Integrated modelling under uncertainty in watershed-level assessment and management.

Uncertainty in water quality model predictions is inevitably high due to natural stochasticity, model uncertainty, and parameter uncertainty. An integrated modelling system (modified-BASINS) under uncertainty is described and demonstrated for use in receiving-water quality prediction and watershed management. A Monte Carlo simulation was used to investigate the effect of various uncertainty types on output prediction. Without pollution control measures in the watershed, the concentrations of total nitrogen (T-N) and total phosphorus (T-P) in the Hwaong Reservoir, considering three uncertainty types, would be less than about 4.4 and 0.23 mg L(-1), respectively, in 2012, with 90% confidence. The effects of two watershed management practices, wastewater treatment plants (WWTP) and constructed wetlands (WETLAND), were evaluated. The combined scenario (WWTP + WETLAND) was the most effective at improving reservoir water quality, bringing concentrations of T-N and T-P in the Hwaong Reservoir to less than 3.4 and 0.14 mg L(-1), 24 and 41% improvements, respectively, with 90% confidence. Overall, the Monte Carlo simulation in the integrated modelling system was practical for estimating uncertainty and reliable in water quality prediction. The approach described here may allow decisions to be made based on the probability and level of risk, and its application is recommended.     

Preparation of PbTiO3 thin films using an alkoxide-alkanolamine sol-gel system

The stable range of PbTiO₃ sol and the processing conditions of uniform thin films were investigated using a solution of titanium isopropoxide, three kinds of alkanolamines (monoethanolamine, diethanolamine, triethanolamine), lead acetate trihydrate and isopropanol. Depending on the sol state with various alkanolamine/alkoxide molar ratios, diethanolamine (DEA) was very effective in preparing uniform and dense oxide films through room-temperature reaction, owing to its superior stability during the hydrolysis and condensation reaction. Perovskite PbTiO₃ thin films were obtained on oxidized silicon wafer above 550 °C and completely pure films were obtained at 650 °C using DEA as a complexing agent. The dielectric constant and loss tangent of these thin films fired at 650 °C for 30 min were found to be 240 and 0.01 at 1 kHz, respectively.     

Psychiatric document retrieval using a discourse-aware model

With the increased incidence of depression-related disorders, many psychiatric websites have been developed to provide huge amounts of educational documents along with rich self-help information. Psychiatric document retrieval aims to assist individuals to locate documents relevant to their depressive problems efficiently and effectively. By referring to relevant documents, individuals can understand how to alleviate their depression-related symptoms according to recommendations from health professionals. This work proposes the use of high-level discourse information extracted from queries and documents to improve the precision of retrieval results. The discourse information adopted herein includes negative life events, depressive symptoms and semantic relations between symptoms, which are beneficial for better understanding of users' queries. Experimental results show that the discourse-aware retrieval model achieves higher precision than the word-based retrieval models, namely the vector space model (VSM) and Okapi model, adopting word-level information alone.     

Direct vapor phase growth process and robust photoluminescence properties of large area MoS2 layers

There has been growing research interest in the use of molybdenum disulfide in the fields of optoelectronics and energy harvesting devices, by virtue of its indirect-to-direct band gap tunability. However, obtaining large area thin films of MoS2 for future device applications still remains a challenge. In the present study, the amounts of the precursors （S and MOO3） were varied systematically in order to optimize the growth of highly crystalline and large area MoS2 layers by the chemical vapor deposition method. Careful control of the amounts of precursors was found to the key factor in the synthesis of large area highly crystalline flakes. The thickness of the layers was confirmed by Raman spectroscopy and atomic force microscopy. The optical properties and chemical composition were studied by photoluminescence （PL） and X-ray photoelectron spectroscopy. The emergence of strong direct excitonic emissions at 1.82 eV （A-exciton, with a normalized PL intensity of -55 × 10^3） and 1.98 eV （B-exciton, with a normalized PL intensity of -5 × 10^3） of the sample at room temperature clearly indicates the high luminescence quantum efficiency. The mobility of the films was found to be 0.09 cm^2/（V.s） at room temperature. This study provides a method for the controlled synthesis of high-quality two-dimensional （2D） transition metal dichalcogenide materials, useful for applications in nanodevices, optoelectronics and solar energv conversion.     

A new methodology for identification of critical lines using damping sensitivity analysis

When an inter-area mode dominates a low-frequency oscillation in a stressed condition, control of the active power flow of interface lines, with compensating devices, can effectively reduce the electromechanical power oscillations. In general, interface lines in which inter-area oscillations are large are considered to be good locations for installation of compensating devices. A sensitivity analysis with respect to change in active power flow can provide an important factor in electric power system operation. This paper proposes a new methodology to calculate the damping sensitivity with respect to change in active power flow, which can be useful for accurate selection of critical lines from the viewpoint of small-signal stability. In the proposed methodology, a damping sensitivity index is used to select the critical lines to damp power system oscillations. This paper describes how to derive the damping sensitivity for the selected mode and illustrates an example applying the proposed algorithm to a simple two-area system and the New England 39-bus test system.     

A fault analysis of DC electric arc furnaces with SVC harmonic filters in a mini-mill plant

This paper proposes the most feasible solution to overcome the failure of the 2nd harmonic filter in the static VAR compensator (SVC) which operates with the DC electric arc furnace (EAF) at Gwangyang Steel Mill in Korea. In order to investigate the causes of this failure, various measurements were carried out on the DC EAF and the main transformer at the PCC (point of common connection). It was concluded that the two causes for the failure are; the inrush current in the main transformer, and the parallel resonance between the system impedance and the harmonic filter. Three solutions to suppress the transformer inrush current and another three solutions to avoid the parallel resonance are suggested. The feasibility of these solutions was verified through the computer simulation with PSCAD/EMTDC. The most feasible solution to avoid further failures of the 2nd harmonic filter was selected, based on the estimated result for the six optional solutions in the point of performance and cost.     

Virtual fine delay line using one-stage inverter delay

A virtual fine delay line (VFDL) using only two ring oscillators and counters can cover a wide frequency operation range clock without adding any additional delay line stage. The proposed ring oscillator can easily make a unit delay as a one-stage inverter. The VFDL achieves fine resolution of less than 60 ps and small circuit area with two clock cycles lock-in time.     

互调干扰信号的特征识别

在复杂电磁信号环境中,实际存在为数不少的互调干扰信号,对这类信号的有效分析识别,是无线电监测工作需要重点关注解决的难题。对互调干扰信号在幅度特征和频谱峰值特征两个方面的特性进行了分析,给出了互调干扰信号识别的思路。     

High efficiency red phosphorescent organic light-emitting diodes using a spirobenzofluorene type phosphine oxide as a host material

High efficiency red phosphorescent organic light-emitting diodes have been developed using a spirobenzofluorene type phosphine oxide (SPPO2) as a host material. The SPPO2 had a high glass transition temperature of 119 °C and a smooth surface morphology with a surface roughness less than 1 nm. The red device with the SPPO2 as a host showed a quantum efficiency of 14.3% with a current efficiency of 20.4 cd/A.     

Angular MST‐Based Topology Control for Multi‐hop Wireless Ad Hoc Networks

This letter presents an angular minimum spanning tree (AMST) algorithm for topology control in multi‐hop wireless ad hoc networks. The AMST algorithm builds up an MST for every angular sector of a given degree around each node to determine optimal transmission power for connecting to its neighbors. We demonstrate that AMST preserves both local and network‐wide connectivity. It also improves robustness to link failure and mitigates transmission power waste.