Separation of Indium from Acid Sulfate-Containing Solutions by Ion Exchange with Impregnated Resins

Indium separation using ion exchange resins from acidic polymetallic and very diluted solutions are investigated. Since the selectivity of commercial ion exchange resins have proven to be too low for an effective separation from solutions with high content of other metals, Lewatit® TP 208 was impregnated with common extractants to enhance its properties. By resin impregnation with D2EHPA and Cyanex 272, not only the selective indium recovery was reached but also the resin capacity was increased approx. two times. The best loading and elution performance were shown by Cyanex 272-impregnated Lewatit® TP 208, increasing the indium purity in the eluate from 0.75 % to 85 %.     

Oxidative degradation of polyamide reverse osmosis membranes: Studies of molecular model compounds and selected membranes

Selected aromatic amides were used to model the chemical reactivity of aromatic polyamides found in thin‐film composite reverse osmosis (RO) membranes. Chlorination and possible amide bond cleavage of aromatic amides upon exposure to aqueous chlorine, which can lead to membrane failure, were investigated. Correlations are made of the available chlorine concentration, pH, and exposure time with chemical changes in the model compounds. From the observed reactivity trends, insights are obtained into the mechanism of RO membrane performance loss upon chlorine exposure. Two chemical pathways for degradation are shown, one at constant pH and another that is pH‐history dependent. An alternative strategy is presented for the design of chlorine‐resistant RO membranes, and an initial performance study of RO membranes incorporating this strategy is reported. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 90: 1173–1184, 2003     

Outgassing from stainless steel and the effects of the gauges

The true outgassing from surfaces is often masked by the production of gases and pumping within the measuring gauge. Quadrupole mass analysers have been used to measure the outgassing from carefully prepared samples of stainless steel. By using an isolation pressure rise technique coupled to non-evaporable getter pumping, the problem of production of methane by the gauge is overcome and it has been possible to measure the outgassing of methane to very low levels. The specific outgassing rate of methane from 316 L stainless steel is found to be ?5×10⁻²² mbar l s⁻¹ cm⁻². The outgassing of the other gases has been measured using several gauges. The specific outgassing of hydrogen is found to be 4.5×10⁻¹⁵ mbar l s⁻¹ cm⁻² and the total of all other gasses amounted to no more than 10% of this figure. Although the measurements of the other gases are more ambiguous than those for methane, it is concluded that, in all probability, only hydrogen is outgassed from stainless steel.     

A point mutation associated with a severe phenotype of neurofibromatosis 2

Neurofibromatosis 2 (NF2) is an autosomal dominant disease characterized by bilateral vestibular schwannomas and other nonmalignant tumors of the brain, spinal cord, and peripheral nerves. Although the average age of onset of NF2 is 20 years, some individuals may become symptomatic in childhood. We studied 5 unrelated NF2 patients who became symptomatic before age 13. All 5 had multiple tumors in addition to vestibular schwannoma, and none had a positive family history. Sequence analysis of the NF2 gene revealed identical nonsense mutation of exon 6 in 3 patients. Because this mutation destroys a restriction enzyme recognition site, genomic DNA from the 2 other children was directly tested for this change and identical alterations were detected. Although the work of our laboratory and others has not, in general, detected identical mutations in unrelated patients, this mutation seems to occur particularly frequently in the pediatric population and thus may be associated with an especially severe phenotype. Restriction analysis in children with NF2 may be a cost effective way of identifying their mutation. Further work is needed to characterize the effects of this change on the NF2 protein product and its relationship to this severe phenotype.     

Integrating R&D and marketing: a comparison of practices in theJapanese and American chemical industries

The authors analyze survey information collected from R&D and marketing managers working for American and Japanese chemical manufacturers. They report three key differences in the R&D marketing relationships between Japanese and American firms. Those differences involve the procedures for allocating the tasks between the functional areas, the activities assigned to each area as a result, and the potential for conflict between the two functions. Specifically, the authors find evidence that R&D departments in Japanese firms have a larger role in new product development than do marketing departments. American firms are not characterized by the same asymmetry in their relationship. Finally, the American firms studied did exhibit a greater potential for conflict between functions     

The hydrogenation of triglycerides using supported alloy catalysts. I. Silica-supported Ni—Ag catalysts

Silica-supported Ni-Ag catalysts with a loading of 2·1·0.6% (w/w) total metal have been prepared using the precursors nickel dimethylglyoxime and silver nitrate by means of a simple impregnation method. The resulting catalysts were activated by calcination at 260°C in air, followed by hydrogen reduction at 450°C. They were then employed for soyabean oil hydrogenation at 1 bar H2 pressure and 160°C in a stirred batch reactor. Characterisation of the catalysts using temperature-programmed reduction and electron microscopy indicated that alloying of nickel and silver had occurred, but metal particle composition, for a given overall composition, varied with metal particle size and smaller metal particles were nickel rich. The hydrogenation activity and selectivity measurements revealed that the catalysts were more active and selective than a commercial nickel catalyst. Furthermore, the specific activities of the alloy catalysts were a maximum for alloys in the range 70–90 at. % Ni. However, the supported alloy catalysts also gave rise to greater trans isomerisation than the commercial catalyst. This is attributed to hydrogen deficiency caused by large triglyceride molecules blocking hydrogen chemisorption on small nickel particles (10–50 Å in diameter), leading to enhanced cis-trans isomerisation.     

Strength and toughness of barium titanate ceramics

The effect of processing variables on the mechanical and electrical properties of holmium-doped barium titanate ceramics with a positive temperature coefficient of resistance has been investigated. This paper contains details of the tests used to measure the mechanical properties of ceramics prepared using four compositional mixes. Two methods of measuring strength were used: diametral compression of disc samples and four-point bending of beam specimens. Fracture toughness was also evaluated using two methods: the failure of single edge-notched (SEN) beams under four-point loading and cracking from a surface indentation with a diamond pyramid indentor. Values of strength ranged from 18 to 82 MPa for the four materials when measured by the diametral compression test. This compared with a range of 35–79 MPa for the same materials tested in pure bending. Fracture toughness values ranged from 0.65 to 0.95 MPa m^1/2 for the SEN specimens and from 1 to 1.8 MPa m^1/2 using the indentation technique on the same samples.     

Penicillin vs. erythromycin in the treatment of diphtheria

PURPOSE: To review the University of Florida experience in treating ependymomas, analyze prognostic factors, and provide treatment recommendations. METHODS AND MATERIALS: Forty-one patients with ependymoma and no metastases outside the central nervous system received postoperative radiotherapy with curative intent between 1966 and 1989. Ten patients had supratentorial lesions, 22 had infratentorial lesions, and 9 had spinal cord lesions. All patients had surgery (stereotactic biopsy, subtotal resection, or gross total resection). Most patients with high-grade lesions received radiotherapy to the craniospinal axis. Low-grade intracranial lesions received more limited treatment. Spinal cord lesions were treated using either partial spine or whole spine fields. RESULTS: Of 32 intracranial tumors, 21 recurred, all at the primary site; no spinal cord tumors recurred. Overall 10-year survival rates were 51% (absolute) and 46% (relapse-free); by tumor site: spinal cord, 100%; infratentorial, 45%; supratentorial, 20% (p = 0.002). On multivariate analysis, tumor site was the only factor that influenced absolute survival (p = 0.0004); other factors evaluated included grade, gender, age, duration of symptoms, resection extent, primary tumor dose, treatment field extent, surgery-to-radiotherapy interval, and days under radiotherapy treatment. CONCLUSIONS: Patients with supratentorial or infratentorial tumors receive irradiation, regardless of grade. Craniospinal-axis fields are used when spinal seeding is radiographically or pathologically evident. Spinal cord tumors are treated using localized fields to the primary site if not completely resected. Failure to control disease at the primary site remains the main impediment to cure.     

Lipolysis of trivernolin by pancreatic lipase

Vernolic acid (cis-12,13-epoxy-cis-9-oetadece-noic acid) occurs as the triglyceride in the seed ofVernonia anthelmintica. Incubation of the seed produces a 1,3-divernolin. To determine whether the structure of trivernolin is responsible for the apparent secondary ester position specificity of the natural enzyme, trivernolin and tri-olein, were incubated with pancreatic lipase and the free fatty acids and monoglycerides were determined after 5 and 15 min digestion periods. The preponderance of 2-monoglyceride produced by the action of pancreatic lipase was interpreted to indicate that the structure of trivernolin was not solely responsible for the secondary position specificity of theV. anthelmintica lipase toward trivernolin.