Synthesis, Characterization, and Formation Process of Na-X Zeolite from Coal Fly Ash

Using the SiO₂ and Al₂O₃ components of the amorphous phase in coal fly ash (Fa), Fa was converted to Na-X zeolites in NaOH-NaAlO₂ solutions by stirring at 35°C for 72 hr and then aging at 85°C for a given period. The molar ratio SiO₂/Al₂O₃ of the starting materials was controlled from 2.0 to 13.2. The resulting materials were characterized by various means. Increasing the SiO₂/Al₂O₃ ratio of the starting material increased the degree of crystallinity of faujasite, exhibiting a maximum at SiO₂/Al₂O₃ = 8.0. The faujasite formed was identified as Na-X zeolite with Si/Al = 1.20. The amorphous phase in Fa was dissolved during the stirring to form a precursor of zeolite, such as amorphous aluminosilicate. The Na-X zeolite was formed by aging for 24 hr, and the degree of crystallinity of this material was increased with the increasing aging period. The cation exchange capacity and specific surface area were increased with the increasing degree of crystallinity of the Na-X zeolites.     

Radiation tolerance for the SMASH-series front-end chips for a silicon micro-strip detector

The radiation tolerance for prototype front-end chips designed for a silicon micro-strip detector was examined with a ⁶⁰Co irradiation source to establish an allowable range of the radiation dose. The irradiated front-end chips were SMA²SH-64A, a 64-channel preamplifier array; SMA²SH-1, a single-channel preamplifier circuit with a comparator; and Control-C, a digital-control chip for the preamplifiers.     

Determination of erythema-effective solar radiation in Japan and Germany with a spore monolayer film optimized for the detection of UVB and UVA--results of a field campaign

A centrifugation method was used to investigate the accumulation of 14C-rifampicin by Staphylococcus aureus and Escherichia coli, and to characterize the mechanism of rifampicin transport into S. aureus. For both species, drug accumulation was rapid with the steady-state concentration (SSC) reached within 40 s of drug exposure. Rifampicin accumulation by S. aureus was temperature and pH dependent; the lower the experimental temperature and the lower the experimental pH, the lower was the concentration of rifampicin accumulated. Accumulation was unaffected by the presence of inhibitors of antibiotic efflux, carbonyl cyanide m-chlorophenylhydrazone (CCCP), dinitrophenol (DNP), or reserpine. Exposure to increasing concentrations of rifampicin suggested that the accumulation process was saturable above a rifampicin concentration of 0.2 mg/L. Michaelis-Menten kinetics gave an apparent Km and Vmax for rifampicin, calculated from a Lineweaver-Burk plot, of 0.05 mg/L (0.06 microM) and 3.8 ng rifampicin per second, respectively. However, calculations suggest that these values reflect those for binding of rifampicin to its target, RNA polymerase.     

Some characteristics of a cellular receptor for virulent infectious bursal disease virus by using flow cytometry

A flow cytometric virus binding assay that directly visualizes the binding of infectious bursal disease virus (IBDV) to its target cells was established. The chicken B lymphoblastoid cell line, LSCC-BK3, which is permissive for IBDV infection, bound high levels of the virus. Another B lymphoblastoid cell line, LSCC-1104-B1, bound low levels of the virus, although it was nonpermissive. No virus binding was detected in nonpermissive T lymphoblastoid cell lines. In the binding assay to heterogeneous cell populations of chicken lymphocytes, IBDV (a highly virulent OKYM strain) bound to 94% cells in the lymphocytes prepared from the bursa of Fabricius, 37% cells in those prepared from the spleen, 3% cells in those prepared from the thymus, and 21% cells in those prepared from the blood. Most of the cells, which bound the virus, were surface immunoglobulin M (SIgM)-positive, but a small number of them were SIgM-negative. Additionally, the binding of IBDV to the LSCC-BK3 cells was affected by treatment of the cells with proteases and N-glycosylation inhibitors. These findings may indicate that the IBDV host range is mainly controlled by the presence of a virus receptor composed of N-glycosylated protein associated with the subtle differentiation stage of B-lymphocytes represented mostly by SIgM-bearing cells.     

Plan for first phase of safety demonstration tests of the High Temperature Engineering Test Reactor (HTTR)

Safety demonstration tests using the High Temperature Engineering Test Reactor (HTTR) will be conducted for the purpose of demonstrating inherent safety features of High Temperature Gas-cooled Reactors (HTGRs) as well as providing the core and plant transient data for validation of HTGR safety analysis codes. The first phase safety demonstration test items include the reactivity insertion test and the coolant flow reduction test. In the reactivity insertion test, which is the control rod withdrawal test, one pair out of 16 pairs of control rods is withdrawn, simulating a reactivity insertion event. The coolant flow reduction test consists of the partial loss of coolant flow test and the gas circulators trip test. In the partial loss of coolant flow test, primary coolant flow rate is slightly reduced by control system. In the gas circulators trip test one and two out of three gas circulators are run down, simulating coolant flow reduction events. The gas circulators trip tests, in which position of control rods are kept unchanged, are simulation tests of anticipated transients without scram (ATWS).     

The Atmospheric Scanning Electron Microscope with open sample space observes dynamic phenomena in liquid or gas

Although conventional electron microscopy (EM) requires samples to be in vacuum, most chemical and physical reactions occur in liquid or gas. The Atmospheric Scanning Electron Microscope (ASEM) can observe dynamic phenomena in liquid or gas under atmospheric pressure in real time. An electron-permeable window made of pressure-resistant 100 nm-thick silicon nitride (SiN) film, set into the bottom of the open ASEM sample dish, allows an electron beam to be projected from underneath the sample. A detector positioned below captures backscattered electrons. Using the ASEM, we observed the radiation-induced self-organization process of particles, as well as phenomena accompanying volume change, including evaporation-induced crystallization. Using the electrochemical ASEM dish, we observed tree-like electrochemical depositions on the cathode. In silver nitrate solution, we observed silver depositions near the cathode forming incidental internal voids. The heated ASEM dish allowed observation of patterns of contrast in melting and solidifying solder. Finally, to demonstrate its applicability for monitoring and control of industrial processes, silver paste and solder paste were examined at high throughput. High resolution, imaging speed, flexibility, adaptability, and ease of use facilitate the observation of previously difficult-to-image phenomena, and make the ASEM applicable to various fields.     

Phosphorus flame retardants in indoor dust and their relation to asthma and allergies of inhabitants

Organophosphate esters are used as additives in flame retardants and plasticizers, and they are ubiquitous in the indoor environment. Phosphorus flame retardants (PFRs) are present in residential dust, but few epidemiological studies have assessed their impact on human health. We measured the levels of 11 PFRs in indoor floor dust and multi‐surface dust in 182 single‐family dwellings in Japan. We evaluated their correlations with asthma and allergies of the inhabitants. Tris(2‐butoxyethyl) phosphate was detected in all samples (median value: 580 μg/g in floor dust, 111 μg/g in multi‐surface dust). Tris(2‐chloro‐iso‐propyl) phosphate (TCIPP) was detected at 8.69 μg/g in floor dust and 25.8 μg/g in multi‐surface dust. After adjustment for potential confounders, significant associations were found between the prevalence of atopic dermatitis and the presence of TCIPP and tris(1,3‐dichloro‐2‐propyl) phosphate in floor dust [per log₁₀‐unit, odds ratio (OR): 2.43 and 1.84, respectively]. Tributyl phosphate was significantly associated with the prevalence of asthma (OR: 2.85 in floor dust, 5.34 in multi‐surface dust) and allergic rhinitis (OR: 2.55 in multi‐surface dust). PFR levels in Japan were high compared with values reported previously for Europe, Asia‐Pacific, and the USA. Higher levels of PFRs in house dust were related to the inhabitants' health status.     

Topic allocation method on edge servers for latency-sensitive notification service

The importance of real-time notification has been growing for social services and Intelligent Transporting System (ITS). As an advanced version of Pub/Sub systems, publish-process-subscribe systems, where published messages are spooled and processed on edge servers, have been proposed to achieve data-driven intelligent notifications. In this paper, we present a system that allows a topic to be managed on multiple edge servers so that messages are processed near the publishers, even when publishers spread over a wide area. Duplicating messages on geographically distributed servers could enable immediate notification to neighboring subscribers. However, the duplicated message spool may cause exhaustion of resources. We prepare a formal model of our publish-process-subscribe system and formulate the topic allocation as an optimization problem under the resource constraints of edge servers. As the optimization problem is NP-hard, we propose heuristics leveraging the locality and the pub/sub relationships observed between clients to use the edge server resources efficiently. Our performance evaluation shows that our method reduces the delay to deliver notifications and the effectiveness of the strategy exploiting the relationships between clients.