is missing. The BPES is an innovative back-up protection scheme designed to prevent the occurrence of widespread blackouts. The BPES evaluates the certainty that transmission lines are likely to be affected by the fault and uses a sequential tripping strategy to isolate the fault if a firm decision is not available due to maloperated relays and/or missing information. The mode of analysis and the sequential tripping strategy ensures that the BPES will clear a fault at minimum risk to the network. An example is included to demonstrate how the certainty factor based sequential tripping strategy is employed by the BPES to clear a fault which occurred on the South Western part of the UK National Grid System     

Investigation on Single-Mode–Multimode– Single-Mode Fiber Structure

This paper presents an investigation on a single-mode-multimode-single-mode fiber structure. A one-way guided-mode propagation analysis for the circular symmetry waveguide is employed to model the light propagation and the approximated formulations are derived and evaluated concerning the accuracy. Phase conjunction of the multimode interference within the fiber structure is revealed. A simple way to predict and analyze the spectral response of the structure is presented through the space to wavelength mapping with the derived approximated formulations. The prediction of spectral response is verified numerically and experimentally.     

Uniform and optimal schemes for stiff initial-value problems

We formulate a class of difference schemes for stiff initial-value problems, with a small parameter ε multiplying the first derivative. We derive necessary conditions for uniform convergence with respect to the small parameter ε, that is the solution of the difference scheme u_i^h satisfies |u_i^h−u(x_i)| Ch, where C is independent of h and ε. We also derive sufficient conditions for uniform convergence and show that a subclass of schemes is also optimal in the sense that |u_i^h−u(x_i)| C min (h, ε). Finally, we show that this class contains higher-order schemes.     

The evolution of government housing policy: The case of new south Wales 1901–41

This paper sets out the development of four main threads of housing policy in New South Wales from the latter part of the 19th century through the first 40 years of the 20th century. Following a discussion of the social and political circumstances and debate surrounding government policy regarding landlord/tenant relations, housing quality and supply, and owner occupancy, it concludes that policy evolution is irregular and a product of the exigencies of the political process. It also suggests that although government policy did little to improve the housing situation for the underprivileged, there was nevertheless a growing acceptance by both Labor and conservative parties of the increased need for government intervention in the housing market.     

Cellular automata model of gravity-driven granular flows

A cellular automata model is used to simulate a variety of granular chute flows. The model is tested against several case studies: flow down a chute, flow past an obstacle, chute flow in which complex, counter-rotating vortices result in streamwise surface stripes and flow near a boundary. The model successfully reproduces experimental observations in all of these cases. These results lead us to propose that simple, rule-based, models such as this can improve our detailed understanding of dynamics and flow within an opaque granular bed.     

Chromosome 9p deletions in invasive and noninvasive nonfunctional pituitary adenomas: the deleted region involves markers outside of the MTS1 and MTS2 genes

We have screened 57 cases of primary, nonfunctional, pituitary adenomas for loss of heterozygosity of markers on chromosome 9p. Using a panel of 11 microsatellite markers, we found hemizygous deletion with at least one of the markers in 18 tumors (31.5%). The frequency of loss was similar in both noninvasive (8 of 26; 31%) and invasive tumors (10 of 31; 32%), suggesting that loss on this chromosome might be an early event in pituitary tumorigenesis. Two discrete areas of loss were punctuated by a region of retention of heterozygosity between the markers D9S171 and IFNA, indicative of homozygous deletion. However, multiplex PCR analysis (MTS1 and MTS2) and the presence of a 3' untranslated region polymorphism in MTS1 suggested that neither of these tumor suppressor genes was homozygously deleted. In 6 of the 18 tumors showing LOH, sufficient DNA was also available for Southern blot analysis and, in all cases, showed retention of MTS1. Cell mixing experiments of tumor cell DNA homozygously deleted for MTS1 with DNA in which neither copy of the gene was deleted only gave rise to a signal at contamination levels greater than 30% and could discriminate homozygous and hemizygous loss. These studies support the recent findings that mechanisms other than hemi- and homozygous deletion are most likely responsible for the loss of MTS1 gene product in pituitary tumors (M. Woloschak et al., Cancer Res., 56: 2493-2486, 1996.). These data show that losses on either side of 9p21-22, both or either of which may be deleted, are involved in pituitary tumorigenesis and provide evidence for distinct suppressor gene loci, in addition to MTS1, on chromosome 9p.     

Workstation redesign for a repetitive drill press operation: A combined work design and ergonomics approach

A typical or conventional workstation for a repetitive drill press operation was evaluated and subsequently redesigned by incorporating the concepts and principles of work design and ergonomics. The production task comprised of drilling four holes on a prepared steel plate. A methods–time measurement (MTM) analysis was conducted to eliminate unnecessary motions and improve the necessary (work) motions involved in task performance. The specific features of the redesigned workstation were specially designed equipment (jig, fixture, etc.), a suitable adjustable chair, proper work height, a placement of tools/equipment within reach envelope, and a comprehensive operator training method. An experimental investigation was conducted to evaluate and test the redesigned workstation in terms of operator productivity (production quantity and quality output) and satisfaction. The increases in quantity (number of holes drilled) and quality (number of good holes drilled) output were 22 and 50%, respectively, for the redesigned workstation compared to the typical or conventional workstation. The high improvement in quality output (50%) could be attributed to the improved design of the jig and fixture and the comprehensive operator training method, which emphasizes the quality aspect of production output. The improvement in operator satisfaction (scores) were highly significant. This investigation has demonstrated the beneficial effect of a combined work design and ergonomics approach, especially for the redesign of a workstation for a repetitive drill press operation. © 2007 Wiley Periodicals, Inc. Hum Factors Man 17: 395–410, 2007.