Differential Game for Distributed Power Control in Device-to-Device Communications Underlaying Cellular Networks

Wireless Personal Communications - In the formulating of power control for wireless networks, the radio channel is commonly formulated using static models of optimization or game theory. In these...     

Improvement in hydrolytic procedure for GLC determination of non-indolyl glucosinolates in rapeseed as isothiocyanates

Some methods determine the non-indolyl glucosinolates content in rapeseed as their hydrolysates: the isothiocyanates and the oxazolidinethiones. These methods in their present form underestimate the amount of the glucosinolates content. In this investigation, a modified method was developed to give a better quantitative estimate, indicating a glucosinolate level five times that obtained by a typical existing method.     

Thickness-dependence of stoichiometry and microstructure characteristics in correlation with conductivity type of CdTe films

CdTe films were prepared by physical vapour deposition on a substrate at room temperature (RT) as well as on a cold (LT) one using low deposition rate. The thickness-dependence of stoichiometry revealed an abrupt decrease in the Cd/Te ratio as the thickness increases. Change of thickness did not affect the type of observed (111) crystallographic texture, only the degree of preferred orientation is enhanced as the film grows. The internal strain was negligible while the crystallite size increased rapidly at small thickness (up to 400 nm), and less thickness dependence was observed with further film growth. However, thickness dependence of lattice parameters showed a minimum and a maximum at approximately 300 nm in the case of RT and LT, respectively. The observed change in conductivity from n- to p-type and its vital correlation with the stoichiometry and structural characteristics were presented. Based on thickness dependence of stoichiometry and lattice parameters as well as the conductivity type, formation and annihilation of lattice defects were considered.     

Modelling and controller design of an isolated diesel enginepermanent magnet synchronous generator

A method to analyze the steady-state performance of a stand-alone permanent magnet synchronous generator driven by a diesel engine is presented. The proposed method is based on equivalent d-q circuits and the phasor diagram of such a generator under steady-state conditions. A fixed capacitor-thyristor controlled reactor scheme is used to regulate the generator terminal voltage by controlling the thyristor ignition angle. Furthermore the overall system dynamics are modelled in terms of state variables and control inputs. Based on a reduced order linearized model, digital optimal state and output feedback controllers are designed by minimising a quadratic performance index using the dynamic programming technique. The objective of the controller is to maintain the load voltage and frequency constant under varying load conditions. The controller's effectiveness is assessed by examining the closed-loop system response to sudden load changes     

Characterization of Urine Stem Cell-Derived Extracellular Vesicles Reveals B Cell Stimulating Cargo

Elucidation of the biological functions of extracellular vesicles (EVs) and their potential roles in physiological and pathological processes is an expanding field of research. In this study, we characterized USC–derived EVs and studied their capacity to modulate the human immune response in vitro. We found that the USC–derived EVs are a heterogeneous population, ranging in size from that of micro–vesicles (150 nm–1 μm) down to that of exosomes (60–150 nm). Regarding their immunomodulatory functions, we found that upon isolation, the EVs (60–150 nm) induced B cell proliferation and IgM antibody secretion. Analysis of the EV contents unexpectedly revealed the presence of BAFF, APRIL, IL–6, and CD40L, all known to play a central role in B cell stimulation, differentiation, and humoral immunity. In regard to their effect on T cell functions, they resembled the function of mesenchymal stem cell (MSC)–derived EVs previously described, suppressing T cell response to activation. The finding that USC–derived EVs transport a potent bioactive cargo opens the door to a novel therapeutic avenue for boosting B cell responses in immunodeficiency or cancer.     

Antioxidant properties and composition of Majorana syriaca extracts

Majorana syriaca is an important food‐flavouring ingredient in the Middle Eastern culture known commonly as Za'atar. The components of the plant were extracted in a Soxhlet apparatus sequentially with solvents of increasing polarity, specifically with petroleum ether (P), diethyl ether (D), ethyl acetate (EAc), and ethanol (E). The activity of the extracts to scavenge the 2,2‐diphenyl‐1‐picrylhydrazyl radical (DPPH^?) followed the order D > E > EAc > P. Moreover, the antioxidant activity in corn oil at concentrations of 200, 500 and 1000 ppm was monitored through peroxide value and conjugated hydroperoxide measurements and revealed that D and E extracts resulted in the highest protection followed by EAc and P extracts. Increasing the concentration from 200 to 500 ppm depressed peroxide formation, while a further increase had no effect. The main components of the P extract according to GS‐MS analysis were thymol (42.89%) and carvacrol (42.75%). The remaining extracts comprise flavonoids and phenolic acids that provide the antiradical and antioxidant activity.     

Maximal limited similarity-based rough set model

Non-symmetric similarity relation-based rough set model (NS-RSM) is viewed as mathematical tool to deal with the analysis of imprecise and uncertain information in incomplete information systems with “?” values. NS-RSM relies on the concept of non-symmetric similarity relation to group equivalent objects and generate knowledge granules that are then used to approximate the target set. However, NS-RSM results in unpromising approximation space when addressing inconsistent data sets that have lots of boundary objects. This is because objects in the same similarity classes are not necessarily similar to each other and may belong to different target classes. To enhance NS-RSM capability, we introduce the maximal limited similarity-based rough set model (MLS-RSM) which describes the maximal collection of indistinguishable objects that are limited tolerance to each other in similarity classes. This allows accurate computation to be done for the approximation space. Furthermore, approximation accuracy comparisons have been conducted among NS-RSM and MLS-RSM. The results demonstrate that MLS-RSM model outperforms NS-RSM and can approximate the target set more efficiently.     

An Efficient Medical Image Deep Fusion Model Based on Convolutional Neural Networks

Medical image fusion is considered the best method for obtaining one image with rich details for efficient medical diagnosis and therapy. Deep learning provides a high performance for several medical image analysis applications. This paper proposes a deep learning model for the medical image fusion process. This model depends on Convolutional Neural Network (CNN). The basic idea of the proposed model is to extract features from both CT and MR images. Then, an additional process is executed on the extracted features. After that, the fused feature map is reconstructed to obtain the resulting fused image. Finally, the quality of the resulting fused image is enhanced by various enhancement techniques such as Histogram Matching (HM), Histogram Equalization (HE), fuzzy technique, fuzzy type Π, and Contrast Limited Histogram Equalization (CLAHE). The performance of the proposed fusion-based CNN model is measured by various metrics of the fusion and enhancement quality. Different realistic datasets of different modalities and diseases are tested and implemented. Also, real datasets are tested in the simulation analysis.     

Effect of electron irradiation on alternating current electrical properties of gelatin – cadmium sulfide nano-composite films

Gelatin was doped with 1 %, 3 %, 5 % and 10 % cadmium sulfide nanoparticles in weight concentrations forming the gelatin-cadmium sulfide nanocomposites and irradiated by various electron beam doses equals 50 kGy, 75 kGy, 100 kGy, and 150 kGy using 3 MeV – 3 mA electron accelerator. The applied alternating current electrical field frequency ranging from 70 Hz to 5 MHz is what caused the fluctuation in dielectric properties and alternating current electrical conductivity of these nanocomposites. The results showed that the films of 1 %, 3 %, 5 %, and 10 % for blank (nanocomposite film without electron beam irradiation) nanocomposites had the highest dielectric parameters (έ, ϵ′′, tan δ) at 0.5 kHz with values of (0.696, 0.0233, 0.034), (0.533, 0.0114, 0.0215), (0.402, 0.001196, 0.003), and (0.459, 0.00418, 0.0091), respectively. However, the lowest dielectric parameters were (0.645, 0.00618, 0.0066), (0.523, 0.00165, 0.0215), (0.417, 0.00035, 0.0008), and (0.455, 0.00066, 0.0015) at 5 MHz, respectively. The highest conductivity values for blank nanocomposites of 1 %, 3 %, 5 %, and 10 % were 1.79×10⁻⁴ S/m, 1.45×10⁻⁴ S/m, 1.16×10⁻⁴ S/m, 1.27×10⁻⁴ S/m at 5 MHz, and the lowest values were 1.92×10⁻⁸ S/m, 1.49×10⁻⁸ S/m, 1.13×10⁻⁸ S/m, 1.26×10⁻⁸ S/m at 0.5 kHz, respectively. For irradiated nanocomposites at 5 MHz, the dielectric constant order for 1 % was 100 kGy, 150 kGy, 50 kGy, and 75 kGy with values 0.63, 0.537, 0.532, and 0.523, respectively. For 10 % weight concentration, the order was 50 kGy, 100 kGy, 150 kGy, and 75 kGy with values 0.515, 0.477, 0.47, and 0.437, respectively. Otherwise the dielectric constant order for 3 % and 5 % was 100 kGy, 75 kGy, 150 kGy, and 50 kGy. The highest dielectric properties and conductivity values for blank and irradiated nanocomposites were observed at 100 kGy for 1 %, 3 %, and 5 %.