Time-dependent deformation in an enhanced SiC/SiC composite

Time-dependent deformation in an enhanced SiC/SiC composite has been studied under constant load at high temperatures of 1200 °C, 1300 °C, and 1400 °C. Creep damage evolution was evaluated by a Young’s-modulus change of partial unloading and microscopic observation. The addition of the glassy phase in the matrix is very effective for protecting the composite from oxidation. The transient creep is dominant in creep life at all the temperatures. An empirical equation is proposed to describe creep behavior of the composite. It is found that creep activation energy increases with creep time at stresses lower than matrix cracking stress, but the activation energy remains constant at stresses higher than the matrix cracking stress. The creep strain rate of the composite is considered to be controlled by creep of fibers based on examining the time, strain, stress, and temperature dependencies of creep strain rates.     

Radiation tolerance for the SMASH-series front-end chips for a silicon micro-strip detector

The radiation tolerance for prototype front-end chips designed for a silicon micro-strip detector was examined with a ⁶⁰Co irradiation source to establish an allowable range of the radiation dose. The irradiated front-end chips were SMA²SH-64A, a 64-channel preamplifier array; SMA²SH-1, a single-channel preamplifier circuit with a comparator; and Control-C, a digital-control chip for the preamplifiers.     

Cytokine gene expression after allogeneic bone marrow transplantation

Cytokines produced by T lymphocytes, monocytes/macrophages, and fibroblasts play a central role in the immune response and in the development of graft-versus-host disease (GVHD). Also, it has been reported that dysregulated production of cytokines maybe the primary mediator of clinical manifestation of acute GVHD. Regarding cytokine gene expression after human allogeneic bone marrow transplantation (allo BMT), we have demonstrated increased IL-1 beta, IL-6, and TNF-alpha mRNA expression in peripheral blood mononuclear cells during the development of acute and chronic GVHD and that the degree of the increase was dependent on the severity of the disease. Furthermore, overexpression of these cytokine mRNAs could be detected before the clinical manifestations of GVHD developed. In contrast, IL-2 mRNA expression was not detected in peripheral blood mononuclear cells in GVHD patients. On the other hand, we have reported that increased mRNA expression and protein product of IL-2 and IFN-gamma were evident in the mixed lymphocyte culture of the cases who developed severe lethal transplantation-related complications. Therefore, the detection of increased IL-2 and IFN-gamma gene expression in MLC appeared to be useful for predicting transplantation-related complications in BMT patients. Furthermore, we found increased IL-2 receptor alpha subunit mRNA expression in the peripheral blood mononuclear cells during GVHD. These findings may indicate the important role of inflammatory cytokines such as IL-1 beta, IL-6 and TNF-alpha in the development of the clinical manifestation of GVHD and also may be indicative of the important role of IL-2 and the IL-2 receptor in allo response perhaps mainly as an autocrine effect.(ABSTRACT TRUNCATED AT 250 WORDS)     

Effective thermal conductivity of compressed woods

Compression is one solution to improve the strength of softwoods. The effective thermal conductivities of compressed Japanese cedars (cryptomeria japonica), which were compressed in the radial direction of the wood, were measured. Both the effective thermal conductivities in the tangential and fiber directions increase proportionally to the density increment due to the compression. However, the thermal conductivity in the radial direction (compression direction) increases slightly with the density increment. Numerical computations were conducted to explain the characteristics of thermal conductivity in the radial direction by using a microscopic heat conduction model for the compressed wood. The numerical results were compared with the measured values. And the physical mechanism of the heat conduction in the compressed woods is discussed.     

Development of a single loop EPR test method and its relation to grain boundary microchemistry for alloy 600

A single loop electrochemical potentiokinetic reactivation test method has been developed for alloy 600 that produces good passivation on all the surfaces, good etching during the reactivation scan and no appreciable pitting. It is able to quantify and discriminate between samples with a wide range of degree of sensitization. The Pa value correlates well with the minimum level of chromium in the depletion regions at the grain boundaries. It has been shown that the width of the attacked regions is much larger than the width of chromium depletion regions and it does not show any direct correlation with either depth or width or with a volume parameter of chromium depletion regions. It has been shown that the chromium carbides are not attacked during the test and that the intragranular regions attacked during the test are the sites of chromium carbides in the grain matrix. A modified Pa parameter is shown to be sensitive down to 7.5 wt% chromium in the depletion regions and indicates that the intragranular carbides have shallower depletion profiles than those at grain boundaries. Comparison of the results of the single loop and the double loop tests showed a good correlation.     

Recovery retardation in equal channel angular pressed Al–Zr alloy during friction stir welding

The effect of Zr on reduction of hardness and microstructure in an FS weld of equal channel angular-pressed Al alloy was investigated. Zr addition to Al suppressed dynamic recovery in the thermomechanically affected zone and enabled retention of the high hardness of the ECA-pressed material throughout the weld.     

Drain structure optimization for highly reliable deep submicrometern-channel MOSFET

A guideline for n^- fully gate overlapped (FOLD) structure design optimization has been studied. From the viewpoint of reliability, the greatest reduction in substrate current directly leads to the most reliable n^- design for the FOLD structure. The current path modulation phenomenon due to the trapped charge at the n ^- extension region dominates the hot-carrier induced characteristics change for conventional lightly doped drain (LDD) structure with side-wall spacer. This phenomenon is minimized in the FOLD structure due to its higher controllability of the gate electrode than the LDD structure at the n^- extension region. Furthermore, it was also confirmed that the 0.3 μm optimized FOLD structure can achieve high circuit performance at 3.3 V operation, maintaining hot-carrier resistance     

The heat transfer and pressure drop characteristics of finned tube banks in forced convection (effects of fin height on pressure drop characteristics)

In recent years the requirement for the reduction of energy consumption has been increasing to solve the problems of global warming and the shortage of petroleum resources. For example, in the power generation field, as thermal power generation occupied 60% of the power generation demand, considerable improvement of the thermal efficiency is required. This paper describes the pressure drop characteristics of finned tube banks used for heat exchangers in thermal power generation that were clarified by testing serrated finned tube banks with different fin heights for improved heat transfer and conventional spiral finned tube banks with different fin heights, and an equation to predict pressure drop which is necessary for the heat exchanger design is proposed. © 2006 Wiley Periodicals, Inc. Heat Trans Asian Res, 35(3): 179–193, 2006; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/htj.20112     

Enzymatic degradation of esters of dichloropropanols: removal of chlorinated glycerides from processed foods

The esters of dichloropropanols from the byproduct of hydrolysates during food processing were degraded by the cell-free extracts of a dichloropropanol-assimilating bacterium of Pseudomonas sp. OS-K-29. 1-Acyloxy-2,3-dichloropropane was hydrolysed into the corresponding carbonic acid and 2,3-dichloropropanol, and then the dichloropropanol was dechlorinated. The esterase activity of the cell-free extracts was effective for the esters of the dichloropropanols and monoacylglycerides, but not for hydrolysing the lipase substrates such as triacylglycerides and Tween 60. A comparative study using a series of octanoyl glycerides and the esters of the dichlopropanols showed that the substrate specificities of the cell-free extracts were similar to the monoacylglyceride lipase from Penicillium camembertii.