Properties of poly(ethylene terephthalate)–poly(ethylene naphthalene 2,6‐dicarboxylate) blends with montmorillonite clay

The production and properties of blends of poly(ethylene terephthalate) (PET) and poly(ethylene naphthalene 2,6‐dicarboxylate) (PEN) with three modified clays are reported. Octadecylammonium chloride and maleic anhydride (MAH) are used to modify the surface of the montmorillonite–Na⁺ clay particles (clay–Na⁺) to produce clay–C18 and clay–MAH, respectively, before they are mixed with the PET/PEN system. The transesterification degree, hydrophobicity and the effect of the clays on the mechanical, rheological and thermal properties are analysed. The PET–PEN/clay–C18 system does not show any improvements in the mechanical properties, which is attributed to poor exfoliation. On the other hand, in the PET–PEN/clay–MAH blends, the modified clay restricts crystallization of the matrix, as evidenced in the low value of the crystallization enthalpy. The process‐induced PET–PEN transesterification reaction is affected by the clay particles. Clay–C18 induces the largest proportion of naphthalate–ethylene–terephthalate (NET) blocks, as opposed to clay–Na⁺ which renders the lowest proportion. The clay readily incorporates in the bulk polymer, but receding contact‐angle measurements reveal a small influence of the particles on the surface properties of the sample. The clay–Na⁺ blend shows a predominant solid‐like behaviour, as evidenced by the magnitude of the storage modulus in the low‐frequency range, which reflects a high entanglement density and a substantial degree of polymer–particle interactions. Copyright © 2005 Society of Chemical Industry     

Enoxaparin in the prevention of deep venous thrombosis after major surgery: multicentric study. The Italian Study Group

Four hundred forty-six patients with Tourette Syndrome (TS) and/or their parents completed a 52-item self-report survey about vocal and motor tics, and the frequency of associated co-morbid conditions of aggression, obsessions and compulsions, attentional problems, sleep disturbance, mood disturbance, anxiety, and self-mutilative behaviours which have been frequently reported in the literature on TS. Respondents also responded to an open-ended question regarding the most disabling aspects of TS. Results were analyzed within two age groups; under 18 years of age (N = 245) and 18 years of age or older (N = 177). Tics and associated conditions were the most frequently reported disabling aspect by both age groups. Subjects under age 18, however, reported significantly more frequent problems with hyperactivity, temper control, aggressive behaviours and sleepwalking than adults with TS.     

Evaluating the patient satisfaction questionnaire after inpatient treatment in phoniatrics and pediatric audiology--a contribution to quality control?]

Baker and confectioner apprentices have been included in a prospective follow-up study in the region of East Thuringia, to evaluate risk factors for the development of hand dermatitis. Starting in August 1996, the apprentices have been interviewed and examined in a standardized way right at the beginning (n=91) of their vocational training, 6 (n=79) and 12 months (n=63) later. To gain objective data, TEWL score was also assessed at 3 standardized sites on the hands. In their case histories, 3.3% (n=3) of the apprentices reported hand dermatitis. The 1st assessment after 2 to 4 weeks vocational training revealed hand eczema in 17.5% (n=16) of the individuals. At the follow-up after 6 months of training 29.1% (n=23), and after 12 month of training 27.0% (n=17), of the apprentices had hand dermatitis of mild to moderate severity. Within 6 months, the TEWL score rose significantly (p<0.001) from 11.9 g m(-2) h(-1) (-/+5.4) to 16.8 g m(-2) h(-1) (-/+9.5). After 12 months, the TEWL score was 14.9 g m(-2) h(-1) (-/+4.6). For the atopic skin diathesis (>10 points of Diepgen's atopy score), there was a significant tendency to be a predictive factor for the development of occupational hand dermatitis. TEWL score failed to correlate with the development of skin damage in our study. The same was true for respiratory atopy and metal sensitization.     

A new variety of low-linolenic rapeseed oil; Characteristics and room-odor tests

Two Canadian rapeseed oils, “Westar” and “low-linolenic”, supplied by the Canola Council were studied and compared with a French rapeseed. The linolenic acid content of the low-linolenic variety is about 3%. This drop in the C18∶3 is completely compensated for by an increase in the C18∶2. Seventy-two percent of the triglycerides with at least one linolenic chain disappeared. A strong increase in the OOL and OLL was observed. The room-odor tests showed that the “low-linolenic” had a significantly higher odor score than the French rapeseed and the “Westar”, both of these being very similar. A fruity odor dominated in the “low-linolenic”, and the fishy painty odors were particularly reduced.     

CALIBRATION OF THE METHOD TO MEASURE BUBBLE PROPERTIES IN 2D FLUIDIZED BEDS

The purpose of the present work is to demonstrate the reliability of a digital image processing technique. A CCD (Charge Coupled Device) is used to perform an investigation on the bubble properties of a 2D gas-solid fluidized bed, and the aim of this study is to establish a criterion in order to reject all images that could not be interpreted as bubbles. This may lead to an alteration of the information obtained. The two-dimensional fluidized bed is 20 cm wide and at least 20 cm high, and the field of view of the camera is 12.54 cm wide and 12.99 cm high. In this way, bubbles could be totally or partially placed into this field of view so that a partial image of a bubble could be analyzed as a whole bubble. With this calibration, a geometric decision criterion for the rejection of nonbubble images was developed.     

Nonionic water‐soluble polymer: Preparation,characterization, and application of poly(1‐vinyl‐2‐pyrrolidone‐co‐hydroxyethylmethacrylate) as a polychelatogen

The free‐radical copolymerization of water‐soluble poly(1‐vinyl‐2‐pyrrolidone‐co‐hydroxyethylmethacrylate) was carried out with a feed monomer ratio of 75:25 mol %, and the total monomer concentration was 2.67M. The synthesis of the copolymer was carried out in dioxane at 70°C with benzoyl peroxide as the initiator. The copolymer composition was obtained with elemental analysis and ¹H‐NMR spectroscopy. The water‐soluble polymer was characterized with elemental analysis, Fourier transform infrared, ¹H‐ and ¹³C‐NMR spectroscopy, and thermal analysis. Additionally, viscosimetric measurements of the copolymer were performed. The thermal behavior of the copolymer and its complexes were investigated with differential scanning calorimetry (DSC) and thermogravimetry techniques under a nitrogen atmosphere. The copolymer showed high thermal stability and a glass transition in the DSC curves. The separation of various metal ions by the water‐soluble poly(1‐vinyl‐2‐pyrrolidone‐co‐hydroxyethylmethacrylate) reagent in the aqueous phase with liquid‐phase polymer‐based retention was investigated. The method was based on the retention of inorganic ions by this polymer in a membrane filtration cell and subsequent separation of low‐molar‐mass species from the polymer/metal‐ion complex formed. Poly(1‐vinyl‐2‐pyrrolidone‐co‐hydroxyethylmethacrylate) could bind metal ions such as Cr(III), Co(II), Zn(II), Ni(II), Cu(II), Cd(II), and Fe(III) in aqueous solutions at pHs 3, 5, and 7. The retention percentage for all the metal ions in the polymer was increased at pH 7, at which the maximum retention capacity could be observed. The interaction of inorganic ions with the hydrophilic polymer was determined as a function of the pH and filtration factor. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 100: 178–185, 2006     

Online recognition of sketched arrow-connected diagrams

We introduce a new, online, stroke-based recognition system for hand-drawn diagrams which belong to a group of documents with an explicit structure obvious to humans but only loosely defined from the machine point of view. We propose a model for recognition by selection of symbol candidates, based on evaluation of relations between candidates using a set of predicates. It is suitable for simpler structures where the relations are explicitly given by symbols, arrows in the case of diagrams. Knowledge of a specific diagram domain is used—the two domains are flowcharts and finite automata. Although the individual pipeline steps are tailored for these, the system can readily be adapted for other domains. Our entire diagram recognition pipeline is outlined. Its core parts are text/non-text separation, symbol segmentation, their classification and structural analysis. Individual parts have been published by the authors previously and so are described briefly and referenced. Thorough evaluation on benchmark databases shows the accuracy of the system reaches the state of the art and is ready for practical use. The paper brings several contributions: (a) the entire system and its state-of-the-art performance; (b) the methodology exploring document structure when it is loosely defined; (c) the thorough experimental evaluation; (d) the new annotated database for online sketched flowcharts and finite automata diagrams.