Microwave hybrid fast sintering of red clay ceramics

This work aimed to examine the performance of the hybrid sintering of clay ceramic in a microwave furnace, compared to the sintering process in a conventional furnace. The raw materials were subjected to X-ray fluorescence, loss on ignition (LOI), X-ray diffraction, particle size distribution, real specific mass, and thermogravimetric analyses. The red clay ceramic mass was prepared, extruded, pre-sintered in a conventional furnace at 600°C/60 min, and sintered at temperatures between 700 °C and 1100 °C. The sintering conventional (resistive oven) was carried out for 60 min with a heating rate of 10°C/min. In the microwave furnace, the sintering times were 5, 10, and 15 min, with a heating rate of 50°C/min, with a sintering chamber coated with silicon carbide (susceptor). The sintered specimens were characterized according to linear shrinkage, water absorption, apparent porosity, apparent specific mass, X-ray diffraction, Raman spectroscopy analysis, spectroscopy analysis in the ultraviolet and visible regions, microhardness, and scanning electron microscopy. The results showed that microwave sintering promoted an increase in the microhardness and apparent specific mass, and reduction in water absorption and apparent porosity values, due to greater densification in the microstructure. The best results occurred for specimens sintered at 1100°C.     

Gender differences in computerised and conventional educational tests

Abstract Research has demonstrated girls to outperform boys on conventional literacy tests. The present studies concern gender differences on computerised educational tests. Seventy-one children were tested using LASS Secondary and a set of seven conventional measures. No significant gender differences were found on any of the LASS Secondary modules, although females did outperform males on a conventional spelling test. A further 126 pupils were tested on computerised and paper versions of the LASS Secondary reading, spelling and reasoning modules. No gender differences were found on the computerised versions, but there were significant differences on the paper versions of the reading and spelling modules favouring females. In a third study, 45 children were administered computerised and paper versions of the LASS Junior reading and spelling modules. There were no significant differences on the computerised modules, but girls performed significantly higher than boys on the paper version of the spelling module. It is possible that computerised assessment does not detect the established gender effect due to differences between males and females in motivation, computer experience and competitiveness. Further large-scale studies are necessary to confirm these findings.     

Recognizing, assessing, and intervening with problems of professional competence.

Working collaboratively, psychologist educators and trainers at the doctoral, internship, and postdoctoral levels; credentialers; practitioners; and students offer 8 proposals for psychologists to consider in recognizing, assessing, and intervening with problems of professional competence in students and practicing professionals. In the proposals, the authors address the following topics: definitions and categories; preparing the system; self-assessment; remediation; diversity; communication across various levels of the system; confidentiality; and ethical, regulatory, and legal underpinnings. They also propose future directions for the assessment of problems in professional competence in both students and practicing psychologists. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Transmission Electron Microscopy and Electron Energy-Loss Spectroscopy Characterization of Glass Phase in Sol-Gel-Derived Mullite

Sol-gel-derived mullite ceramics were processed by pressureless sintering at 1600°, 1650°, and 1700°C for 4 h. Microstructural and microchemical characterization of the mullite materials was performed using transmission electron microscopy, in conjunction with energy-dispersive X-ray spectroscopy and electron energy-loss spectroscopy (EELS). Apart from mullite grain diameter and triplepocket size, no major microstructural changes were observed with increasing sintering temperature. Residual glass was present at triple pockets and along two-grain junctions. Not all grain boundaries revealed the presence of a continuous amorphous intergranular film. Clean interfaces were observed only at boundaries with one grain parallel to the [001] orientation (low-energy configuration). Quantitative EELS analysis of mullite grains and glass pockets revealed only small changes in composition with increasing sintering temperature; i.e., the alumina:silica ratio slightly increased for mullite and glass. The analysis implied that mullite with this relatively high aluminum content would not be stable adjacent to residual glass. However, a stable glass-mullite system has been proposed, because impurity cations were detected within glass pockets, which suggested a slight shift of the subsolidus line (glass-mullite/ mullite) to a higher amount of alumina. Energy-loss nearedge structure studies of the Si- L _2,3 edge revealed a similar near-edge structure for the mullite, residual glass, and quartz. Thus, SiO₄ tetrahedra were thought to be the main building units of the glass contained in sintered mullite.     

Spatial and temporal scaling of nitrous oxide emissions from the field to the regional scale in Scotland

Nitrous oxide (N₂O) is a powerful greenhouse gas. As the UK government is committed to reducing greenhouse gas emissions, it is important to know not only how much of these gases are released but also where and when. Targeted measurements of emissions in relation to crop growth cycles, soil wetness and fertiliser applications were used to derive annual emission rates for specific combinations of soil type, land management and fertiliser practices. These annual emission rates were then spatially scaled to derive regional figures through the development of a Geographic Information System (GIS) based model framework. Digital soil and land use maps at a scale of 1:25000 for two test areas of approximately 200000 ha each (Lothians and the Ayrshire Basin) were overlain with a climate map within the GIS, deriving unique combinations of soil wetness and land use. The calculated annual emission rates (kg N ha^–1 yr^–1) were then applied to these and multiplied by the total area of each soil/land use type to derive annual emission losses for each area. The annual emission of nitrous oxide from the Lothians was determined as approximately 381000 kg N yr^–1, while the emissions from the Ayrshire Basin were predicted to be 794000 kg N yr^–1. This indicates the increased emissions associated with both the wetter soils of Ayrshire and the greater extent of grazed pasture systems in this area. Due to the detailed scale of the input data, localised areas with large emissions were identified. Abatement strategies would be concentrated on areas of high emissions that include a change to crops with lower emission potential, reducing fertiliser and manure inputs, reducing grazing intensity and improving soil drainage.Supplementary material to this paper is available in electronic form at http://dx.doi.org/10.1023/A:1024422604493     

Compatibility of polysaccharide/maleic copolymer blends. IV. Thermal behavior of hydroxypropyl cellulose‐containing blends

The compatibility of the hydroxypropyl cellulose (HPC) with maleic acid–vinyl acetate copolymer in the solid state was studied by thermogravimetry, thermo‐optical analysis, differential scanning calorimetry (DSC), Fourier transform infrared spectroscopy (FTIR), and optical microscopy. It was established that physical interactions are prevalent in blends with a high content of HPC, whereas chemical interactions predominate in blends with a medium and low content of HPC. By increasing the temperature, the thermochemical reactions are favored. Thermal properties are dependent on the mixing ratio of the components. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 88: 2585–2597, 2003