Modeling and verification of the double frequency effect using a MEMS device

The derivation, verification, and implication of the nonlinear dynamic and frequency response of electrostatic actuator due to the double frequency effect (DFE) were reported in this study. In particular, an extra mode called half mode was observed and measured in various studies. However, a complete in-depth discussion of the effect was not reported in the past. In the present study, a second-order dynamical equation was adapted firstly to model the dynamic and frequency response of electrostatic actuator where typical harmonic input signal with a dc bias was used. Secondly, by solving the equation, complex waveform in dynamic response and an extra half mode in frequency response due to the double frequency effect can be observed and discussed. To verify the simulated result, an electrostatic driving device was fabricated using PolyMUMPS^© process. Note that in frequency response, when dc bias is equal to the amplitude of ac signal, simulated and experimental results indicated that the amplitude of half mode was one-fourth of first mode.     

A novel InP/InGaAs TEBT for ultralow current operations

A novel InP/InGaAs tunneling emitter bipolar transistor (TEBT) is fabricated and demonstrated. The studied device exhibits a very small collector-emitter offset voltage of 40 mV and an extremely wide operation regime. The operation region is larger than 11 decades in magnitude of collector current (10/sup -12/ to 10/sup -1/A). A current gain of 3 is obtained even if the device is operated at an ultralow collector current of 3.9 /spl times/ 10/sup -12/A (1.56 /spl times/ 10/sup -7/A/cm/sup 2/). Furthermore, the common-emitter breakdown voltage of the studied device is higher than 2 V. Consequently, the studied device shows a promise for low supply voltage, and low-power consumption circuit applications.     

Concurrent error detection in array multipliers forGF(2m) fields

Based on Lee-Lu-Lee's array multipliers and the RESO method, a concurrent error detection scheme in array multipliers for GF(2^m ) fields is presented and only one clock cycle is added. The fault tolerant capability in such array multipliers is also included and only two extra clock cycles are required     

Lead content of rice collected from various areas in the world

Rice samples consumed by local populations were collected between 1990 and 1995 in 17 areas in the world, mostly from Asia (10 areas), but also from 7 areas outside of Asia. In total, 1528 samples were obtained (about one half from Japan) and were analyzed for lead (Pb) by electrothermal atomic absorption spectrometry. When the Pb contents in rice samples were classified into 10 areas in Asia, the highest and the lowest geometric means (GMs) were for Indonesia (38 ng/g) and Australia (2 ng/g), respectively. Among 7 regions outside Asia, the GM was highest for Spain (58 ng/g) and the lowest for the USA. (3 ng/g). Moreover, inter-regional differences were significant, when more than 100 samples from one area were divided into 3-9 regions and GMs for regions were compared. There was a marked difference in Pb contents in rice by areas and regions in the world. Nevertheless, comparison by area of the present results with those reported in literature show that there has been no substantial reduction in Pb in rice in the past decade either in Japan or elsewhere in the world.     

Vitamin C elevates red blood cell glutathione in healthy adults

Pre-transplant nephrectomy was done in a 25-year-old man for calculous pyelonephritis using a retroperitoneal laparoscopic approach with a newly devised ligature applicator-dissector- kidney retractor.     

Familial bilateral blepharoptosis and subvalvular aortic stenosis

PURPOSE: To select ideal radiologic projections for mapping and ablation of tachycardias of right ventricular outflow tract (RVOT). METHODS: Ten hearts from human corpses were studied utilizing radiopaque material to identify the pulmonary valve and three distinct sites on this valve: septal anterior (A), septal posterior (P) and free-wall (L). Next, the hearts were filmed in the frontal plane and in oblique projections with 15 degrees increments to the right and to the left. The projections in which the sites were lateralized on the valve, eased radiologic interpretation and were considered ideal for mapping and ablation. Depending on the proximity of the sites to the lateral extremes of the pulmonary valve, the projections were considered ideal ( ), intermediary (++) and inadequate (+). RESULTS: Projections [table: see text] CONCLUSION: The A site of RVOT was best indicated in the 60 and 45 degrees left anterior oblique projections; the 0 degree postero anterior projection was best for mapping the P site; the L region was best explored in the 60 degrees right anterior oblique projection.     

Catalytic oxidation of naphthalene using a Pt/Al2O3 catalyst

Polycylic aromatic hydrocarbons (PAHs) are listed as carcinogenic and mutagenic priority pollutants, belonging to the environmental endocrine disrupters. Most PAHs in the environment stem from the atmospheric deposition and diesel emission. Consequently, the elimination of PAHs in the off-gases is one of the priority and emerging challenges. Catalytic oxidation has been widely used in the destruction of organic compounds due to its high efficiency (or conversion of reactants), its economic benefits and good applicability.

This study investigates the application of the catalytic oxidation using Pt/γ-Al₂O₃ catalysts to decompose PAHs and taking naphthalene (the simplest and least toxic PAH) as a target compound. It studies the relationships between conversion, operating parameters and relevant factors such as treatment temperatures, catalyst sizes and space velocities. Also, a related reaction kinetic expression is proposed to provide a simplified expression of the relevant kinetic parameters.

The results indicate that the Pt/γ-Al₂O₃ catalyst used accelerates the reaction rate of the decomposition of naphthalene and decreases the reaction temperature. A high conversion (over 95%) can be achieved at a moderate reaction temperature of 480 K and space velocity below 35,000 h⁻¹. Non-catalytic (thermal) oxidation achieves the same conversion at a temperature beyond 1000 K. The results also indicate that Rideal–Eley mechanism and Arrhenius equation can be reasonably applied to describe the data by using the pseudo-first-order reaction kinetic equation with activation energy of 149.97 kJ/mol and frequency factor equal to 3.26 × 10¹⁷ s⁻¹.     

Ozonation of CI Reactive Black 5 using rotating packed bed and stirred tank reactor

This study investigates the ozonation of CI Reactive Black 5 (RB5) by using the rotating packed bed (RPB) and completely stirred tank reactor (CSTR) as ozone contactors. The RPB, which provides high gravitational force by adjusting the rotational speed, was employed as a novel ozone contactor. The same ozone dosage was separately introduced into either the RPB or the CSTR for the investigation, while the experimental solution was continuously circulated within the apparatus consisting of the RPB and CSTR. The decolorization and mineralization efficiencies of RB5 in the course of ozonation are compared for these two methods. Moreover, the dissolved and off‐gas ozone concentrations were simultaneously monitored for the further analysis. As a result, the ozone mass transfer rate per unit volume of the RPB was significantly higher because of its higher mass transfer coefficient and gas–liquid concentration driving force. Furthermore, ozonation kinetics was found to be independent of the gravitational magnitude of an ozone gas–liquid contactor. Therefore, the results suggest employing RPBs as ozone‐contacting devices with the advantage of volume reduction. The experimental results, which can be used for further modeling of the ozonation process in the RPB, also show the requirement of correct design for the RPB. Consequently, the present study is useful for the understanding of practical application of RPBs. Copyright © 2004 Society of Chemical Industry