Design of 5.9 ghz dsrc-based vehicular safety communication

The automotive industry is moving aggressively in the direction of advanced active safety. Dedicated short-range communication (DSRC) is a key enabling technology for the next generation of communication-based safety applications. One aspect of vehicular safety communication is the routine broadcast of messages among all equipped vehicles. Therefore, channel congestion control and broadcast performance improvement are of particular concern and need to be addressed in the overall protocol design. Furthermore, the explicit multichannel nature of DSRC necessitates a concurrent multichannel operational scheme for safety and non-safety applications. This article provides an overview of DSRC based vehicular safety communications and proposes a coherent set of protocols to address these requirements     

A Monte Carlo simulation study of the mechanical and conformational properties of networks of helical polymers. I. General concepts

We study the mechanical and conformational properties of networks of helical polymers with a combination of Monte Carlo simulations based on the Wang-Landau algorithm and the three-chain model. We find that the stress-strain behavior of these networks has novel features not observed in typical networks made of synthetic polymers. In particular, we find that as these networks are stretched they first strengthen, then soften and finally strengthen again. This non-monotonic behavior of the stress correlates with the one of the helical content and is rationalized by the elongation-induced formation and melting of the helical structure of the polymer. We complement these results with a study of other conformational properties of the polymer strands that clarify the molecular mechanisms behind the mechanical behavior of these networks. Finally, we present a qualitative comparison of some of our results with the theoretical ones recently reported by Kutter and Terentjev.     

Electrical conductivity in iodine-doped ethyl cellulose

The electrical conductivity of solution-grown ethyl cellulose (EC) films, 5–30 μm thick, has been studied in the sandwich configuration (metal–EC–metal) as a function of iodine concentration from 0.5 to 5.0 wt% ratio. The studies were conducted in the temperature range 333–383 K, while the field was varied over the range (3.0–5.5) × 10⁴V/cm. Aluminium was used as the lower electrode, while the upper electrode was of Al, Ag, Cu, Au or Sn. Certain transient effects such as a large burst of current immediately after the application of field were observed. An attempt was made to identify the nature of the current by comparing the observed dependence on electric field, electrode material and temperature with the respective characteristic features of the existing theories of electrical conduction. The results show that the electrical conduction follows Ohm's law at lower fields, while at higher fields, space-charge limited current (SCLC) was observed. It was also found that Richardson–Schottky emission was responsible, to some extent, for the transport of charge carriers in the polymer. The conductivity of the films increased on doping with iodine. The dopant molecules are considered to act as additional trapping centes and provide links between the polymer molecules in the amorphous region, thus resulting in the formation of charge transfer complexes.     

XML: a door to automated Web applications

In Japanese culture, your meishi conveys your place in the company, even in society, as well as your name, phone number, and e-mail address. That is to say, in Japan, business cards matter. They convey complex metadata about the people who carry them. Like people, Web pages come in an abundance of shapes and sizes (and sounds). What makes them machine interpretable-and therefore a new medium for communicating information globally-is Hypertext Markup Language. HTML allows the structural markup of Web documents, distinguishing the elements of a page with tags and declaring the physical relationships among the various document elements. This organizes the display of information and allows humans to read and use it. To give machines this capability, however, requires semantic markup, identifying what each particular element means on its own (for example, “this is a home street address” or “this is an e-mail address”). Semantic markup would change what is now simply displayed content to machine readable, structured content. The Extensible Markup Language (XML) specification, first released as two working drafts in 1997 by the World Wide Web Consortium, makes it dramatically easier to develop and deploy domain- and mission-specific Web pages. We describe the evolution of the Web's data representation from display formats to structural markup to semantic markup     

On the synthesis and characterization of a new manganite type CMR material: La0.7Hg0.3MnO3

A new manganite type CMR material, La_0.7Hg_0.3MnO₃ has been successfully synthesized and has been found to exhibit magnetoresistance (≈9%) at low fields (≈1.5 kG). The synthesis has been carried out through a solid state reaction route consisting of the formation of La_0.7MnO₃ followed by diffusion of Hg leading to La_0.7Hg_0.3MnO₃. The as grown samples are polycrystalline and correspond to an orthorhombic unit cell with the lattice parameters; a=5.5183 Å, b=5.6383 Å and c=7.5368 Å. The typical grain size as revealed by scanning electron microscopy is in the range of 0.5–2 μm. The ρ–T behaviour shows a peak at T_IM=227 K. The ρ–T behaviour above this temperature corresponds to that of an insulator and below this to that of a metal. The ρ–T behaviour remains unaltered when a magnetic field (H_dc=1.5 kG) is applied. However, with this magnetic field a drop in the resistivity is observed up to 77 K. At room temperature the magnetoresistance ratio (MRR) is too small but it steadily increases as the temperature is decreased. Thus, MRRs at 227.13 and 77 K are 3.41 and 9.05%, respectively, in an applied field of H_dc=1.5 kG. At a given temperature the variation in MRR with field H_dc is rapid at lower field values (H_dc<1.2 kG) and scales linearly for higher field values (H_dc>1.2 kG). It may be mentioned that the present work on the synthesis and magnetoresistance behaviour of La_0.7Hg_0.3MnO₃, is the first of its type.     

Hydrodynamics and liquid phase axial mixing in orifice pipe reactor

Two phase flow in a horizontal pipe, with orifice plates placed at regular intervals as obstructions, was studied for the effect of phase velocities on flow patterns, fractional phase hold-ups, pressure drop and liquid phase axial dispersion. Radioactive technetium-99m (as an aqueous solution of sodium pertechnatate) was used as tracer. A pulse injection technique with two point measurements was employed. Three different orifice diameters were used (8 mm, 16 mm, and 20 mm) in a pipe diameter of 32 mm. The orifice spacing was 500 mm in all cases. Superficial gas (air) velocity was varied over a range from 0.02 m/s to 1.0 m/s and superficial liquid (water) velocity from 0.03 m/s to 0.85 m/s. Different flow patterns under different flow conditions were identified and a generalised flow map is presented. Variations in hold-ups and pressure drop with flow patterns have been explained. Rational correlations have been developed for fractional phase hold-ups and pressure drop. A preliminary comparison of two phase gas-liquid flow in a horizontal pipe with orifice obstructions (to be called orifice pipe reactor), as a gas-liquid contacting device, is made with a conventional bubble column reactor. Recommendations have been made for future work.     

Speed Control of DC Motor with MRPID Controller in the Presence of Noise

Speed control of a DC motor has always been a challenge because of its variable torque. But it becomes more challenging when noise enters the system at its input. Therefore, there is a need of more advanced controllers. In this paper, a multi-resolution proportional integral derivative (MRPID) controller has been proposed to be utilized to control the speed of a DC motor. It works well even in the presence of noise as compared to the conventional PID controller. Also, performance of a PID controller deteriorates when nonlinearity or uncertainty arises in the system. This degraded performance can be improved by utilizing the multi-resolution property of wavelets, which decomposes the error signal into various frequency components. Further, wavelet coefficients of these decompositions are used to generate the control signal for controlling speed of a DC motor. In this paper, performances of a MRPID, a fractional order PID (FOPID) and a conventional PID controllers are compared in the presence of noise for speed control of a DC motor. The results obtained using a MRPID controller are observed to be better in terms of improved transient characteristics and disturbance rejection for a DC motor as compared to those obtained with PID and FOPID controllers.

     

Enhanced photoluminescence from CdS nanocrystals encapsulated by PVP and SHMP

The effects of the stabilizing agent on the structural and luminescence properties of cadmium sulfide (CdS) nanocrystals have been investigated. Samples were prepared by chemical precipitation method using sodium hexametaphosphate (SHMP) and polyvinyl pyrrolidone (PVP). The structural and optical properties have been studied by X-ray diffraction (XRD), ultraviolet-visible (UV-Vis) absorption, photoluminescence (PL) and Fourier transform infrared (FTIR) spectroscopy. XRD patterns confirm the presence of cubic zinc blend crystal structure with space group F-43m. The results show the variation in crystallite size with change in surfactant. Blue shift in absorption edge as compared to bulk CdS is found. PL results represent broad and very intense red emission with smaller particle size due to modification of surface emitting states with surfactant.