Electrocoagulation technique in enhancing COD and suspended solids removal to improve wastewater quality.

This paper presents a preliminary study for the removal of COD and suspended solids in wastewater treatment by combining magnetic field and electrocoagulation (EC) technology. The experiments were carried out using batch apparatus and setup in the static method. Batch experiments with two monopolar iron (Fe) plate anodes and cathodes were employed as electrodes. Wastewater samples were prepared from milk powder with an initial COD of 1,140 mgL(-1) and suspended solids of 1,400 mgL(-1) and acidic conditions were employed (pH approximately 3). DC current was varied from 0.5-0.8 A and operating times were between 30 and 50 min. The results show that the effluent wastewater was very clear (turbidity approximately 9 NTU) and its quality exceeded the direct discharge standard. The suspended solids and COD removal efficiencies were as high as 30.6 and 75.5%, respectively. In addition, the experimental results also show that the electrocoagulation could neutralise the pH of wastewater.     

Towards a classification of energy aware MAC protocols for wireless sensor networks

Power management is an important issue in wireless sensor networks (WSNs) because wireless sensor nodes are usually battery powered, and an efficient use of the available battery power becomes an important concern specially for those applications where the system is expected to operate for long durations. This necessity for energy efficient operation of a WSN has prompted the development of new protocols in all layers of the communication stack. Provided that, the radio transceiver is the most power consuming component of a typical sensor node, large gains can be achieved at the link layer where the medium access control (MAC) protocol controls the usage of the radio transceiver unit. MAC protocols for sensor networks differ greatly from typical wireless networks access protocols in many issues. MAC protocols for sensor networks must have built‐in power conservation, mobility management, and failure recovery strategies. Furthermore, sensor MAC protocols should make performance trade‐off between latency and throughput for a reduction in energy consumption to maximize the lifetime of the network. This is in general achieved through duty cycling the radio transceiver. Many MAC protocols with different objectives were proposed for wireless sensor networks in the literature. Most of these protocols take into account the energy efficiency as a main objective. There is much more innovative work should be done at the MAC layer to address the hard unsolved problems. In this paper, we first outline and discuss the specific requirements and design trade‐offs of a typical wireless sensor MAC protocol by describing the properties of WSN that affect the design of MAC layer protocols. Then, a typical collection of wireless sensor MAC protocols presented in the literature are surveyed, classified, and described emphasizing their advantages and disadvantages whenever possible. Finally, we present research directions and identify open issues for future medium access research. Copyright © 2009 John Wiley & Sons, Ltd.     

Two‐sided matching framework for optimal user association in 5G multi‐RAT UDNs

Recently, academic and industrial research communities are paying more explicit attention to the 5G multiple radio access technology ultra‐dense networks (5G multi‐RAT UDNs) for boosting network capacity, especially in UD urban zones. To this aim, in this paper, we intend to tackle the user association problem in 5G multi‐RAT UDNs. By considering the decoupled uplink/downlink access (DUDA), we divide our user association problem into two distinct subproblems representing, respectively, the uplink and the downlink channels. Next, we formulated each one as a nonlinear optimization problem with binary variables. Then, to solve them, we were restricted by the hard complexity, as well as the hard feasibility of centralized user association schemes. Thus, to resolve our user association problem in a reasonable time and distributed manner, we formulated each subproblem as a many‐to‐one matching game based on matching theory. Next, we provide two fully distributed association algorithms to compute the uplink and downlink stable matching among user equipments (UEs) and base stations (BSs). Simulation results corroborate our theoretical model and show the effectiveness and improvement of our achieved results in terms of the overall network performance, quality of service (QoS), and energy efficiency (EE) of UEs.     

Implementation of photovoltaic water pumping system with MPPT controls

To increase the output efficiency of a photovoltaic (PV) system, it is important to apply an efficient maximum power point tracking (MPPT) technique. This paper describes the analysis, the design and the experimental implementation of the tracking methods for a stand-alone PV system, using two approaches. The first one is the constant voltage (CV) MPPT method based on the optimum voltage, which was deduced experimentally, and considered as a reference value to extract the optimum power. The second one is the increment conductance (Inc-Cond) MPPT method based on the calculation of the power derivative extracted by the installation. The output controller can adjust the duty ratio to the optimum value. This optimum duty ratio is the input of a DC/DC boost converter which feeds a set of Moto-pump via a DC/AC inverter. This paper presents the details of the two approaches implemented, based on the system performance characteristics. Contributions are made in several aspects of the system, including converter design, system simulation, controller programming, and experimental setup. The MPPT control algorithms implemented extract the maximum power point (MPP), with satisfactory performance and without steady-state oscillation. MATLAB/Simulink and dSpace DS1104 are used to conduct studies and implement algorithms. The two proposed methods have been validated by implementing the performance of the PV pumping systems installed on the roof of the research laboratory in INSAT Tunisia. Experimental results verify the feasibility and the improved functionality of the system.     

Performance analysis of a double-pass photovoltaic/thermal (PV/T) solar collector with CPC and fins

The use of PV/T in combination with concentrating reflectors has a potential to significantly increase power production from a given solar cell area. A prototype double-pass photovoltaic-thermal solar air collector with CPC and fins has been designed and fabricated and its performance over a range of operating conditions was studied. The absorber of the hybrid photovoltaic/thermal (PV/T) collector under investigation consists of an array of solar cells for generating electricity, compound parabolic concentrator (CPC) to increase the radiation intensity falling on the solar cells and fins attached to the back side of the absorber plate to improve heat transfer to the flowing air. Energy balance equations have been developed for the various nodes of the system. Both thermal and electrical performance of the collector are presented and discussed.     

The potential contribution of renewable energy to electricity supply in Saudi Arabia

Saudi Arabia has enormous oil resources. At the same time, the Kingdom has other resources, notably solar energy that may figure in future supplies of electricity. In the past several years, considerable operational experience has been gained throughout the world in the implementation of renewable energy systems of types that would be relevant to the Kingdom. This paper reviews the nature of this experience and applies it in a quantitative assessment of the costs, savings, and environmental benefits of renewable energy conducted as a part of an electric utility integrated resource planning (IRP) project in the Kingdom. Integrated resource planning is an approach that systematically evaluates potential electricity supply and demand-side resources with the aim of developing a plan that provides energy services to customers at the least societal cost. The analysis summarized in this paper has shown that, when some of the non-market benefits of renewable energy are also included in the assessment of their overall costs and benefits, a supply expansion plan that includes wind and solar resources can provide energy services for the Kingdom at a lower societal cost than a “Business-as-usual” plan utilizing only fossil-fueled generating resources.     

Best Minimum Summation Scheduler for Long Term Evolution

Resource scheduling in Long Term Evolution (LTE) is an open and rising issue. It has an enormous impact on the entire system performance. Due to the nature of LTE system, the scheduler has to be designed carefully. It has to overcome many challenges such as limited processing time and the high dynamic behavior. This paper proposes a novel scheduling policy for the MAC layer in LTE called the Best Minimum Summation (BMS). The main aim of this scheduling policy is to achieve high performance with low complexity. Three sub-schedulers have been developed. Each one of these schedulers deals with scheduling table in different dimension. The first one operates on the scheduling table through the user dimension (BMS.UE); while the second one operates on the scheduling table through the resource block dimension (BMS.RB). The third scheduler operates on the scheduling table correlating both of these dimensions (BMS.2D). All of the proposed solutions were intensively evaluated in a system level simulator. Three performance metrics were used which are throughput, error rate and fairness. The results have shown that the ability of the BMS.UE scheduler to outperform other existing schedulers of LTE.     

Architectural Design,Improvement, and Challenges of Distributed Software-Defined Wireless Sensor Networks

Wireless Personal Communications - Software-defined networking (SDN) is widely perceived to simplify network management and monitoring. The introduction of the SDN model into wireless sensor...     

Enhancing inter-PMIPv6-domain for superior handover performance across IP-based wireless domain networks

As a network-based localized mobility management protocol, Proxy Mobile IPv6 (PMIPv6) enables a Mobile Host (MH) to roam within a localized domain without MH intervention in the mobility-related signalling. However, the PMIPv6 maintains MH mobility support in a restriction domain. Therefore, whenever the MH roams away from the PMIPv6 domain, its reachability status will be broken-down causing high handover latency and inevitable traffic loss for its communication session. This article proposes a proactive mechanism to mange the MH handover and maintain its data session continually across inter-PMIPv6-domains. The proposed mechanism introduces an intermediate global mobility anchor entity, called, which is responsible to coordinate MH handover as well as redirect its traffic across inter-PMIPv6-domains. Through various simulation evaluations, via ns-2, several experiments were conducted, revealing numerous results that verify the proposed mechanism superior performance over the conventional inter-PMIPv6-domain handover schemes in terms of handover latency, achieved throughput, protocol signalling cost and end-to-end traffic delivery latency.     

An Enhanced A-MSDU Frame Aggregation Scheme for 802.11n Wireless Networks

The main goal of the IEEE 802.11n standard is to achieve a minimum throughput of 100 Mbps at the MAC service access point. This high throughput has been achieved via many enhancements in both the physical and MAC layers. A key enhancement at the MAC layer is frame aggregation in which the timing and headers overheads of the legacy MAC are reduced by aggregating multiple frames into a single large frame before being transmitted. Two aggregation schemes have been defined by the 802.11n standard, aggregate MAC service data unit (A-MSDU) and aggregate MAC protocol data unit (A-MPDU). As a consequence of the aggregation, new aggregation headers are introduced and become parts of the transmitted frame. Even though these headers are small compared to the legacy headers they still have a negative impact on the network performance, especially when aggregating frames of small payload. Moreover, the A-MSDU is highly influenced by the channel condition due mainly to lack of subframes sequence control and retransmission. In this paper, we have proposed an aggregation scheme (mA-MSDU) that reduces the aggregation headers and implements a retransmission control over the individual subframes at the MSDU level. The analysis and simulations results show the significance of the proposed scheme, specifically for applications that have a small frame size such as VoIP.